Helder Roberto de Oliveira Rocha

Prof. Helder Roberto de Oliveira Rocha

Federal University of Espirito Santo (UFES)
orcid

Research Focus & Metrics

Academic Career Length

14Years (2013-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
1 January 2021 in Applied Energy
Verified
Journal Article
Closed access
HRHelder Roberto de Oliveira Rocha
Helder Roberto de Oliveira Rocha
IHIcaro H. Honorato
Icaro H. Honorato
RFRodrigo Fiorotti
Rodrigo Fiorotti
WCWanderley C. Celeste
Wanderley C. Celeste
LSLeonardo J. Silvestre
Leonardo J. Silvestre
JSJair Adriano Lima Silva
Jair Adriano Lima Silva

13 April 2020 in IEEE Sensors Journal
Verified
Journal Article
Closed access
MFMenno Jan Faber
Menno Jan Faber
KZKlaas Minne van der Zwaag
Klaas Minne van der Zwaag
WSWillian Garcia Viega dos Santos
Willian Garcia Viega dos Santos
HRHelder Roberto de Oliveira Rocha
Helder Roberto de Oliveira Rocha
MSMarcelo Segatto
Marcelo Segatto
JSJair Adriano Lima Silva
Jair Adriano Lima Silva
A theoretical study and an experimental evaluation on the performance of the long-range (LoRa) technology are presented in this paper. After an instructive mathematical review of important concepts, we assess the LoRa performance in additive white Gaussian noise (AWGN) channels through a numerical model, to elucidate its communication capabilities in negative signal-to-noise ratio (SNR) conditions and, as consequence, in the long distances promised by such low power and narrowband technology. Because of the significance of forward error correction codes in the performance of modern systems, we propose an analytical bit-error-rate (BER) expression that considers the influence of LoRa code rate (CR) parameter. The agreement between the theoretical and the numerical results of a Hamming coded system validated the closed-form BER, evaluated in terms of SNR in AWGN channels. Moreover, an experimental setup with off-the-shelf LoRa wide area network (LoRaWAN) equipment was prepared to demonstrate the feasibility of this promising technology, as well the impact of the CR parameter on the packet error rate (PER), in a link with a single end-device. As expected, communication in urban and open areas with distances up to ≈3 and ≈10 km, respectively, were achieved, according to measurements of the average received signal indicators around -100 dBm for an average SNR ≈5 dB. The usefulness of the practical analysis was confirmed by the agreement between the theoretical and the measured noise floors, and by the verification of the substantial impact of the parameter CR on the system PER.

5 August 2024 in Applied Energy
Verified
Journal Article
Closed access
RFRodrigo Fiorotti
Rodrigo Fiorotti
JFJussara Fardin
Jussara Fardin
HRHelder Roberto de Oliveira Rocha
Helder Roberto de Oliveira Rocha
DRDavid Rua
David Rua
JLJoão Abel Peças Lopes
João Abel Peças Lopes

16 November 2023 in Applied Energy
Verified
Journal Article
Closed access
HRHelder Roberto de Oliveira Rocha
Helder Roberto de Oliveira Rocha
RFRodrigo Fiorotti
Rodrigo Fiorotti
DLDanilo M. Louzada
Danilo M. Louzada
LSLeonardo J. Silvestre
Leonardo J. Silvestre
WCWanderley C. Celeste
Wanderley C. Celeste
JSJair A.L. Silva
Jair A.L. Silva

11 February 2020 in IEEE Access
Verified
Journal Article
Open access
Arnaldo Leal-JuniorArnaldo Leal-Junior
Arnaldo Leal-Junior
HRHelder Roberto de Oliveira Rocha
Helder Roberto de Oliveira Rocha
Antreas TheodosiouAntreas Theodosiou
Antreas Theodosiou
ANAnselmo Frizera Neto
Anselmo Frizera Neto
Carlos MarquesCarlos Marques
Carlos Marques
MRMoises R. N. Ribeiro
Moises R. N. Ribeiro
We report the development of an optimization approach for diaphragm-embedded optical fiber sensors, which was applied on the pressure, force and liquid level assessment using chirped fiber Bragg gratings (CFBGs) inscribed in cyclic transparent optical polymer (CYTOP) fibers. The inscription was performed using the plane-by-plane method with a femtosecond laser, whereas the diaphragm optimization was performed through the multi-objective particle swarm optimization (MOPSO). The objective functions for the optimization were obtained from numerical simulation using the finite element method of diaphragms with different thickness and diameters. The MOPSO resulted in a set of solutions with thickness and diameter aiming the optimization of sensitivity and linearity of diaphragm-embedded CFBG sensors. Three configurations were chosen with different values sensitivity and linearity. Experimental analysis was performed in each configuration for temperature and pressure variations, where the results confirmed the different sensitivity and linearity levels for each chosen configuration. Two applications were analyzed for the proposed configurations with higher sensitivity and linearity: one for force estimation over a 200-N range and the other for sub-millimeter assessment of liquid level over a 50-cm range. In order to obtain a highly reliable and accurate system, a novel data integration method for chirped FBGs was proposed. In this case, the estimation of force, pressure or liquid level was performed considering the contributions of both wavelength shift and full width half maximum (FWHM) variations. The proposed approach resulted in error improvement of 60% for all cases and for all parameters analyzed.

21 January 2023 in Sensors
Verified
Journal Article
Open access
PDF file
MGMatheus Araújo Gava
Matheus Araújo Gava
HRHelder Roberto de Oliveira Rocha
Helder Roberto de Oliveira Rocha
MFMenno Jan Faber
Menno Jan Faber
MSMarcelo Segatto
Marcelo Segatto
Heinrich WörtcheHeinrich Wörtche
Heinrich Wörtche
JSJair Adriano Lima Silva
Jair Adriano Lima Silva
A resource optimization methodology is proposed for application in long range wide area networks (LoRaWANs). Using variable neighborhood search (VNS) and a minimum-cost spanning tree algorithm, it reduces the implementation and the maintenance costs of such low power networks. Performance evaluations were conducted in LoRaWANs with LoRa repeaters to increase coverage, in scenario where the number and the location of the repeaters are determined by the VNS metaheuristic. Parameters such as spread factor (SF), bandwidth and transmission power were adjusted to minimize the network’s total energy per useful bit (Ebit) and the total data collection time. The importance of the SF in the trade-off between (Ebit) and time on-air is evaluated, considering a device scaling factor. Simulation results, obtained after model adjustments with experimental data, show that, in networks with few associated devices, there is a preference for small values of SF aiming at reduction of Ebit. The usage of large SF’s becomes relevant when reach extensions are required. The results also demonstrate that, for networks with high number of nodes, the scaling of devices over time become relevant in the fitness function, forcing an equal distribution of time slots per SF to avoid discrepancies in the time data collection.