Aeronautic transport is a leading energy consumer that strongly contributes to greenhouse gas emissions due to a significant dependency on fossil fuels. Biodiesel, a substitution of conventional fuels, is considered as an alternative fuel for aircrafts and power generation turbine engines. Unfortunately, experimentation has been mostly limited to small scale turbines, and technical challenges remain open regarding operational safety. The current study presents the facility, the instrumentation, and the measured results of experimental tests in a 640 kW full-scale J69-T-25A turbojet engine, operating with blends of Jet A1 and oil palm biodiesel with volume contents from 0% to 10% at different load regimes. Findings are related to the fuel injection system, the engine thrust, and the emissions. The thrust force and the exhaust gas temperature do not expose a significant variation in all the operation regimes with the utilization of up to 10% volume content of biodiesel. A maximum increase of 36% in fuel consumption and 11% in injection pressure are observed at idle operation between B0 and B10. A reduction of the CO and HC emissions is also registered with a maximum variation at the cruise regime (80% Revolutions Per Minute—RPM).
1 August 2020 in Sustainable Energy Technologies and Assessments
The conversion of biomass to olefin by employing gasification has recently gained the attention of the petrochemical sector, and syngas composition is a keystone during the evaluation of process design. Process simulation software is a preferred evaluation tool that employs stoichiometric and kinetic approaches. Despite the available literature, the estimation errors of these simulation methods have scarcely been contrasted. This study compares the errors of stoichiometric and kinetic models by simulating a downdraft steam gasifier in PRO/II. The quantitative examination identifies the model that best predicts the composition of products for the gasification of Japanese wood waste. The simulation adopts reaction mechanisms, flowsheet topology, reactions parameters, and component properties reported in the literature. The results of previous studies are used to validate the models in a comparison of the syngas composition and yield of products. The models are used to reproduce gasification at temperatures of 600∼900 °C and steam-to-biomass mass ratios of 0∼4. Both models reproduce experimental results more accurately for changes in the steam-to-biomass mass ratio than for temperature variations. The kinetic model is more accurate for predicting composition and yields, having global errors of 3.91%-mol/mol and 8.16%-g/gBM, respectively, whereas the simple stoichiometric model has an error of 7.96%-mol/mol and 16.21%-g/gBM.
12 October 2023 in Chemical Engineering Research and Design