Ștefănica Eliza Tansanu

Mrs. Ștefănica Eliza Tansanu

orcid

Research Focus & Metrics

Academic Career Length

5Years (2022-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
16 March 2023 in Materials
Verified
Journal Article
Open access
PDF file
RVRobert Stefan Vizitiu
Robert Stefan Vizitiu
ABAndrei Burlacu
Andrei Burlacu
CACherifa Abid
Cherifa Abid
MBMarius Costel Balan
Marius Costel Balan
ȘTȘtefănica Eliza Tansanu
Ștefănica Eliza Tansanu
NKNicoleta Elena Kaba
Nicoleta Elena Kaba
This study presents an experimental and numerical investigation into the efficiency of a two-stage heat recovery–storage system for reducing the thermal energy losses in the industry. The system is designed to recover and store waste thermal energy from residual fluids using heat pipes for recovery and an environmentally friendly phase change material for heat storage. Experimental investigation was conducted using water as the primary agent and varying the temperature between 60 °C, 65 °C, and 70 °C at a constant flow rate of 24 L/min. The secondary agent, also water, was used at an initial temperature of 10 °C and the flow rate was varied between 1 L/min, 2 L/min, and 3 L/min. The results show that the system had a peak efficiency of 78.1% and was able to recover a significant amount of thermal energy. This study demonstrates the potential of this system to reduce the thermal energy losses in the industry and highlight the importance of further research and development in this field, as the industry is responsible for approximately 14% of the total thermal energy losses and finding efficient ways to recover and store waste thermal energy is crucial to achieving sustainable energy consumption.

4 September 2024 in Sustainability
Verified
Journal Article
Open access
PDF file
RVRobert Stefan Vizitiu
Robert Stefan Vizitiu
ȘTȘtefănica Eliza Tansanu
Ștefănica Eliza Tansanu
ABAndrei Burlacu
Andrei Burlacu
CACherifa Abid
Cherifa Abid
MBMarius Costel Balan
Marius Costel Balan
NKNicoleta Elena Kaba
Nicoleta Elena Kaba
The implementation of energy-saving measures has a substantial and beneficial impact on the preservation of energy resources as well as the reduction of carbon dioxide emissions. This study focuses on the design and experimental analysis of a water-to-air heat recovery system aimed at capturing waste heat from wastewater and transferring it to a fresh cold air stream using heat pipe technology. The research problem addressed in this study is the efficient recovery of low-grade thermal energy from wastewater, which is often underutilized. The prototype heat recovery unit was designed, manufactured, and tested in the laboratory to assess its performance across various operating conditions. The experimental setup included a system where the primary agent, hot water, was heated to 60 °C and circulated through the evaporator section of the heat recovery unit, while the secondary agent, fresh air, was forced through the condenser section. The system’s performance was evaluated under different air velocities, ranging from 3.5 m/s to 4.5 m/s, corresponding to airflow rates of 207.1 m3/h and 268.6 m3/h, respectively. The study employed analytical methods alongside empirical testing to determine the effectiveness of the heat recovery system, with the global heat transfer coefficient calculated for different scenarios. The efficiency of the system varied between 25% and 51.6%, depending on the temperature and speed of the fresh air stream. The most significant temperature difference observed between the inflow and outflow of the fresh air stream was 16.8 °C, resulting in a thermal output of 1553 W. Additionally, the average (mean) overall heat transfer coefficient of the unit was calculated to be 49 W/m2 K, which aligns with values reported in the literature for similar systems. The results demonstrate the potential of the designed system for practical applications in energy conservation and carbon emission reduction.

