The development of biodegradable packaging materials has been drawing attention worldwide to minimize the environmental impact of traditional petroleum-based plastics. Nevertheless, it is challenging to obtain bio-based materials with suitable properties for packaging applications. Films produced from a single biopolymer often lack some important properties. An alternative to overcome this limitation is the multilayer assembly. Under this technology, two or more materials with specific and complementary properties are combined into a single-layered structure, thus improving the performance of bio-polymer plastics. This review presents the main aspects of bio-based multilayer film production technologies, discussing their advantages and disadvantages, which have to be considered to produce the most suitable film for each specific application. Most of the studies reported that such films resulted in increased mechanical performance and decreased water, oxygen, and dioxide carbon permeability. This approach allows the addition of compounds leading to antioxidant or antibacterial activity. Finally, a discussion about the future challenges is also presented. Graphical Abstract
In the present study, agro-food waste derived rice straw (RS) was valorized into cellulose microfibers (CMFs) using a green process of combined ultrasound and heating treatments and were thereafter used to improve the physical properties of thermoplastic starch films (TPS). Mechanical defibrillation of the fibers gave rise to CMFs with cumulative frequencies of length and diameters below 200 and 5–15 µm, respectively. The resultant CMFs were successfully incorporated at, 1, 3, and 5 wt% into TPS by melt mixing and also starch was subjected to dry heating (DH) modification to yield TPS modified by dry heating (TPSDH). The resultant materials were finally shaped into films by thermo-compression and characterized. It was observed that both DH modification and fiber incorporation at 3 and 5 wt% loadings interfered with the starch gelatinization, leading to non-gelatinized starch granules in the biopolymer matrix. Thermo-compressed films prepared with both types of starches and reinforced with 3 wt% CMFs were more rigid (percentage increases of ~215% for TPS and ~207% for the TPSDH), more resistant to break (~100% for TPS and ~60% for TPSDH), but also less extensible (~53% for TPS and ~78% for TPSDH). The incorporation of CMFs into the TPS matrix at the highest contents also promoted a decrease in water vapor (~15%) and oxygen permeabilities (~30%). Finally, all the TPS composite films showed low changes in terms of optical properties and equilibrium moisture, being less soluble in water than the TPSDH films.
This work evaluated the ozonation of cassava starch, correlating the process conditions with starch structure and properties. The starch structure was evaluated considering both molecules and granules. Ozonation resulted in an increased number of carbonyl and carboxyl groups with increasing ozone consumption. Moreover, a reduction of large and branched molecules was observed, with the consequent increase of smaller sized molecules. The structural changes significantly influenced the pasting properties, gel texture, water absorption and solubility indexes. As the main result, ozonation improved the hydrogels’ texture. The 145.3 mg O3 gstarch−1 sample produced gels ~280% stronger than the native starch. Moreover, the ozonated starch hydrogels maintained their consistency even at acidic conditions – on the contrary to native starch. Finally, the ozonated starch pastes were clearer than native ones. Therefore, ozone processing gives new possibilities for cassava starch application.