The main purpose of cold chain is to keep the temperature of products constant during transportation. The internal temperature of refrigerated truck body is mainly measured with a temperature sensor installed at the hottest point on the body. Hence, the measured temperature cannot represent the overall temperature values of transported products in the body. Moreover, the airflow pattern in the refrigerated body can vary depending on the arrangement of loaded logistics, resulting temperature differences between the transported products. In this study, the airflow and temperature change in the refrigerated body depending on the loading patterns of box were analyzed using experimental and numerical analysis methods. Ten different box loading patterns were applied to the body of 0.5 ton refrigerated truck. The temperatures inside boxes were measured depending on the loading patterns. CFD modeling with two different turbulence models (k-ε and SST k-ω) was developed using COMSOL Multiphysics for predicting the temperatures inside boxes loaded with different patterns, and the predicted data were compared to the experimental data. The k-ε turbulence model showed a higher temperature error than the SST k-ω model; however, the highest temperature point inside the boxes was almost accurately predicted. The developed model derived an approximate temperature distribution in the boxes loaded in the refrigerated body.
The popularity of senior-friendly food has been increasing as the world enters the age of an aging society. It is required that senior-friendly food products are processed with the new concept of processing techniques that do not destroy the nutritional and sensory values. Ohmic heating can be an alternative to conventional heating methods for processing senior-friendly food with retaining excellent taste and quality because of less destruction of nutrients in the food. In this study, the ohmic–vacuum combination heating system was developed to process a multiphase type of senior-friendly food. Changes in physical and electrical properties of senior-friendly model foods were investigated depending on the experimental conditions such as vacuum pressure intensity and vacuum pretreatment time. Numerical simulations based on the experimental conditions were performed using COMSOL multiphysics. The ohmic–vacuum combination heating method with agitation reduced the heating time of the model food, and non-uniform temperature distribution in model food was successfully resolved due to the effect of vacuum and agitation. Furthermore, the difference was found in the hardness of solid particles depending on the vacuum treatment time and intensity after the heating treatment. The ohmic–vacuum combination heating system appeared effective when applying for the senior-friendly foods in multiphase form. The simulation results matched reasonably well with the experimental data, and the data predicted through simulation could save the cost and time of experimentation.
The processing of sprout vegetables in powder form has been known to extend the shelf-life by retaining nutritional values; however, sprout powder products were exposed to a variety of contaminants, such as microbial contaminants, during processing and storage. Therefore, the proper treatment for removing the contaminants in the powder was required without compromising their quality properties. This study was conducted (1) to determine a suitable pasteurization method for sprout barley powder, and (2) to investigate the effect of vacuum-steam heating combination treatment on the quality change and the lethality of microorganisms in sprout barley powder. The heating pattern of sprout barley powder was elucidated with a vacuum-thermal combination system consisting of a vacuum chamber, overhead stirrer, far-infrared heater, and PID (Proportional-Integral-Differential) controller. In addition, the mixing patterns of sprout barley powder, depending on the types of stirring blades, were evaluated by discrete element modeling using EDEM™ software. The vacuum-steam combination heating system was fabricated using the investigated pre-design factors. The quality change in sprout barely powder was evaluated by measuring the microbial inactivation, CIE values (L*, a*, b*, ΔE), and water activity (aw). During the pasteurization process, steam could be directly injected into the chamber at regular intervals for two hours to transfer moisture and heat to the powder. By combining steam and vacuum conditions, the population of E. coli O157:H7 in the powder was reduced by 4.33 log CFU/g, eliminating all E. coli O157:H7 in the powder. In addition, the water activity (aw) of the powder was significantly decreased in a vacuum pressure environment without the quality deterioration.