15 August 2024 in Sustainability
Verified
Journal Article
Open access
PDF file
ȘTȘtefănica Eliza Tansanu
Ștefănica Eliza Tansanu
CACherifa Abid
Cherifa Abid
ABAndrei Burlacu
Andrei Burlacu
RVRobert Stefan Vizitiu
Robert Stefan Vizitiu
MBMarius Costel Balan
Marius Costel Balan
In the transition to sustainable energy consumption, waste heat recovery and storage systems become key to advancing Europe’s energy efficiency and reducing carbon emissions, especially by harnessing thermal energy from low-temperature sources like wastewater. This study focuses on optimizing a heat recovery system that uses heat pipes for effective heat extraction and coconut oil as a phase change material for efficient thermal storage. A total of 12 numerical simulations were conducted to analyze the outcomes of varying operational parameters, including the diameter of the heat pipe, condenser size, secondary agent flow rate, coil length, and primary agent inlet temperature. The numerical findings indicate that reduced flow rates, in combination with smaller condenser diameters and increased primary agent temperatures, greatly improve the efficiency of heat absorption and transfer. Following a 4 h test period, the most successful outcome resulted in a melting fraction of 98.8% and a temperature increase of 18.95 °C in the output temperature of the secondary agent. In contrast, suboptimal conditions resulted in only a 2.21 °C rise and a 30.80% melting fraction. The study highlights the importance of component sizing and optimization, noting that strategic modifications and appropriate phase change materials can lead to highly efficient and scalable systems.

1 March 2022 in Bulletin of the Polytechnic Institute of Iași. Construction. Architecture Section
Verified
Journal Article
Open access
PDF file
ȘTȘtefănica Eliza Tansanu
Ștefănica Eliza Tansanu
ABAndrei Burlacu
Andrei Burlacu
RVRobert Ștefan Vizitiu
Robert Ștefan Vizitiu
The concept of energy is closely related to the building sector and the systems used for heating, implicitly energy saving which is a current problem of both old and new buildings. In this paper a series of numerical simulations were made in Autodesk CFD Simulation in order to study the influence of terminal heating systems over the thermal comfort in rooms. Three case solutions were analysed, as follows: heating a room using a steel radiator, heating a room using an aluminium radiator and heating a room using underfloor heating. The values resulted through numerical simulations for the average room temperature were compared with the values for ideal heating. It was observed that underfloor heating is the most efficient source of heating among those analysed. Compared to heating using radiators, the temperatures along the length and height of the room using underfloor heating are constant and close to the ideal heating. The human body feels the most comfortable due to the uniform distribution of temperature from ground level, on height.

1 June 2022 in Bulletin of the Polytechnic Institute of Iași. Construction. Architecture Section
Verified
Journal Article
Open access
PDF file
ȘTȘtefănica Eliza Tansanu
Ștefănica Eliza Tansanu
ABAndrei Burlacu
Andrei Burlacu
RVRobert Ștefan Vizitiu
Robert Ștefan Vizitiu
The concept of energy is closely related to the building sector and the systems used for heating, implicitly energy saving which is a current problem of both old and new buildings. In this paper a series of numerical simulations were made in Autodesk CFD Simulation in order to study the influence of terminal heating systems over the thermal comfort in rooms. Three case solutions were analysed, as follows: heating a room using a steel radiator, heating a room using an aluminium radiator and heating a room using underfloor heating. The values resulted through numerical simulations for the average room temperature were compared with the values for ideal heating. It was observed that underfloor heating is the most efficient source of heating among those analysed. Compared to heating using radiators, the temperatures along the length and height of the room using underfloor heating are constant and close to the ideal heating. The human body feels the most comfortable due to the uniform distribution of temperature from ground level, on height.

2 March 2025
Verified
Book Chapter
Closed access
PDF file
RMRadu Gabriel Mihai
Radu Gabriel Mihai
ȘTȘtefănica Eliza Tansanu
Ștefănica Eliza Tansanu
GBGabriel Bejan
Gabriel Bejan
DADorin Avram
Dorin Avram
MBMarinela Barbuta
Marinela Barbuta
MTMowaffak Tawfiq
Mowaffak Tawfiq