Guansheng Lv

Dr. Guansheng Lv


Research Focus & Metrics

Academic Career Length

9Years (2018-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
28 May 2019 in IEEE Access
Verified
Journal Article
Open access
GLGuansheng Lv
Guansheng Lv
WCWenhua Chen
Wenhua Chen
XLXin Liu
Xin Liu
FGFadhel M. Ghannouchi
Fadhel M. Ghannouchi
ZFZhenghe Feng
Zhenghe Feng
This paper presents a fully integrated C-band Doherty power amplifier (DPA) based on a 0.25-μm GaN-HEMT process for 5G massive MIMO application. The performance degradation caused by nonlinear output capacitance is analyzed, and a novel compensation technique is proposed. A low-Q output network is employed to broaden the bandwidth, and its insertion loss in the back-off region is demonstrated to be mainly decided by the Q-factor of the drain bias inductor of the main PA. Hence, by adopting on-chip transmission lines with high Q-factors for drain biasing, a full integration and a low loss can be achieved simultaneously. Reversed uneven power splitting and back-off input matching are proposed for gain enhancement. The fabricated DPA demonstrates a small-signal gain of 8.6 -11.6 dB, an output power of 40.4 -41.2 dBm, a 6-dB back-off drain efficiency (DE) of 47% -50%, and a saturation DE of 55% -63% across a wide bandwidth from 4.5 to 5.2 GHz, with an ultra-compact size of 2.2 mm × 2.1 mm. Using a 40-MHz LTE signal with a 7.7-dB peak-to-average power ratio at the carrier frequency of 4.9 GHz, the measured average output power and efficiency are 33 dBm and 43%, respectively. The raw adjacent channel power ratio is -29 dBc, and is improved to -46 dBc by applying digital predistortion.

28 January 2019 in IEEE Microwave and Wireless Components Letters
Verified
Journal Article
Closed access
GLGuansheng Lv
Guansheng Lv
WCWenhua Chen
Wenhua Chen
XLXin Liu
Xin Liu
ZFZhenghe Feng
Zhenghe Feng
This letter implements a 3.5-/5.8-GHz dual-band power amplifier (PA) with hybrid operating modes for 5G mobile communication and vehicle network using a 0.25-μm gallium nitride (GaN)-HEMT process. For the 3.5-GHz band, the PA operates in the Doherty mode, and the performance is optimized for a high back-off efficiency and a large bandwidth. For the 5.8-GHz band, the PA operates in class-AB mode, and optimal saturation efficiency is used as the design goal. According to the measurement results, a saturated power of 41.8-42.6 dBm, a saturated drain efficiency (DE) of 56%-64%, and a 6-dB back-off DE of 42%-51% are achieved from 3.3 to 3.8 GHz, while the saturated power and DE at 5.8 GHz are 41 dBm and 55%, respectively. To our best knowledge, this is the first dual-band GaN monolithic microwave integrated circuit PA designed for hybrid operating modes.

15 April 2019 in IEEE Transactions on Microwave Theory and Techniques
Verified
Journal Article
Closed access
GLGuansheng Lv
Guansheng Lv
WCWenhua Chen
Wenhua Chen
XCXiaofan Chen
Xiaofan Chen
FGFadhel M. Ghannouchi
Fadhel M. Ghannouchi
ZFZhenghe Feng
Zhenghe Feng
In this paper, a Ka/Q dual-band Doherty power amplifier (DPA) with simplified offset lines is implemented in a 0.1-μm gallium arsenide (GaAs) process. It is found that the dual-band transmission lines (TLs) employed in the sub-6-GHz dual-band DPA are not suitable to be used as the offset lines in millimeter-wave (mm-wave) dual-band DPAs due to their large sizes and insert losses. An in-depth analysis reveals that the phase requirement of the offset lines can be relaxed, and the DPA exhibits a reasonable performance in a certain phase-shift range. A novel design method is proposed to realize offset lines using simple TLs, which can satisfy the phase-shift ranges in dual bands by choosing a proper electrical length. To enhance the gain of the DPA, a reversed uneven power splitter is adopted to deliver more power to the main power amplifier (PA). The fabricated DPA achieves an output power of 25.4/25.2 dBm, a peak power-added efficiency (PAE) of 33%/25%, and a 6-dB back-off PAE of 22%/17% at 29/46 GHz, respectively, with a compact size of 2.2 1.4 mm². Applying a 20-MHZ 64-quadratic-amplitude modulation (QAM) signal with a 7.7-dB peak-to-average power ratio (PAPR), the measured average output power, PAE, and error vector magnitude (EVM) at 29/46 GHz are 18.4/19 dBm, 17%/15%, and 1.5%/1.1% after linearization, respectively. To the best of our knowledge, the proposed DPA is the first demonstration of mm-wave dual-band DPAs that do not require any additional switching or reconfiguration.

