Although primarily deemed to be an ornamental stone, granite may also be ground into fines for use in cement mortars, where it exhibits high strength and durability. Both the 40K present in the stone and the natural decay series of its uranium, thorium and actinium components exhibit high activity concentrations. An understanding is therefore needed of the correlation among the different particle sizes in granite aggregate to assess their con-tribution to a mortar's activity concentration index (ACI). This study analyses the variation in ACI with particle size in three types of granite based on the chemical, mineralogical and radiological characterisation of five size fractions. The activity concentrations of the tho-rium and uranium natural decay series were highest in the finest fractions. A correlation was observed between thorium and the MgO and Fe2O3 normally present in mica group phyllosilicates. In two of the three granites, the mortars prepared with the smallest size particles had ACI values >1. (c) 2021 SECV. Published by Elsevier Espa n similar to a, S.L.U. This is an open access article under the CC BY-NC-ND license (http://creativecommons.org/licenses/by-nc-nd/4.0/).

That the preservation of twentieth concrete heritage is an area scantly explored can be attributed to a lack of appreciation for such a young material. In most cases conservation is broached from a technical perspective with little regard for heritage value. Ongoing assessment of the condition of structures is the primary strategy to minimise such misguided action. This study involved characterising the condition of the concrete in a number of singular elements forming part of the Eduardo Torroja Institute for Construction Science headquarters at Madrid, Spain, a modernist compound listed by the city of Madrid as a protected asset. The in situ findings using non-destructive and laboratory techniques revealed the core concrete to be in good condition. The surface material, however, exhibits signs of durability issues calling for conservation treatments and techniques compatible with the preservation of the integrity and authenticity of this young heritage material.

The study reported the effect of granite sand on strength and microstructural developments in mortars prepare from OPC with a high coal fly ash (FA) content or from hybrid alkaline cements. The radiological behaviour of the resulting mortars was compared to materials prepared with siliceous sand (with particles sizes of 0.96, which would ultimately limit their use. A conclusion of interest is that where information is at hand on the starting materials (OPC, FA, sand, admixtures), their proportions in the mortar and the mixing liquid content (water or alkaline activators) their radiological content is accurately predicted. The inference is that a mortar’s radiological content and ACI can be known prior to mixing, providing a criterion for determining its viability. That in turn lowers environmental risks and the health hazards for people in contact with such materials.

The radiological characterization of aggregates used in construction materials is essential to determine their suitability from a radiological protection perspective and to ensure their safety for health and the environment. While the activity concentrations of radionuclides present in construction materials are typically determined using gamma spectrometry, an alternative approach involves the development of statistical methods and predictive models derived from the chemical composition of the material. A total of 39 aggregates used in construction of various types (siliceous, carbonatic, volcanic, and granitic) have been analyzed, correlating their chemical compositions obtained through X-ray fluorescence (XRF) with the activity concentrations of natural radionuclides measured via gamma spectrometry using principal component analysis (PCA). The results obtained allowed for the observation of an inversely proportional relationship between the chemical composition of the grouping of siliceous and carbonatic aggregates and the content of radionuclides. However, the set of granitic aggregates showed a strong correlation with the natural radioactive series of uranium, thorium, and ⁴⁰K. Conversely, the radionuclide content of volcanic aggregates was independent of their chemical composition. The results obtained from the PCA facilitated the development of different models using multiple regression analysis. The chemical parameters obtained in the proposed models were related to the typical mineralogy in each grouping, ranging from primary minerals such as feldspars to accessory minerals such as anatase, apatite, and pyrolusite. Finally, the models were validated using independent samples from those used to determine the models, achieving RSD (%) values ≤ 30% in 50% of the activity concentrations of ²²⁶Ra, ²³²Th(²¹²Pb), and ⁴⁰K, as well as the estimated ACI.