Central Asia, and in particular Tajikistan, is one of the most geologically hazardous areas in the world, particularly in terms of seismicity, floods, and landslides. The majority of landslides that occur in the region are seismically induced. A notable site is the Baipaza landslide, which has been subject to deformation since the 1960s, with the most recent collapse occurring in 2002. The potential collapse of the landslide represents a significant risk to the nearby Baipaza hydroelectric dam, situated 5 km away, and has the potential to create widespread challenges for the entire region. The objective of this work is to provide a comprehensive characterization of the Baipaza landslide through the utilization of satellite remote-sensing techniques, exploiting both Sentinel-1 Synthetic Aperture Radar (SAR) and Sentinel-2 optical images freely available from the European Space Agency’s (ESA) Copernicus project. The employment of these two techniques enables the acquisition of insights into the distinctive characteristics and dynamics of the landslide, including the displacement rates up to 246 mm/year in the horizontal component; the precise mapping of landslide boundaries and the identification of distinct sectors with varying deformation patterns; and an estimation of the volume involved within the landslide, which is approximately of 1 billion m3.
The results of multi-interferometric processing applied to radar images acquired by the European Space Agency (ESA) Sentinel-1 constellation, obtained in the framework of the IPL (International Programme on Landslides) project n.221, are presented in this manuscript. The target area is the Hunza-Nagar River valley, a remote area in northern Pakistan. The Humarri slide, a massive landslide located along the left side of the valley, is the most active phenomenon in the area, and poses a very high risk to the Humarri village built in the lowest part of the landslide, and a threat of damming the Hispar River. The highest deformation rates (with peaks higher than 300 mm/yr) were recorded in the middle and low part of the landslide. Where the Humarri village is located, the velocity values are lower and range between −30 and −80 mm/yr. The analysis of displacement time series, spanning from February 2017 to January 2020, reveal different deformation behaviors and different onset of accelerating behaviors within the landslide body. The global coverage, the wide-area mapping capabilities, and the regular acquisitions planning ensured by the Sentinel-1 constellation, coupled with InSAR ability to deliver very precise and spatially dense information, make it possible to scan wide areas and spot unstable zones, especially where remoteness, vast areal extension, and climatic conditions make it difficult to undertake field activities.
21 June 2026 in Earth Surface Processes and Landforms
Peatlands are natural terrestrial carbon stores that play a key role in climate change mitigation. Accurate mapping of these ecosystems remains challenging due to their complex surface characteristics and the limitations of traditional optical‐based methods. This paper presents a method for the detection of peatland‐like displacement dynamics using open‐source advanced differential interferometric synthetic aperture radar data from the European Ground Motion Service. Vertical displacement time series are analysed using a two‐step unsupervised framework that integrates principal component analysis and k ‐means clustering in Great Britain to identify areas exhibiting peat‐like displacement behaviour. This provides a process‐based complement to traditional optical peatland mapping approaches. The results reveal distinct subsidence trends and seasonal deformation patterns typical of peat soils, even in regions not classified as peatlands in existing land cover databases. Cross‐correlation analysis with climatic variables further highlights the sensitivity of peatlands to moisture and temperature variations. Three case studies are shown to validate the approach and demonstrate its potential for refining peatland inventories: (i) Hatfield Moors, (ii) New Forest and (iii) an area north of Tilshead not classified as peatland in the land cover database. The proposed solution exploits the potential of Sentinel‐1 data to enhance peatland identification, characterise their response to environmental parameters and support the updating of existing land cover maps. A more precise identification of peatland ecosystems is relevant for climate change analysis and resilience. This methodology provides a robust, cost‐effective tool for identifying peat‐like behaviour areas and for significantly enhancing conservation and restoration efforts.
1. Remote sensing systems represent a crucial technological advancement in Earth Observation (EO). These systems enable the acquisition of data over wide geographical areas regarding targets on the...
An approach for assessing the quantitative vulnerability, through empirical fragility and vulnerability curves, of masonry buildings exposed to slow-kinematic landslides is described. More in detail, the fragility curves express the probability of exceeding a given level of damage for a range of landslide intensity values. Starting from these ones, the vulnerability curve provides the mean level of damage severity to a given building (or aggregate of buildings) in relation to the landslide intensity value. The application of the vulnerability curve is exploited in the quantitative risk analysis (QRA), that quantifies the probability of a given level of loss.The Department of Earth Sciences of the University of Florence has catalogued the severity damage landslide-induced to over four thousand masonry buildings gathered from in situ surveys in the northern Apennines. Moreover, to retrieve the fragility and, consequently, the vulnerability curves for buildings, the proposed method exploits the results of spaceborne Advanced Differential Interferometry SAR (A-DInSAR) analysis. In particular, such a method considers the landslide intensity value equal to the module of the vertical (up-down) and horizontal (east-west) deformation velocity obtained by properly combining ascending and descending Sentinel-1 DInSAR products, retrieved through the P-SBAS (Parallel-Small Baseline Subset) method developed at IREA-CNR.This approach to assess the vulnerability has been integrated within the well-known QRA procedure, which is based on the application of the risk equation (R=H*V*E), where:R is the landslide risk in terms of economic loss;H is the hazard retrieved from the susceptibility map available for the entire Italian territory;V is the vulnerability obtained directly from the equation of the vulnerability curve;E is the exposure of buildings assessed from average real estate market parameters reported in the OMI (Osservatorio Mercato Immobliare).The effectiveness of the proposed procedure has been tested over the municipality of Zeri (Massa-Carrara, Italy), where a large-scale landslide risk map has been produced. In particular, for each building of the study area, the hazard, the vulnerability, the exposure and the risk associated with it, are presented. The analysis estimates a total risk of 33.2 million euro for the Zeri municipality and the identification of specific buildings at highest risk. The provided result can be useful for the civil protection activities of the local administrator identifying areas with higher potentiality of damage on structures.