Changkui Lei

Dr. Changkui Lei

Taiyuan University of Technology, Taiyuan, Shanxi, China
orcid

Research Focus & Metrics

Academic Career Length

9Years (2018-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
1 March 2019 in Fuel
Verified
Journal Article
Closed access
CLChangkui Lei
Changkui Lei
JDJun Deng
Jun Deng
KCKai Cao
Kai Cao
YXYang Xiao
Yang Xiao
LMLi Ma
Li Ma
CSChimin Shu
Chimin Shu

6 April 2023 in ACS Omega
Verified
Journal Article
Open access
CLChangkui Lei
Changkui Lei
LJLijuan Jiang
Lijuan Jiang
RBRuoyu Bao
Ruoyu Bao
CDCunbao Deng
Cunbao Deng
CWChengbo Wang
Chengbo Wang

26 December 2019 in Combustion Science and Technology
Verified
Journal Article
Closed access
JDJun Deng
Jun Deng
LLLi Liu
Li Liu
CLChangkui Lei
Changkui Lei
CWCaiping Wang
Caiping Wang
YXYang Xiao
Yang Xiao
To study the migration of the high-temperature region and the dynamic changes in the index gas concentration during spontaneous coal combustion and oxidation, we established spatiotemporal distributions of the temperature and index gases during the dynamic evolution of spontaneous coal combustion. The XK-VI coal spontaneous combustion experimental system was used to investigate the migration law of the high-temperature region of loose coal in an air leakage field environment, and gas was then collected and analyzed. The results indicated that the coal temperature showed a stepwise change during the whole heating process. The general trend of the migration changes of the high-temperature points in the test furnace was to move toward the air inlet side and move from the low-oxygen concentration area toward the high-oxygen concentration area. Before the critical temperature, the high-temperature points were approximately 65 cm away from the air inlet. After the critical temperature, the high-temperature points gradually appeared at a distance of 45 cm from the air inlet. When the coal temperature exceeded the dry cracking temperature, the high-temperature points moved down to approximately 8 cm from the air inlet and finally moved to the air supply surface. Through analysis of the gas concentration in the furnace, the gas content varied with the migration of the high-temperature points in the furnace. The oxygen consumption rate and CO and CO2 production rates increased slowly before the dry cracking temperature and increased rapidly after the dry cracking temperature. The gas ratios of CO/CO2, CH4/C2H6, and C2H4/C2H6 changed near the critical temperature, and CO/CO2 and CH4/C2H6 changed from decreasing to rapidly increasing, and C2H4/C2H6 sharply increased from zero.

1 January 2019 in Advances in Civil Engineering
Verified
Journal Article
Open access
PDF file
XYXin Yi
Xin Yi
CLChangkui Lei
Changkui Lei
JDJun Deng
Jun Deng
LMLi Ma
Li Ma
JFJing Fan
Jing Fan
CSChi-Min Shu
Chi-Min Shu
Research on fire spread in super high‐rise buildings is crucial for identifying feasible methods of fire prevention and personnel evacuation. In this study, a fire spread model was established based on the fire dynamics simulator (FDS), and fire spread results were analyzed for a fire scenario in a single room under different conditions, a fire scenario in different functional places under the same conditions, and the spread of fire outside of the room. The results revealed that the critical time required for a fire to become a safety hazard in a shop, a restaurant, or an office was approximately 200 s. The same type of fire reached the critical time required for a fire to become a safety hazard more quickly in an office than a restaurant or shop, regardless of whether the fire spread was caused by CO mass fraction or temperature. More attention should be paid to fire safety in office spaces in super high‐rise buildings. Furthermore, compared with CO mass fraction and temperature, visibility was a more influential factor in determining the critical time required for fire to become a hazard, and smoke affected the adjacent open area in approximately 60 s. In the event of a fire, the temperature of the staircase and its front chamber was always lower than the threshold temperature of 60°C for human body tolerance.

23 October 2019 in Combustion Science and Technology
Verified
Journal Article
Closed access
XCXiaokun Chen
Xiaokun Chen
TMTeng Ma
Teng Ma
XZXiaowei Zhai
Xiaowei Zhai
CLChangkui Lei
Changkui Lei
BSBobo Song
Bobo Song
Understanding the development process of coal oxidation reactions can aid in preventing coal spontaneous combustion. Oxidation heating experiments on anthracite, bituminous coal, and lignite at different heating rates were carried out using simultaneous thermal analysis–Fourier transform infrared spectroscopy (STA–FTIR). The experimental results show that combining TG, DSC, CO, CO2 and H2O curves in the spontaneous combustion process of coal, the maximum acceleration point Ta and maximum mass loss rate T4 are important for judging the severity of the coal spontaneous combustion hazard. Meanwhile, Ta is more accurate as the ignition temperature point than the ignition temperature T3. As the coal’s rank and heating rate increases, the characteristic temperatures moved to higher temperature. The higher degree of metamorphism has a higher ignition activation energy. Additionally, the reaction models for ignition activation energy between anthracite and bituminous coal changed from three-way transport to random nucleation and nuclei growth with the increase of metamorphic rank, but were not affected by the heating rate.

19 May 2023 in Sustainability
Verified
Journal Article
Open access
PDF file
CLChangkui Lei
Changkui Lei
Xueqiang ShiXueqiang Shi
Xueqiang Shi
LJLijuan Jiang
Lijuan Jiang
CDcunbao Deng
cunbao Deng
JNJun Nian
Jun Nian
YGYabin Gao
Yabin Gao
Coal spontaneous combustion in underground mine goaf has a great impact on coal mining. The temperature-programmed experiment is a commonly used and effective method for studying the characteristics of coal spontaneous combustion. Aiming at the problem that the numerical simulation of coal spontaneous combustion characteristics under the condition of external air supply and temperature control in a temperature-programmed experiment is insufficient, a multi-physical field coupling numerical model of coal spontaneous combustion in the temperature-programmed experiment is established. The variation characteristics of coal temperature, oxygen, and oxidation products under external air supply and temperature control were studied. The results show that the numerical simulation results are consistent with the experimental results. With the increase in temperature, the volume fractions of oxygen and carbon dioxide decrease and increase, respectively. As the air supply volume increases, the oxygen volume fraction at the outlet increases, and the peak value of the oxygen volume fraction change rate exhibits a “hysteresis” feature, and the time corresponding to the peak value increases. Moreover, the temperature change rate increases. With the increase in the heating rate, the peak value of the oxygen volume fraction change rate increases and shows an “early appearance” characteristic, at the same time, the maximum coal temperature displays a linear increase trend.