Recently, polymer-coated nanoparticles were proposed for enhanced oil recovery (EOR) due to their improved properties such as solubility, stability, stabilization of emulsions and low particle retention on the rock surface. This work investigated the potential of various polymer-coated silica nanoparticles (PSiNPs) as additives to the injection seawater for oil recovery. Secondary and tertiary core flooding experiments were carried out with neutral-wet Berea sandstone at ambient conditions. Oil recovery parameters of nanoparticles such as interfacial tension (IFT) reduction, wettability alteration and log-jamming effect were investigated. Crude oil from the North Sea field was used. The concentrated solutions of PSiNPs were diluted to 0.1 wt % in synthetic seawater. Experimental results show that PSiNPs can improve water flood oil recovery efficiency. Secondary recoveries of nanofluid ranged from 60% to 72% of original oil in place (OOIP) compared to 56% OOIP achieved by reference water flood. In tertiary recovery mode, the incremental oil recovery varied from 2.6% to 5.2% OOIP. The IFT between oil and water was reduced in the presence of PSiNPs from 10.6 to 2.5–6.8 mN/m, which had minor effect on EOR. Permeability measurements indicated negligible particle retention within the core, consistent with the low differential pressure observed throughout nanofluid flooding. Amott–Harvey tests indicated wettability alteration from neutral- to water-wet condition. The overall findings suggest that PSiNPs have more potential as secondary EOR agents than tertiary agents, and the main recovery mechanism was found to be wettability alteration.
Laboratory experiments have shown higher oil recovery with nanoparticle (NPs) flooding. Accordingly, many studies have investigated the nanoparticle-aided sweep efficiency of the injection fluid. The change in wettability and the reduction of the interfacial tension (IFT) are the two most proposed enhanced oil recovery (EOR) mechanisms of nanoparticles. Nevertheless, gaps still exist in terms of understanding the interactions induced by NPs that pave way for the mobilization of oil. This work investigated four types of polymer-coated silica NPs for oil recovery under harsh reservoir conditions of high temperature (60 C) and salinity (38,380 ppm). Flooding experiments were conducted on neutral-wet core plugs in tertiary recovery mode. Nanoparticles were diluted to 0.1 wt.% concentration with seawater. The nano-aided sweep efficiency was studied via IFT and imbibition tests, and by examining the displacement pressure behavior. Flooding tests indicated incremental oil recovery between 1.51 and 6.13% of the original oil in place (OOIP). The oil sweep efficiency was affected by the reduction in core’s permeability induced by the aggregation/agglomeration of NPs in the pores. Different types of mechanisms, such as reduction in IFT, generation of in-situ emulsion, microscopic flow diversion and alteration of wettability, together, can explain the nano-EOR effect. However, it was found that the change in the rock wettability to more water-wet condition seemed to govern the sweeping efficiency. These experimental results are valuable addition to the data bank on the application of novel NPs injection in porous media and aid to understand the EOR mechanisms associated with the application of polymer-coated silica nanoparticles.
Nanoparticles (NPs) have been proposed for enhanced oil recovery (EOR). The research has demonstrated marvelous effort to realize the mechanisms of nanoparticles EOR. Nevertheless, gaps still exist in terms of understanding the nanoparticles-driven interactions occurring at fluids and fluid–rock interfaces. Surface-active polymers or other surface additive materials (e.g., surfactants) have shown to be effective in aiding the dispersion stability of NPs, stabilizing emulsions, and reducing the trapping or retention of NPs in porous media. These pre-requisites, together with the interfacial chemistry between the NPs and the reservoir and its constituents, can result in an improved sweep efficiency. This paper investigates four types of polymer-coated silica NPs for the recovery of oil from water-wet Berea sandstones. A series of flooding experiments was carried out with NPs dispersed at 0.1 wt.% in seawater in secondary and tertiary oil recovery modes at ambient conditions. The dynamic interactions of fluids, fluid–rock, and the transport behavior of injected fluid in the presence of NPs were, respectively, studied by interfacial tension (IFT), spontaneous imbibition tests, and a differential pressure analysis. Core flooding results showed an increase in oil recovery up to 14.8% with secondary nanofluid injection compared to 39.7% of the original oil in place (OOIP) from the conventional waterflood. In tertiary mode, nanofluids increased oil recovery up to 9.2% of the OOIP. It was found that no single mechanism could account for the EOR effect with the application of nanoparticles. Instead, the mobilization of oil seemed to occur through a combination of reduced oil/water IFT, change in the rock surface roughness and wettability, and microscopic flow diversion due to clogging of the pores.
