Collapse is almost certain to occur in the industrial drying of Eucalyptus nitens and, as such this prevents the lumber manufacturing industry in Chile from producing commercial solid wood products from this species. This problem is still unsolved, and different studies to reduce collapse are currently underway. In this exploratory study, shrinkage and collapse after drying of Eucalyptus nitens was measured for boards cut from different radial locations within the stem (core, transition, and outer wood from pith to bark) and having different annual ring orientations (flat-sawn and quarter-sawn). Though exploratory, the results appear to confirm that pieces that were cut from the center of the trees were less susceptible to collapse than pieces cut from the transition zone between the center and the periphery. On average, collapse in transition wood was approximately 50% higher than the collapse observed in wood cut from the central zone of the trees.
This article reports the results of an exploratory study designed to reduce heat and electricity consumption in industrial drying of radiata pine. The experiments were performed with slight modifications of the standard drying schedules used by the sawmill to dry radiata pine in 100-m3 industrial kilns. The heat and electricity consumption were determined with data collected during the drying runs and calculations based on mathematical models. The results showed that depending on the case, heat and power consumption were respectively reduced by up to 14 and 35%.