The crack initiation and short crack propagation in a martensitic spring steel were investigated by means of in-situ fatigue testing. Shot peened samples as well as untreated samples were exposed to uniaxial alternating stress to analyze the impact of compressive residual stresses. The early fatigue damage started in both sample conditions with the formation of slip bands, which subsequently served as crack initiation sites. Most of the slip bands and, correspondingly, most of the short fatigue cracks initiated at or close to prior austenite grain boundaries. The observed crack density of the emerging network of short cracks increased with the number of cycles and with increasing applied stress amplitudes. Furthermore, the prior austenite grain boundaries acted as obstacles to short crack propagation in both sample conditions. Compressive residual stresses enhanced the fatigue strength, and it is assumed that this beneficial effect was due to a delayed transition from short crack propagation to long crack propagation and a shift of the crack initiation site from the sample surface to the sample interior.

X-ray diffraction with high spatial resolution is commonly used to characterize (poly)crystalline samples with, for example, respect to local strain, residual stress, grain boundaries and texture. However, the investigation of highly absorbing samples or the simultaneous assessment of high-Z materials by X-ray fluorescence have been limited due to the utilization of low photon energies. Here, a goniometer-based setup implemented at the P06 beamline of PETRA III that allows for micrometre spatial resolution with a photon energy of 35 keV and above is reported. A highly focused beam was achieved by using compound refractive lenses, and high-precision sample manipulation was enabled by a goniometer that allows up to 5D scans (three rotations and two translations). As experimental examples, the determination of local strain variations in martensitic steel samples with micrometre spatial resolution, as well as the simultaneous elemental distribution for high-Z materials in a thin-film solar cell, are demonstrated. The proposed approach allows users from the materials-science community to determine micro-structural properties even in highly absorbing samples.

We demonstrate an approach to the reconstruction of scanning probe X-ray diffraction tomography data with anisotropic polycrystalline samples. The method involves reconstructing a voxel map containing an orientation distribution function in each voxel of a bulk 3D sample. By choosing a particular kind of basis functions, we can effectively utilize non-negativity in orientation space for samples with sparse texture. This enables us to achieve stable solutions at high angular resolutions where the problem would otherwise be underdetermined. This method differs from established approaches by not relying on a peak-finding step. It is therefore applicable to sample systems consisting of small and highly mosaic crystalline domains that are not handled well by these methods. We demonstrate the new approach using data from a shot-peened martensite sample where we are able to map the twinning microstructure in the interior of a bulk sample without resolving the individual lattice domains. We also demonstrate the approach on a piece of gastropod shell with a mosaic microstructure. The results suggest that, by utilizing the sparsity of the texture, the experiment can be carried out using only a single rotation axis, unlike previous demonstrations of texture and tensor tomography.