The rapid adoption of electric vehicles, together with increased battery mass and altered load distribution, is placing greater demands on ride comfort and suspension adaptability, while controller optimization may still request forces beyond the instantaneous capability of the physical semi-active actuator if experimentally supported force limits are not explicitly enforced. This study proposes a unified experimentally constrained optimization framework for a magnetorheological damper (MRD)-based semi-active suspension system using a two-degree-of-freedom quarter-car model. The damper is characterized at eleven current levels and represented by a branch-dependent lookup model that provides the zero-current baseline and instantaneous feasible force range. Proportional–integral–derivative (PID) and linear quadratic regulator (LQR) controllers are independently tuned using a genetic algorithm (GA) and particle swarm optimization (PSO) under identical vehicle dynamics, objective functions, tuning excitation, and MRD force constraints. Each candidate force demand is projected onto the experimentally derived feasible range throughout optimization. The controllers are tuned on a composite B–C–D profile and subsequently evaluated over nine road–speed scenarios. PID-PSO reduces the RMS sprung-mass acceleration by 15.91% and achieves the best acceleration performance in six cases, whereas LQR-PSO provides more balanced improvements in body motion, suspension travel, tire response, and force feasibility. The proposed framework therefore provides a more physically constrained basis for the comparative design and evaluation of MRD-based semi-active suspension control.
This study proposes two enhanced configurations for a parallel-channel cold plate in battery thermal management systems to improve thermo-hydraulic performance through the introduction of cylindrical and fin-type baffles. A three-dimensional computational fluid dynamics (CFD) model was developed in ANSYS to simulate fluid flow and heat transfer within the cold plate. A Poly-Hexcore meshing strategy with local refinement and near-wall inflation layers was employed to ensure numerical accuracy while maintaining computational efficiency. A parametric investigation involving 150 cases was conducted to identify the optimal channel configuration. The results indicate that, among the investigated configurations and under the present numerical operating conditions, the fin-type baffle exhibits the most balanced thermo-hydraulic behavior by achieving an effective balance between heat-transfer enhancement and pressure-drop penalty. The present study provides a CFD-based framework for the design and optimization of parallel-channel cold plates for battery thermal management applications.
2 September 2026 in Proceedings of the Institution of Mechanical Engineers, Part D: Journal of Automobile Engineering
This study investigates the lane-change response of a tractor–semitrailer vehicle and determines the corresponding geometric operating boundaries in terms of steering and velocity parameters. The main contributions are the development of a 28-degree-of-freedom multi-body dynamic model of a four-axle articulated vehicle using the Newton–Euler formulation, its low-frequency experimental assessment under representative low-to-moderate lateral-excitation conditions, its subsequent application in numerical parametric simulations to identify geometric lane-change operating boundaries in the velocity–steering parameter space. These boundaries are derived by post-processing the complete simulated swept envelope and are interpreted as condition-specific numerical predictions rather than experimentally validated thresholds of dynamic instability. The model incorporates tire nonlinear characteristics, suspension dynamics, and articulated coupling effects. A sinusoidal steering input is employed to simulate lane-change maneuvers under low-adhesion road conditions. The influences of steering amplitude, steering frequency, and vehicle speed on trajectory deviation and lane-change dynamic response are systematically analyzed. The results provide condition-specific numerical references for evaluating the swept-envelope response of articulated vehicles under prescribed steering inputs and offer a basis for future studies involving warning, monitoring, and control-oriented applications.