Land Surface Temperature (LST) affects exchange of energy between earth surface and atmosphere which is important for studying environmental changes. However, research on the relationship between LST, Land Use Land Cover (LULC), and Normalized Difference Vegetation Index (NDVI) with topographic elements in the lower Himalayan region has not been done. Therefore, the present study explored the relationship between LST and NDVI, and LULC types with topographic elements in the lower Himalayan region of Pakistan. The study area was divided into North-South, West-East, North-West to South-East and North-East to South-East directions using ArcMap 3D analysis. The current study used Landsat 8 (OLI/TIRS) data from May 2021 for LULC and LST analysis in the study area. The LST data was obtained from the thermal band of Landsat 8 (TIRS), while the LULC of the study areas was classified using the Maximum Likelihood Classification (MLC) method utilizing Landsat 8 (OLI) data. TIRS collects data for two narrow spectral bands (B10 and B11) with spectral wavelength of 10.6 μm-12.51 μm in the thermal region formerly covered by one wide spectral band (B6) on Landsat 4-7. With 12-bit data products, TIRS data is available in radiometric, geometric, and terrain-corrected file format. The effect of elevation on LST was assessed using LST and elevation data obtained from the USGS website. The LST across LULC types with sunny and shady slopes was analyzed to assess the influence of slope directions. The relationship of LST with elevation and NDVI was examined using correlation analysis. The results indicated that LST decreased from North-South and South-East, while increasing from North-East and South-West directions. The correlation coefficient between LST and elevation was negative, with an R-value of -0.51. The NDVI findings with elevation showed that NDVI increases with an increase in elevation. Zonal analysis of LST for different LULC types showed that built-up and bare soil had the highest mean LST, which was 35.76 °C and 28.08 °C, respectively, followed by agriculture, vegetation, and water bodies. The mean LST difference between sunny and shady slopes was 1.02 °C. The correlation between NDVI and LST was negative for all LULC types except the water body. This study findings can be used to ensure sustainable urban development and minimize urban heat island effects by providing effective guidelines for urban planners, policymakers, and respective authorities in the Lower Himalayan region. The current thermal remote sensing findings can be used to model energy fluxes and surface processes in the study area.

This research work reports the magnetic adsorption of fluoride from drinking water through silica-coated Fe₃O₄ nanoparticles. Chemical precipitation and wet impregnation methods were employed to synthesize the magnetic nanomaterials. Moreover, the synthesized nanomaterials were characterized for physicochemical properties through scanning electron microscopy, Fourier-transform infrared spectroscopy, and X-ray powder diffraction. Screening studies were conducted to select the best iron oxide loading (0.0–1.5 wt%) and calcination temperature (300–500 °C). The best selected nanomaterial (0.5Fe-Si-500) showed a homogenous FeO distribution with a 23.79 nm crystallite size. Moreover, the optimized reaction parameters were: 10 min of contact time, 0.03 g L⁻¹ adsorbent dose, and 10 mg L⁻¹ fluoride (F⁻) concentration. Adsorption data were fitted to the Langmuir and Freundlich isotherm models. The Q_m and K_F (the maximum adsorption capacities) values were 5.5991 mg g⁻¹ and 1.869 L g⁻¹ respectively. Furthermore, accelerated adsorption with shorter contact times and high adsorption capacity at working pH was among the outcomes of this research work.

Bio-degradable and eco-friendly essential oils (EOs) extracted from Mentha longifolia, Salsola imbricata, Erigeron bonariensis, E. canadensis, Ailanthus altissima, and Zanthoxylum armatum were investigated for their repellent and larvicidal potential against Aedes aegypti mosquitoes. The EOs of M. longifolia, S. imbricata, E. bonariensis, E. canadensis, A. altissima, and Z. armatum exhibited 99.0%, 96.8%, 40.2%, 41.7%, 29.1%, and 13.2% repellency against mosquitoes at a tested dose of 33.3 μg/cm², respectively. In time span bioassays, the EOs of M. longifolia, S. imbricata, E. bonariensis, and E. canadensis showed more than 40% repellency for 60 min at a tested dose of 330 μg/cm². Larvicidal bioassays revealed that larvae of Ae. aegypti were the most susceptible to M. longifolia (LC₅₀, 39.3 mg/L), E. bonariensis (LC₅₀, 26.0 mg/L), E. canadensis (LC₅₀, 35.7 mg/L), and Z. armatum (LC₅₀, 35.9 mg/L) EOs upon 48 h exposure. The most abundant constituents in the EOs of M. longifolia, S. imbricata, E. bonariensis, E. canadensis and A. altissima were piperitone oxide (45.5%), carvone (39.9%), matricaria ester (43.1%), (31.7%) and eugenol (24.4%), respectively. Our study demonstrates that EOs of M. longifolia, S. imbricata, E. bonariensis, and E. canadensis might be used to control Ae. aegypti mosquitoes without harming humans or the environment.

In the present study, the antibacterial activity of Cornus macrophylla was examined. Organic solvent extracts of leaves were prepared using methanol, n-hexane, chloroform, and ethyl acetate. Antibacterial activity was examined by using a 100 mg/mL extract concentration. Penicillin was kept as a positive control while dimethyl sulfoxide was taken as a negative control. Methanolic extract exhibited a 21.5, 36.3, 25.3, and 23.7 mm inhibition zone diameter (IZD); n-hexane showed a 33, 40, 32.8, and 28.7 mm IZD; chloroform showed a 18.8, 29, 22.3, and 21.6 mm IZD; and ethyl acetate showed a 23.5, 30.2, 30, and 22.3 mm IZD against Erwinia carotovora, Pseudomonas syringae, Ralstonia solanacearum, and Xanthomonas axonopodis, respectively. The n-hexane extract revealed high antibacterial activity against all bacterial species as compared with methanolic, chloroform, and ethyl acetate extract. Gas Chromatography Mass Spectrometry (GC/MS) analysis of n-hexane extract depicted the presence of 55 compounds. Out of these compounds, one compound, identified as α-amyrin (Mol. wt = 426), exhibited the maximum peak area (32.64%), followed by A’-Neogammacer-22(29)-en-3-ol, acetate, (3.beta.,21.beta.)- (Mol. wt = 468) and β-amyrin (Mol. wt = 426) having peak areas of 25.97 and 6.77%, respectively. It was concluded that the antibacterial activity observed during the present investigation may be due to these compounds.