Dyes are among the toxic contaminants that significantly impact water ecosystems. A biomaterial prepared from Zizyphus Spina-Christi seed (ZSCS) to remove methylene blue (MB) and methyl violet (MV) from an aqueous solution was investigated. Several techniques have been used, including FTIR, SEM, EDX, XPS, and TGA, to characterize the physical and chemical properties of ZSCS. The effect of various parameters such as pH, adsorbent dosage, contact time, temperature, and initial dye concentration on the adsorption process were studied. The ZSCS adsorbent showed efficient MB and MV dye adsorption with Langmuir adsorption capacity of 666.66 and 476.19 mg/g, respectively, at experimental condition [(pH = 6; time = 30 min; T = 45 °C, dye concentration: 500 mg/L, and adsorbent dose = 0.6 g/L for MB and 1 g/L for MV dye)]. Kinetic and isotherm models were applied to fit the experimental outcomes. The result showed that ZSCS showed an ultrafast absorption process with a high removal efficiency of MB and MV within 5 min indicating its effective adsorption properties. The Langmuir isotherm model was the most suitable model for describing the adsorption of MB and MV dyes on ZSCS. The pseudo-second-order model kinetic fits better to MB and MV adsorption onto ZSCS than other models, suggesting that the adsorption mechanism followed chemisorption. Our results could offer an efficient cost-effective approach for dye removal from wastewater.
The increasing threat of dye pollution in water resources underscores the urgent need for sustainable and cost-effective treatment solutions However, a gap remains in identifying efficient and reusable natural materials for dye removal. This study evaluates the potential of natural zeolite as an effective and reusable adsorbent for removing methylene blue dye from aqueous solutions. Natural zeolite was characterized using SEM, FTIR, XRD, and TGA techniques, and its adsorption performance was systematically tested under various conditions, including pH, adsorbent dosage, contact time, temperature, and initial dye concentration. The results revealed a maximum dye removal efficiency of 98.9% under optimized conditions (pH = 7, adsorbent dosage = 0.01 g/L, contact time = 60 min, temperature = 25 °C) and a monolayer adsorption capacity of 24.71 mg/g. The adsorption process conformed to the Langmuir isotherm and followed pseudo-second-order kinetics, indicating monolayer coverage and chemisorption mechanisms. Thermodynamic analysis confirmed the adsorption process was spontaneous and exothermic. Recycling experiments demonstrated the zeolite’s strong reusability, highlighting its potential as an economically viable and environmentally friendly method for wastewater treatment applications. Further research should explore real wastewater applications and scale-up potential to support practical implementation.
Well-constrained lake water-budget assessment is essential for sustainable lake management. However, quantifying groundwater inflow, groundwater outflow, and evaporation remains challenging because subsurface fluxes are difficult to measure directly and tracers may behave differently under complex hydrogeochemical and biogeochemical conditions. This study evaluates electrical conductivity (EC) and stable oxygen isotope composition (δ¹⁸O) as complementary tracers for assessing the water budget of a drainage lake in Washington State, USA. EC and δ¹⁸O were measured over a two-year period in lake water, surface inflows and outflows, springs, marsh water, and precipitation, and were applied in transient mass-balance calculations to estimate groundwater exchange, evaporation, and residence time. EC and δ¹⁸O produced comparable groundwater inflow estimates of 0.075 ± 0.02 and 0.081 ± 0.02 m³/s, respectively, and similar groundwater outflow estimates of 0.12 ± 0.02 and 0.13 ± 0.03 m³/s. Both tracers yielded a mean residence time of approximately 2.7 years. However, this agreement for groundwater exchange did not indicate that EC behaved conservatively across the full lake water budget. Evaporation estimates diverged markedly: δ¹⁸O produced a plausible evaporation rate of 0.06 m³/s, consistent with Penman-based estimates, whereas EC generated an anomalous negative value, reflecting non-conservative behavior associated with mineralized inflows, source-water heterogeneity, and internal lake processes. These findings show that EC can support groundwater-exchange estimation when independently constrained, but it should not be used as a stand-alone conservative tracer for evaporation or full water-budget assessment. Together, EC and δ¹⁸O provide a stronger framework for interpreting groundwater–lake interactions and supporting sustainable lake management.
Artificial recharge of groundwater is a sustainable approach to mitigate water scarcity, particularly in arid and semi-arid regions. This study explores the utilization of wells for artificial groundwater recharge in dam reservoirs to enhance water storage, using remote sensing technology, geographical information systems, and groundwater surveys as well as meteorological data. The findings reveal that artificial recharge rates surpass natural recharge from rainfall, significantly enhancing groundwater storage. In addition, recharge wells effectively reduced evaporation losses from reservoirs and contributed to supplying groundwater aquifer. The study recommends the establishment of strategic water storage projects using artificial recharge wells, an increase in monitoring wells around dams, and the monitoring of hydrochemical changes in groundwater pre- and post-recharge. This research underscores the importance of integrating advanced technologies and strategic planning to optimize artificial recharge, reduce evaporation, and sustainably manage groundwater resources in arid regions.
9 October 2026 in Journal of Hydrology: Regional Studies