We demonstrate a 102 W middle infrared (ZGP) optical parametric amplifier (OPA) pumped by a 2097-nm -switched Ho:YAG laser at a pulse repetition frequency of 10 kHz. The seed middle infrared laser was produced by a ZGP optical parametric oscillator. Its average power was 28.4 W pumped by a 50 W 2097-nm laser. By thermal lens compensation, the beam factor reduced from 3.1 to 2.1. When the incident Ho pump power was 120 W, the middle infrared ZGP OPA yielded the maximum average output power of 102 W and slope efficiency of 61.7%. The overall optical conversion efficiency of 60% from Ho to middle infrared was obtained for the whole middle infrared laser system. In addition, at the maximum average output power, the beam quality factors of the middle infrared ZGP OPA were measured to be about 2.7 and 2.8 for horizontal and vertical directions, respectively.
A high-efficiency and high-brightness Ho:YAG master-oscillator power-amplifier (MOPA) system dual-end pumped by Tm:YLF lasers was demonstrated. The maximum output power of 231 W at a wavelength of 2090.7 nm was achieved with pulse repetition frequency of 10 kHz and pulse width of 22.9 ns, corresponding to pulse energy of 23.1 mJ and peak power of . The extraction efficiency of the amplifier system was more than 60%. The beam quality factor was measured to be . Using the Ho:YAG MOPA system as the pump source, the optical parametric oscillator delivered an output power of 110 W, corresponding to slope efficiency of 62%.
In this paper, we demonstrate a 570.0 MHz harmonically mode-locked all-polarization-maintaining Ho-doped fiber laser based on semiconductor saturable absorbed mirror. Firstly, the laser operates in the 15.4 MHz fundamental mode-locked soliton regime, emitting 2051.5 nm, 1.62 ps soliton pulse without Kelly sidebands. And then, the stable 37th-order harmonic mode-locked soliton with maximum repetition rate up to 570.0 MHz at 2053nm is generated. Moreover, colorful soliton rain behaviors are also discussed.
A 1064-nm femtosecond fiber chirped pulse amplification (FCPA) laser system based on a single-stage double-pass Yb-doped rod-type photonic crystal fiber (PCF) amplifier was demonstrated with a pulse repetition rate of 500 kHz, which was specially designed for expected conversion efficiency enhancement of a 10.8 eV source. With a series of Yb:fiber power amplifiers, the average output power was boosted to approximately 35 W. Further, using a transmission gratings-based pulse compressor, an average output power of 27.5 W was achieved, corresponding to a pulse energy of 55 µJ and a compression efficiency of 78.6%. The shortest pulse duration was optimized to be 204 fs, which was also accompanied by obvious pedestal. A pulse duration of 336 fs was also obtained when the pulse quality was at a top priority. To the best of our knowledge, this is the first demonstration of high-repetition-rate high-pulse-energy 1064-nm, instead of 1035-nm, femtosecond laser, based on commercially available Yb-doped rod-type PCF amplifier.
A high efficiency, continuous-wave, narrow linewidth, pump-enhanced optical parametric oscillator (OPO) at 3.8 µm was demonstrated, which was pumped by a 1064 nm fiber laser with a linewidth of 18 kHz. The low frequency modulation locking technique was employed to stabilize the output power. The wavelengths of signal and idler were 1475.5 nm and 3819.9 nm at 25 °C, respectively. The pump-enhanced structure was applied, leading to a maximum quantum efficiency of over 60% with pump power of 3 W. The maximum output power of idler light is 1.8 W with a linewidth of 363 kHz. The excellent tuning performance of the OPO was also demonstrated. In order to avoid mode-splitting and decrease of pump enhancing factor due to feedback light in the cavity, the crystal was placed obliquely to the pump beam and the maximum output power was increased by 19%. At the maximum output power of idler light, the M2 factors in the x and y directions were 1.30 and 1.33, respectively.