This paper reports the characterization of a miniaturized circulatory column system that is capable of magnifying the effective column length by forming a circulatory loop with chip-scale columns, thus ultimately achieving high-efficiency target separation. The circulatory column system is composed of a tandem of 25 cm microcolumns and six valves for fluidic flow control in order to enable chromatographic separation in circulatory motions while requiring only 5.5 kPa of pressure, which current micropumps are currently capable of supplying. The developed column system (1) successfully demonstrated 16 times elongation of a virtual column length up to 800 cm by only utilizing two 25 cm microcolumns, which is the longest column length reported by any MEMS-scale functioning GC column, (2) achieved a high theoretical plate number of 68 696 with pentane circulating after 15.5 circulatory cycles, which corresponds to the plate number per length-pressure of 1611 plate m−1 kPa−1, the highest record reported yet, and (3) demonstrated successful separation of target molecules during circulation by utilizing a pentane/hexane mixture, resulting in magnification of the two corresponding peaks via circulation.
This paper reports the development of a nano-gap vapor sensor that is capable of detecting an airborne target in a repeatable manner in near-zero static power consumption. The nano-gap sensor employed a matching gap distance of 5.8 nm to the lengths of both linkers and targets for selectivity. The nano-gap sensor was fabricated based on deposition and removal of a thin sacrificial layer via atomic-layer-deposition (ALD), and then coated with newly-synthesized linkers. The fabricated vapor sensor demonstrated the detection of a target gas (1, 5-Diaminopentane) or Cadaverine in a concentration of <;100ppm; produced a notable on/off current ratio of 104~107; and repeatable performance up to 2 times.
This paper presents a new technique for the fabrication of high resolution non-planar precision microshells for hemispherical resonating gyros via a poached-egg micromolding (PEM) method. In PEM, precision ball lenses are used as starting molds. Hemispherical shells are formed on the lenses using five major steps: (1) isotropic coating with sacrificial and shell layers, (2) stencil transfer of coated lenses to substrate, (3) shell top removal by anisotropic etching, (4) sacrificial layer etching and (5) release of the ball lens molds. Using PEM, we fabricated posted sputtered ultra-low-expansion glass hemispherical shells of 1 mm diameter and 1.2 μm thickness. The microshells have better than 120 ppm uniformity in thickness and less than ±0.125 μm deviation from a perfect sphere. The measured microshell resonant frequency at 100 mTorr was 17.32 kHz and the Q was ~ 20,000.