Surface-enhanced Raman scattering (SERS) is a highly sensitive technique for detecting DNA, proteins, and single molecules. The design of SERS substrates plays a crucial role, with the density of hotspots being a key factor in enhancing Raman spectra. In this study, we employed carbon nanowall (CNW) as the nanostructure and embedded plasmonic nanoparticles (PNPs) to increase hotspot density, resulting in robust Raman signals. To enhance the CNW’s performance, we functionalized it via oxygen plasma and embedded silver nanoparticles (Ag NPs). The authors evaluated the substrate using rhodamine 6G (R6G) as a model target molecule, ranging in concentration from 10⁻⁶ M to 10⁻¹⁰ M for a 4 min exposure. Our analysis confirmed a proportional increase in Raman signal intensity with an increase in concentration. The CNW’s large specific surface area and graphene domains provide dense hotspots and high charge mobility, respectively, contributing to both the electromagnetic mechanism (EM) and the chemical mechanism (CM) of SERS.

The fabrication of high-capacity, binder-free Li–ion battery anodes using a simple and efficient manufacturing process was reported in this research. The anode material for lithium–ion batteries utilized is a combination of two-dimensional (2D) carbon nanowalls (CNWs) and Cu nanoparticles (improved rate performance and capacity retention) or Si (high capacity) nanoparticles. A methane (CH₄) and hydrogen (H₂) gas mixture was employed to synthesize CNWs on copper foil through microwave plasma-enhanced chemical vapor deposition (PECVD). The Cu or Si nanoparticles were then deposited on the CNW surface using an RF magnetron sputtering equipment with four-inch targets. To analyze the electrochemical performance of the LIBs, CR2032 coin-type cells were fabricated using anode materials based on CNWs and other components. It was confirmed that the Cu−CNW demonstrates improved rate performance, increased specific capacity, and capacity retention compared with traditional anodes. Additionally, CNW combined with Si nanoparticles has enhanced the capacity of LIB and minimized volume changes during LIB operation.

Recently, as air pollution and particulate matter worsen, the importance of a platform that can monitor the air environment is emerging. Especially, among air pollutants, nitrogen dioxide (NO₂) is a toxic gas that can not only generate secondary particulate matter, but can also derive numerous toxic gases. To detect such NO₂ gas at low concentration, we fabricated a GNWs/NiO-WO₃/GNWs heterostructure-based gas sensor using microwave plasma-enhanced chemical vapor deposition (MPECVD) and sputter, and we confirmed the NO₂ detection characteristics between 10 and 50 ppm at room temperature. The morphology and carbon lattice characteristics of the sensing layer were investigated using field emission scanning electron microscopy (FESEM) and Raman spectroscopy. In the gas detection measurement, the resistance negative change according to the NO₂ gas concentration was recorded. Moreover, it reacted even at low concentrations such as 5–7 ppm, and showed excellent recovery characteristics of more than 98%. Furthermore, it also showed a change in which the reactivity decreased with respect to humidity of 33% and 66%.

Carbon is a material with interesting properties which exists in large quantities on Earth, so many studies involving carbon have been conducted. In particular, nano-sized carbon allotropes, referred to as carbon nanomaterials, comprise the subject of various studies currently underway. The electrical, chemical, physical properties of carbon nanowalls (CNWs) are modified by parameters such as surface density, height and thickness. These characteristics have significant effects on CNWs and can be adjusted as a growth interlayer. It was confirmed that the molybdenum disulfide (MoS₂) interlayer synthesized in this paper by radio frequency (RF) magnetron sputtering altered the morphological characteristics of the CNWs, including its shaped edge, pores diameter and density. We provide interesting results through FE-SEM, EDS and Raman analysis in this paper. Based on the Raman analysis, both the D-peak of carbon and the I_D/I_G ratio decreased. Through this study, the effect of MoS₂ on the morphological characteristics of CNWs was confirmed.

Carbon, which exists in large quantities on Earth, is a material with interesting properties, and many studies have been conducted since the past. In particular, nano-sized carbon allotropes are called carbon nanomaterials, and many studies are currently underway. Among them, carbon nanowall (CNW) is a structure in which graphene of sp2 bond is grown vertically, CNW have outstanding strength, can be highly electrically conducting or semiconducting, have a large specific surface area per unit mass. Electrical, chemical, physical properties of these CNW is modified by parameter such as surface density, height and thickness of it. Those have great effect on CNW and can be adjusted as growth interlayer. It was confirmed that the molybdenum disulfide (MoS2) interlayer synthesized by radio frequency (RF) magnetron sputtering altered the morphological characteristics such as the shaped edge of the CNW, the pores diameter and density. Through these studies, we confirmed the effect of MoS2 on the morphological characteristics of CNW. This opens the door to improving the performance of electrodes and devices.