Low-temperature plasma nitriding is a thermochemical surface treatment that promotes surface hardening and wear resistance enhancement without compromising the corrosion resistance of sintered austenitic stainless steels. Hollow cathode radiofrequency (RF) plasma nitriding was conducted to evaluate the influence of the working pressure and nitriding time on the microstructure and thickness of the nitrided layers. A group of samples of sintered 316L austenitic stainless steel were plasma-nitrided at 400 °C for 4 h, varying the working pressure from 160 to 25 Pa, and the other group was treated at the same temperature, varying the nitriding time (2 h and 4 h) while keeping the pressure at 25 Pa. A higher pressure resulted in a thinner, non-homogeneous nitrided layer with an edge effect. Regardless of the nitriding duration, the lowest pressure (25 Pa) promoted the formation of a homogenously nitrided layer composed of nitrogen-expanded austenite that was free of iron or chromium nitride and harder and more scratching-wear-resistant than the soft steel substrate.
Hexagonal boron-nitride nanoparticle coating was deposited on AISI 1045 steel surface. The deposition process included a transformation of B-containing thin organic film into nanocrystalline BN using two methods: thermal annealing at 450–850 °C and reactive ion etching in Ar/N2 plasma. The film structure, phases, and film morphology of deposited nanoparticles of boron nitride on AISI 1045 steel were characterized by XPS, XRD, and EDS. Post-annealing at 450 °C does not lead to the formation of a BN phase in the layer. A non-stoichiometric BN phase with nitrogen deficiency appears at 650 °C. At 850 °C annealing, the formed BN phase is completely stoichiometric. The effects of deposited and incorporated BN on the friction and hardness properties of AISI 1045 steel were also studied. The post-annealing process improved the hardness from 5.35 to 11.4 GPa, showing a pronounced linear temperature dependence. An original approach was adopted to quantify the energy-dependent growth constants based on the indentation load-discharge curves measured on samples treated under different conditions. Those constants describe the rate of the reactions and the type of interdiffusion process characteristic for each material used. This approach can partially fulfill the role of the Rutherford backscattering spectrometry profile, which is an expensive and time-consuming process, mainly when light elements such as boron and nitrogen are used.
6 August 2025 in Surface Topography: Metrology and Properties
Studies on aluminum-matrix composites are frequent and there are several alternatives for the dispersed phase, including the presence of quasicrystals (QCs) obtained through manufacturing processes that involve melting. Among other effects, QCs can improve wear resistance with respect to other aluminum alloys. The present research considers an additive manufacturing Al‒Fe‒Cr alloy fabricated via Laser-based Powder Bed Fusion of metals (PBF-LB/M). The processing resulted in a composite structure with coarse and fine grain regions along the microstructure, both with dispersed QC particles. The composite was characterized by optical microscopy, scanning electron microscopy, nanoindentation, and scratch tests. In the last case, initial tests with loads increasing from 0 to 100 mN were conducted to understand the transitions between the abrasion mechanisms in both regions. A second set of scratch tests was performed considering constant loads of 20 mN and 80 mN, to better characterize the abrasive micromechanisms. 3D interferometry analyses were performed to identify possible correlations between the mechanical and tribological behavior of each region and the characteristics of the surfaces that resulted from mechanical loading, including metallographic polishing. Results indicate differences in the mechanical and tribological behavior of both regions, but only when low normal loads (e.g., nanoindentation tests with normal loads below 5 mN) were used.