26 March 2021 in IEEE Transactions on Microwave Theory and Techniques
Verified
Journal Article
Closed access
GLGuansheng Lv
Guansheng Lv
WCWenhua Chen
Wenhua Chen
XCXiaofan Chen
Xiaofan Chen
FGFadhel Ghannouchi
Fadhel Ghannouchi
ZFZhenghe Feng
Zhenghe Feng
This article presents a fully integrated distributed efficient power amplifier (DEPA) for fifth-generation (5G) massive multiple-input multiple-output (MIMO) applications. In conventional DEPA, an individual input matching network (IMN), power splitter, and phase compensation line are used for each auxiliary power amplifier (PA) unit, resulting in a large overall size. To facilitate integration, an energy-efficient and compact DEPA with modified input matching and power splitting network is proposed, where a distributed input matching network (DIMN) is used for the auxiliary PA. A broadband input matching, reasonable power splitting, and phase alignment can be achieved simultaneously by adjusting the dimensions of gate transmission lines (TLs) between different auxiliary PA units. An integrated DEPA is implemented in a commercial 0.25- μm GaN-HEMT process to validate the proposed architecture. The fabricated DEPA shows a saturated output power of 40.4-41.7 dBm, an 8-dB back-off drain efficiency (DE) of 35%-50%, and a saturated DE of 46%-56% from 3.2 to 5.2 GHz, with a compact size of 3.4×3.0 mm 2 . Applying a 100-MHz orthogonal frequency division multiplexing (OFDM) signal with a 7.8-dB peak-to-average power ratio (PAPR), an average efficiency of 35.7%-47% is measured over the entire bandwidth, and the adjacent channel power ratio (ACPR) is better than -46 dBc after digital predistortion (DPD). To the best of our knowledge, the proposed DEPA demonstrates the widest bandwidth among all reported fully integrated back-off efficient PAs without using digital techniques or reconfiguration.

8 December 2021 in IEEE Transactions on Microwave Theory and Techniques
Verified
Journal Article
Closed access
GLGuansheng Lv
Guansheng Lv
WCWenhua Chen
Wenhua Chen
YZYu Zhang
Yu Zhang
NCNingwei Chen
Ningwei Chen
FGFadhel Ghannouchi
Fadhel Ghannouchi
ZFZhenghe Feng
Zhenghe Feng
This article presents a highly linear Doherty power amplifier (DPA) based on phase mismatch. When output phase mismatch (OPM) is introduced, i.e., the phase shift of the output impedance transformer deviates from 90°, the power-combining network (PCN) will exhibit a certain amplitude-to-phase (AM–PM) characteristic. When input phase mismatch (IPM) is introduced, i.e., the main and auxiliary branches are not phase-aligned, the AM–PM of the PCN can be further finely tuned. By choosing proper OPM and IPM, the AM–PM of the overall DPA can be compensated by that of the PCN while maintaining reasonable back-off and saturated performances. Moreover, the PCN with phase mismatch shows gain expansion, and thus the amplitude-to-amplitude (AM–AM) distortion of the DPA can also be improved to some extent. A fully integrated DPA is implemented in a $0.25~\mu \text{m}$ gallium nitride (GaN)-HEMT process to validate the proposed method. The fabricated DPA realizes an AM–PM of 2° and an AM–AM of 0.3 dB at 6.3 GHz, with a saturated power of 41.1 dBm and a 6 dB back-off drain efficiency (DE) of 45%. Applying a 200 MHz signal with a 7.8 dB peak-to-average power ratio (PAPR), a raw adjacent channel power ratio (ACPR) of −42 dBc and an average DE of 37.4% are measured at the output power of 33.1 dBm. When the carrier frequency is swept from 6.1 to 6.5 GHz, a raw ACPR below −39 dBc and an average DE better than 37% are maintained.

24 September 2021 in IEEE Transactions on Microwave Theory and Techniques
Verified
Journal Article
Closed access
GLGuansheng Lv
Guansheng Lv
WCWenhua Chen
Wenhua Chen
XCXiaofan Chen
Xiaofan Chen
SWShun Wan
Shun Wan
FGFadhel Ghannouchi
Fadhel Ghannouchi
ZFZhenghe Feng
Zhenghe Feng
In this article, a fully integrated dual-band gallium nitride (GaN) Doherty power amplifier (DPA) based on multi-resonant circuits (MRCs) is presented. A lumped T-type network in combination with the output capacitances of the main and auxiliary transistors is able to realize the quarter-wavelength transformer (QWT) in DPA, and its component values are totally decided by the operating frequency, given a certain characteristic impedance. MRCs are proposed to exhibit the required component values at two different frequencies. By replacing each component in the T-type network with an MRC, a dual-band QWT can be achieved. An integrated dual-band DPA is implemented in a commercial 0.25- $\mu \text{m}$ GaN-HEMT process to validate the proposed method. The fabricated DPA shows a saturated output power of 43.8–44.7/44.4–44.8 dBm, a 6-dB back-off drain efficiency (DE) of 41%–46%/41.5%–47%, and a saturated DE of 49%–52%/56%–59% in 3.35–3.6/4.8–5.2 GHz, with a compact size of $2.8\times3.5$ mm 2 . Applying a 100-MHz OFDM signal with a 7.8-dB peak-to-average power ratio (PAPR), an average efficiency of 37%/40% and an average power of 37/37 dBm are measured at 3.5/5.0 GHz, and the adjacent channel power ratio (ACPR) is better than −49 dBc after digital predistortion (DPD). To the best of our knowledge, the proposed DPA is the first demonstration of fully integrated dual-band GaN DPAs.