Hidden corrosion defects can lead to dangerous accidents such as leakage of toxic materials causing extreme environmental and economic consequences. Ultrasonic guided waves showed good potential detecting distributed corrosion in pipeline networks at sufficiently large distances. To simplify signal analysis, traditional guided wave methods use low frequencies where only fundamental modes exist; hence, the small, localized defects are usually barely detectable. Novel techniques frequently use higher order guided wave modes that propagate around the circumference of the pipe and are more sensitive to the localized changes in the wall thickness. However current high order mode guided wave technology commonly uses either non-dispersive shear modes or higher order mode cluster (HOMC) waves that are mostly sensitive to surface defects. As the number of application cases of high order modes to corrosion detection is still limited, a huge potential is available to seek for other modes that can offer improved resolution and sensitivity to localized corrosion type defects. The objective of this work was to investigate higher order modes for corrosion detection and to determine the most promising ones in sense of excitability, leakage losses, propagation distance, and potential simplicity in the analysis. The selection of the proper mode is discussed with the support of phase and group velocity dispersion curves, out of plane and in plane distributions over the thickness and on surface of the sample, and leakage losses due to water load. The analysis led to selection of symmetric S3 mode, while the excitation of it was demonstrated through finite element simulations, taking into account the size of phased array aperture and apodization law and considering two-sided mode generation. Finally, theoretical estimations were confirmed with experiments, demonstrating the ability to generate and receive selected mode. It was shown that S3 mode is a good candidate for corrosion screening around the circumference of the pipe, as it has sufficient propagation distance, can be generated with conventional ultrasonic (UT) phased arrays, has sufficiently high group velocity to be distinguished from co-existing modes, and is sensitive to the loss of wall thickness.
Pipeline structures are susceptible to corrosion, leading to significant safety, environmental, and economic implications. Existing long range guided wave inspection systems often fail to detect footprints of the concentrated defects, which can lead to leakage. One way to tackle this issue is the utilization of circumferential guided waves that inspect the pipe’s cross section. However, achieving the necessary detection resolution typically necessitates the use of high-order modes hindering the inspection data interpretation. This study presents the implementation of an ultrasonic technique capable of detecting and classifying wall thinning and concentrated defects using high-order guided wave modes. The technique is based on a proposed phase velocity mapping approach, which generates a set of isolated wave modes within a specified phase velocity range. By referencing phase velocity maps obtained from defect-free stages of the pipe, it becomes possible to observe changes resulting from the presence of defects and assign those changes to the specific type of damage using artificial neural networks (ANN). The paper outlines the fundamental principles of the proposed phase velocity mapping technique and the ANN models employed for classification tasks that use synthetic data as an input. The presented results are meticulously verified using samples with artificial defects and appropriate numerical models. Through numerical modeling, experimental verification, and analysis using ANN, the proposed method demonstrates promising outcomes in defect detection and classification, providing a more comprehensive assessment of wall thinning and concentrated defects. The model achieved an average prediction accuracy of 92% for localized defects, 99% for defect-free cases, and 98% for uniform defects.