Super alloys offer excellent mechanical and chemical properties at elevated temperatures that make them an attractive choice for aerospace, automotive and chemical processing, and marine applications. These alloys are, however, difficult to machine due to their high strength at elevated temperatures, low thermal conductivity and work hardening. In this study, micro milling of Inconel 600 super alloy has been carried out and the effects of the key input parameters (cutting speed, feed rate, depth of cut) on response parameters (burr formation, surface roughness and tool wear), under various cooling conditions (dry, wet and cryogenic), have been analyzed. High speed micro milling (range up to 80,000 RPM) was carried out, while keeping the feed rate values below and above the cutting edge radius. The Taguchi design of experiments was used during this study. The results have been analyzed using SEM and 3D optical microscopy. Analysis of Variance (ANOVA) revealed that the best surface roughness values can be achieved under cryogenic machining condition with an overall contribution ratio of 28.69%. It was also revealed that cryogenic cooling resulted in the highest tool life with the contribution ratio of cooling conditions at 26.52%.
This research investigates the machinability of Inconel 718 under conventional machining speeds using three different tool coatings in comparison with uncoated tool during milling operation. Cutting speed, feed rate and depth of cut were selected as variable machining parameters to analyze output responses including surface roughness, burr formation and tool wear. It was found that uncoated and AlTiN coated tools resulted in lower tool wear than nACo and TiSiN coated tools. On the other hand, TiSiN coated tools resulted in highest surface roughness and burr formation. Among the three machining parameters, feed was identified as the most influential parameter affecting burr formation. Grey relational analysis identified the most optimal experimental run with a speed of 14 m/min, feed of 1 μm/tooth, and depth of cut of 70 μm using an AlTiN coated tool. ANOVA of the regression model identified the tool coating parameter as most effective, with a contribution ratio of 41.64%, whereas cutting speed and depth of cut were found to have contribution ratios of 18.82% and 8.10%, respectively. Experimental run at response surface optimized conditions resulted in reduced surface roughness and tool wear by 18% and 20%, respectively.
Polymer matrix wave transparent composites are used in a variety of high-speed communication applications. One of the applications of these involves making protective enclosures for antennas of microwave towers, air vehicles, weather radars, and underwater communication devices. Material performance, structural, thermal, and mechanical degradation are matters of concern as advanced wireless communication needs robust materials for radomes that can withstand mechanical and thermal stresses. These polymer composite radomes are installed externally on antennas and are exposed directly to ambient as well as severe conditions. In this research, epoxy resin was reinforced with a small amount of quartz fibers to yield an improved composite radome material compared to a pure epoxy composite with better thermal and mechanical properties. FTIR spectra, SEM morphology, dielectric constant (Ɛr) and dielectric loss (δ), thermal degradation (weight loss), and mechanical properties were determined. Compared to pure epoxy, the lowest values of Ɛr and δ were 3.26 and 0.021 with 30 wt.% quartz fibers in the composite, while 40% less weight loss was observed which shows its better thermal stability. The mechanical characteristics encompassing tensile and bending strength were improved by 42.8% and 48.3%. In high-speed communication applications, compared to a pure epoxy composite, adding only a small quantity of quartz fiber can improve the composite material’s dielectric performance, durability, and thermal and mechanical strength.
27 May 2022 in The International Journal of Advanced Manufacturing Technology