Gigahertz hard X-ray imaging for the proposed matter-radiation interaction in extreme project presents an unprecedented challenge to front imager in both speed and radiation hardness. Novel fast scintillators are to be developed to face these challenges. This paper presents an investigation on the optical and scintillation properties for a set of fast inorganic scintillators. Transmittance, emission, light output, and decay time were measured. Based on this investigation, we plan to take two approaches to develop inorganic scintillators with subnanoseconds of decay time for the gigahertz hard X-ray imaging. One is yttrium-doped barium fluoride single crystals, and another is based on gallium-doped ZnO nanoparticles.
1 March 2018 in IEEE Transactions on Nuclear Science
Future high-energy physics experiments at the energy and intensity frontiers will face a challenge of severe radiation environment from both ionization dose and charged and neutral hadrons. The high-luminosity large hadron collider, for example, will present an environment, where up to 130 Mrad ionization dose, 3 × 1014 charged hadrons/cm 2 and 5× 10 15 neutrons/cm 2 are expected. In this paper, we report our investigation on charged hadron-induced radiation damage in BaF 2 , LYSO/LFS, and PWO crystals up to 3 × 10 15 protons/cm 2 by using 800-MeV protons at the Los Alamos Neutron Science Center. Comparison is made between radiation damages induced by protons and ionization dose alone.
21 April 2020 in IEEE Transactions on Nuclear Science
One crucial issue for the application of scintillation crystals in future high-energy physics experiments is radiation damage in a severe radiation environment, such as the high luminosity large hadron collider. While radiation damage induced by ionization dose in inorganic scintillators is well understood, investigations are on-going to understand radiation damage induced by hadrons, including both charged hadrons and neutrons. Aiming at understanding neutron induced radiation damage in fast inorganic scintillators, LYSO/LFS, BaF2 and PWO crystals were irradiated at Los Alamos Neutron Science Center by a combination of particles, including neutrons, protons and γ-rays. The results indicate that LYSO/LFS and BaF2 crystal plates are radiation hard up to a 1 MeV equivalent neutrons fluence of 9 ×1015 neq/cm2, but not PWO, and the neutron-induced radiation damage in LYSO crystals is a factor of ten less than protons.
Yb:CaF2 transparent ceramics represent a promising laser gain medium for ultra-short lasers due to their characteristics: low phonon energy, relatively high thermal conductivity, negative thermo-optical coefficient, and low refractive index. Compared to single crystals, Yb:CaF2 ceramics offer superior mechanical properties, lower cost, and it is easier to obtain large-sized samples with proper shape and uniform Yb3+ doping at high concentrations. The combination of air pre-sintering and Hot Isostatic Pressing (HIP) emerges as a viable strategy for achieving high optical quality and fine-grained structure of ceramics at lower sintering temperatures. The properties of the powders used in ceramic fabrication critically influence both optical quality and laser performance of Yb:CaF2 ceramics. In this study, the 5 atomic percentage (at.%) Yb:CaF2 transparent ceramics were fabricated by air pre-sintering and hot isostatic pressing (HIP) using nano-powders synthesized through the co-precipitation method. The co-precipitated powders were optimized by studying air calcination temperature (from 350 to 550 °C). The influence of calcination temperature on the microstructure and laser performance of Yb:CaF2 ceramics was studied in detail. The 5 at.% Yb:CaF2 transparent ceramics air pre-sintered at 625 °C from powders air calcined at 400 °C and HIP post-treated at 600 °C exhibited the highest in-line transmittance of 91.5% at 1200 nm (3.0 mm thickness) and the best laser performance. Specifically, a maximum output power of 0.47 W with a maximum slope efficiency of 9.2% at 1029 nm under quasi-CW (QCW) pumping was measured.