Kim Hyunchang

Mr. Kim Hyunchang

Sungkyunkwan University, Suwon, Gyeonggi, Republic of Korea

Research Focus & Metrics

Academic Career Length

5Years (2022-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
24 October 2022 in Applied Sciences
Verified
Journal Article
Open access
PDF file
ACAhyeong Choi
Ahyeong Choi
Kim HyunchangKim Hyunchang
Kim Hyunchang
Mingyuan HuMingyuan Hu
Mingyuan Hu
YKYOUNGJAE KIM
YOUNGJAE KIM
HAHYEONGKI AHN
HYEONGKI AHN
Kwanho YouKwanho You
Kwanho You
Sliding mode control and disturbance compensation techniques are applied to a nonlinear speed control algorithm for a permanent magnet synchronous motor (PMSM). Optimizing the speed control performance of PMSM systems with various disturbances and uncertainties is challenging. To achieve a satisfactory performance, a sliding mode control method based on the super-twisting algorithm reaching law (STRL) is presented. STRL can adapt dynamically to the variations of a controlled system. The STRL maintains a high tracking performance of the controller and allows the control input to eliminate chattering. To estimate the uncertainties and compensate for disturbances, a support vector regression-disturbance observer (SVR-DOB) is presented. The estimated uncertainties were used to minimize modeling errors and improve the disturbance rejection. A controller using SVR-DOB achieves a high precision, and the simulation results demonstrated the validity of the proposed control approach.

10 May 2022 in Sensors
Verified
Journal Article
Open access
PDF file
Mingyuan HuMingyuan Hu
Mingyuan Hu
Kyunghyun LeeKyunghyun Lee
Kyunghyun Lee
HAHYEONGKI AHN
HYEONGKI AHN
ACAhyeong Choi
Ahyeong Choi
Kim HyunchangKim Hyunchang
Kim Hyunchang
Kwanho YouKwanho You
Kwanho You
A modified sigmoid sliding mode control (MS-SMC) approach is proposed for stabilizing and tracking a quadrotor system with a nonlinear sliding surface, where the dynamics model is underactuated, highly coupled, and nonlinear. The constructed nonlinear sliding surface is based on the traditional sliding mode surface with a modified sigmoid function, allowing the initial value to quickly reach equilibrium. A new type of nonlinear SMC is applied for performance improvement of the quadrotor using the proposed modified sigmoid sliding surface. To control the quadrotor effectively, a double-loop control method is used to design the control rate, in which the position subsystem is the outer loop, and the attitude subsystem is the inner loop.With the Lyapunov function, the stability of the overall closed-loop system is ensured by stabilizing each subsystem step by step. Moreover, from a practical point of view, the system performance under the model uncertainties and external disturbances are also considered. The simulation results show that the proposed MS-SMC performs better than the conventional sliding mode control (CSMC) and the back-stepping sliding mode control (BS-SMC) in terms of stabilization and tracking against external disturbances.

25 November 2022 in Processes
Verified
Journal Article
Open access
PDF file
HAHYEONGKI AHN
HYEONGKI AHN
Kim HyunchangKim Hyunchang
Kim Hyunchang
ACAhyeong Choi
Ahyeong Choi
Kwanho YouKwanho You
Kwanho You
In this study, we propose a hypocenter localization algorithm that uses the time difference of arrival (TDOA) and angle of arrival (AOA) as a hybrid model. The hypocenter measurements are detected by the accelerator sensors of the four separate observatories that are closest to the origin of an earthquake. The measurements are calibrated by the proposed deep learning P-onset picking system with short-time Fourier transform (STFT) signal analysis because the accurate detection of Primary waves (P-waves) is limited by seismic environmental noise. The revised measurements are used to calculate the precise distances between the observatories and hypocenters. The proposed hybrid TDOA/AOA is represented by a linear matrix equation that includes the unknowns of the precise distances, coordinates, and arrival angles to the observatories. We estimate a hypocenter using the constrained least squares method (CLS) under the constraints of the TDOA/AOA. The objective function with the constraints is optimized using the Lagrange function, and the asymptotic optimum is obtained by specifying the optimal Lagrange multipliers. Simulations show the performance of the proposed hypocenter localization method.