Extraction of oil trapped after primary and secondary oil production stages still poses many challenges in the oil industry. Therefore, innovative enhanced oil recovery (EOR) technologies are required to run the production more economically. Recent advances suggest renewed application of surface-functionalized nanoparticles (NPs) for oil recovery due to improved stability and solubility, stabilization of emulsions, and low retention on porous media. The improved surface properties make the NPs more appropriate to improve microscopic sweep efficiency of water flood compared to bare nanoparticles, especially in challenging reservoirs. However, the EOR mechanisms of NPs are not well understood. This work evaluates the effect of four types of polymer-functionalized silica NPs as additives to the injection water for EOR. The NPs were examined as tertiary recovery agents in water-wet Berea sandstone rocks at 60 °C. The NPs were diluted to 0.1 wt. % in seawater before injection. Crude oil was obtained from North Sea field. The transport of NPs though porous media, as well as nanoparticles interactions with the rock system, were investigated to reveal possible EOR mechanisms. The experimental results showed that functionalized-silica NPs can effectively increase oil recovery in water-flooded reservoirs. The incremental oil recovery was up to 14% of original oil in place (OOIP). Displacement studies suggested that oil recovery was affected by both interfacial tension reduction and wettability modification, however, the microscopic flow diversion due to pore plugging (log-jamming) and the formation of nanoparticle-stabilized emulsions were likely the relevant explanations for the mobilization of residual oil.
Lack of relevant screening methods of oil recovery techniques for water flood with added nanoparticles in a given reservoir are hindering its implementation for enhanced oil recovery (EOR) purposes. Moreover, the understanding of the underlying mechanisms of oil increased by nanoparticles must be improved. In this work, we screened twenty-three different types of silica nanoparticles as additives to injection water for oil recovery applications. The nanoparticles were surface functionalised to remain stable in the injection water and be active at the surface. The hypothesis is that the particles will improve the microscopic oil recovery efficiency of water flood in an oil reservoir. The concentrated solution of nanoparticles were prepared to 0.1 wt % concentration in synthetic North Sea water. Crude oil was obtained from a field in the North Sea. The following investigations were carried out to quickly verify the performance of nanoparticle oil recovery: 1) secondary injection through a visual glass micromodel. 2) For the prominent silica nanoparticles, we evaluated oil recovery by conducting secondary core flooding experiments in water-wet Berea sandstone rocks; and 3) the displacement mechanisms of nanoparticles were investigated by interfacial tension measurements between nanofluids and crude oil; Amott-wettability test; and by analyzing differential pressure across the core. Experimental results from secondary floods showed that modified silica nanoparticles can boost oil recovery. The core flood recoveries ranged from 45.7% to 54.5% of original oil in place (OOIP) compared to 39.7% of reference water flood. Displacement studies revealed that, oil recovery was obtained from a contribution of interfacial tension reduction, wettability alteration, and log jamming effect due to pore blockage. This work suggests a procedure for screening nanoparticles for EOR applications while providing insights into the role of the modified-silica nanoparticles for recovery of oil.
Polymer-coated silica nanoparticles (PSiNP) have been proposed for enhanced oil recovery (EOR) owing to their improved properties such as stability, emulsion formation, low retention, etc. over bare nanoparticles. Even though most studies report EOR potential of nanoparticles compared to plain water flood, the underlying oil recovery mechanisms of nanoparticles are not well understood. This experimental work investigates the efficiency of PSiNP for oil recovery on micro-scale via comparing waterflooding to nanofluid flooding with minimizing the variations in pore architecture and initial oil connectivity on the trapping efficiency. This research unleashes the potential application of four types of PSiNPs for EOR in water-wet Berea sandstone reservoirs and microfluidic chips. The PSiNPs were mixed with synthetic seawater at 0.1 wt % concentration. The oil recoveries were compared with waterflooding obtained on the same core. For this purpose, the following experiments were performed: First, four waterfloods were carried out until there was no oil production on four cores. Then, the cores were cleaned and dried. Afterwards, each core was injected with nanofluid in secondary recovery mode. To compare the four types of PSiNPs, microfluidic experiments were performed under the same experimental conditions such as pore-structure and initial oil connectivity. Measurements of interfacial tension and contact angle, and analysis of differential pressure across the cores and pore-scale images were performed to reveal possible recovery mechanisms of PSiNPs. The nanofluids had higher ultimate oil recoveries than plain waterflood. The PSiNPs with small particle sizes had the highest reduction in IFT and the best capability to disconnect and minimize the size of the residual oil clusters within the pore spaces. Our hypothesis is that the adsorption of PSiNPs on the grain surfaces played a considerable role in the oil displacement efficiency. On the other hand, the ability of PSiNPs to cause pore-blockage and log-jamming attributed to the large NP size and adsorption on surfaces was strongly related to the displacement efficiency. Performing screening experiments of different nanofluids on cores with similar petrophysical properties could produce misleading results. Microfluidic experiments have advantages over the core-flooding experiments. Since the microchip has different properties compared to natural rocks; the results did not correlate with core-scale experiments. However, it was a significant tool, in this work, to indicate the generation of emulsions and the rate of clusterization, which cannot be seen from conventional core-scale experiments. The knowledge gained from this experimental work helps to improve the screening methodology for the use of recovery agents such as nanoparticles for EOR applications.