The plough is the basic machine for soil work. It is usually connected to the tractor by means of a suspension system. The suspension system is a bar-shaped arm system fixed to the tractor frame, which fixes and raises the attached machine in three points. Its role is significant. Single-sided ploughing on slopes creates some special situations. This phenomenon was observed during a plowing competition and in this paper we look for solutions related to this topic.

This study presents a comparative analysis of the water droplet erosion resistance of three compressor wheels coated with Ni-P and Si-P layers. The tests were conducted using a custom-developed experimental apparatus in accordance with the ASTM G73-10 standard. The degree of erosion was monitored through continuous precision mass measurements, and structural changes on the surfaces of both the base materials and the coatings were examined using a Zeiss Crossbeam 350 scanning electron microscope (SEM). Hardness values were determined using a Vickers KB 30 hardness tester, while the chemical composition was analysed using a WAS Foundry Master optical emission spectrometer. Significant differences in erosion resistance were observed among the various compressor wheels, which can be attributed to differences in coating hardness values, as well as to the detachment of the Ni-P layer from the base material under continuous erosion. In all cases, water droplet erosion led to a reduction in the isentropic efficiency of the compressor—measured using a hot gas turbocharger testbench—with the extent of efficiency loss depending upon the type of coating applied. Although blade protection technologies for turbocharger compressor impellers used in the automotive industry have been the subject of only a limited number of studies, modern technologies, such as the application of certain alternative fuels and exhaust gas recirculation, have increased water droplet formation, thereby accelerating the erosion rate of the impeller. The aim of this study is to evaluate the resistance of three different coating layers to water droplet erosion through standardized tests conducted using a custom-designed experimental apparatus.

The three-point linkage serves to interconnect the power machine and the suspended or semi-suspended work machine. It has a role in the operation of the machine group, in towing and in the setup of the machines. Part of the weight of the suspended machine is loaded on the driven wheels, thus increasing the adhesion weight which results in an increase in the tractive force. Understanding the operation of this equipment it is necessary for horticulture, agronomy and landscape architecture future engineers. In this thesis we model the effect of connection points of the three-point linkage on the tractive force in a specific case: that of the suspended plow.