There is a growing need for stability enhancement in modern electrical networks integrated with wind energy, particularly due to different oscillation modes disturbances. Power system stabilizers (PSSs) are used to mitigate oscillations and improve the stability of the power system. This paper presents a comprehensive analysis of single-band PSS1A and multi-band PSS4C (MB-PSS4C) connected to the ST1A excitation system. An efficient approach in the selection of the parameters of MB-PSS4C using Particle Swarm Optimization (PSO) is proposed. A comparative investigation linked to the common Pattern Search and Simplex Search, from previous work, has been conducted to gauge the efficacy of PSO. The generator’s transient stability with considerations of relative power angle (power angle differences), speed deviation, and active power of synchronous generators (SGs) are analyzed. Different wind penetration levels ranging from 36MW to 108 MW are integrated into the network and are investigated. Results demonstrate that PSO-MB-PSS4C connected to ST1A stabilizes the system effectively with reduced settling time while mitigating the peak power angle differences of SGs. Reduced settling time of 1.35 s is observed for wind penetration of 48 MW, with 43.31° peak power angle; while for high wind penetration of 108 MW, the settling time is around 8 s with peak power angle of 43.9°.
Wind Energy serves as one of the most cost-efficient renewable sources of energy that reduces the carbon emissions. The need for stability enhancement in power systems with the integration of wind energy is a great concern as this is future forward towards energy sustainability. Multi-Band Power System Stabilizer (MB-PSS) has proven to be an effective controller to increase the efficiency and stability of power systems. This article presents a novel method for MB-PSS4C optimization under the fault condition, where the parameters are tuned based on the Simplex Search method. The wind energy integrated power system is investigated to assess the effect of wind energy uncertainty on transient stability and an in-depth analysis of actual wind speed is conducted. A 3-phase fault is carried out to evaluate the effect of Optimized OMB-PSS4C on the stability of two-area four-machine system integrated with wind energy. MATLAB is used to investigate transient stability based on the nonlinear simulation of relative power angle and speed deviation of synchronous generators (SGs). The presented results established that when the OMB-PSS4C and exciter ST1A are used, the relative power angle changed from an unstable to steady-state within the settling time of around 3 s with an accompanying decrease of peak value from 54.8° to 43.23°. The high penetration of wind energy has the potential to cause an increase in settling time, for instance the settling time increased to 7.87 s after integrating 108 MW based wind energy. However, the stability of the system is guaranteed with the utilization of OMB-PSS4C.
The use of wind energy is increased due to the high demand for sustainable energy. The penetration of wind energy in electrical networks might have several effects on load flow and power system stability. In this research, the transient stability of the IEEE 9-Bus system integrated with Doubly Fed Induction Generator (DFIG) is analyzed. Additionally, different penetration levels of a wind farm are considered. With a 5% penetration of wind energy, the maximum power angle of the synchronous generator is around 129 deg, which is quite similar to the existing system. In contrast, the power angle increases to 140 deg after adding more wind turbines with 15% wind farm penetration. Then, the system loses stability with a 25% penetration of wind energy. The results indicate that the high penetration of wind energy has a destabilizing impact on the studied network. Moreover, the location of the wind farm affects transient stability. This research intends to contribute towards assessing the stability of the power system integrated DFIG. Hence, this study will support the increase of using wind energy in power systems rather than conventional power plants and evaluate the stability to enable the reliability of alternative energy sources in the grid.
Nowadays, there is an increased concern for stability improvement in modern electrical systems, especially due to the use of distributed generation into the grids. Stability of power system is one of the main challenges to improve the power system efficiency. A Power System Stabilizer (PSS) is a cost-effective controller and efficient device to increase the stability and reliability of power systems. In this paper, the transient stability of IEEE 9-bus system is improved with the integration of excitation system and PSS. The relative power angle is considered to evaluate the transient stability. The simulation results show that the existing system has oscillated. However, when the system is integrated with the exciter ST1A and PSS1A, the peak power angle decreases from 132.1° to 103.7°, and the settling time is 5.53 s. Additionally, the speed deviation is improved when PSS connected to ST1A.
System stability plays a significant role in the development of modern power systems. Power System Stabilizer (PSS) is an effective device often used to provide auxiliary damping to the oscillations by stabilizing the signals. Particle Swarm Optimization (PSO) is a popular and intelligent optimization technique used to solve various optimization problems. In this research work, the transient stability of the two-area four-machine system is improved using PSS1A. PSS1A is a single-input single-band power system stabilizer. The PSS1A parameters are optimized using PSO to enhance the stability and mitigate the oscillations. The simulation results of the relative power angle of Synchronous Generators (SGs) show that the transient stability is significantly improved with Optimized PSS1A (O-PSS1A), and the oscillations are mitigated. The maximum relative power angle of generator 1 and generator 2, with respect to generator 4, reduced by 29.5% and 33.6% respectively with the proposed O-PSS1A. Similarly, a reduction was obtained in settling time of both generator 1 and generator 2 at 4.94 s and 3.66 s compared to the system without PSS which was unstable.
1 December 2021 in Journal of Physics: Conference Series
Electricity is in high demand with a fast-growing population; hence it is advisable to turn towards green energy. In this research, Wind Turbine (WT) is modelled with two different types of induction generators (IGs), which are the Doubly-Fed Induction Generator (DFIG) and Squirrel-Cage Induction Generator (SCIG) and implemented to IEEE 9-Bus system to assess the transient stability. MATLAB/ Simulink R2019a platform was considered to carry the whole examination. DC1A excitation system was applied to Synchronous Generators (SGs) as well as Power System Stabilizer (PSS). The transmission line7-5 was found to suffer from a high peak value of a relative power angle of approximately 130 degrees. As for the settling time, without PSS it was 20.69 s and with PSS it became 6.23 s. A wind farm with a rated capacity of 60 MW was used in the system. WT integrated with DFIG has the lowest peak value of 127 degrees at Bus locations 4 and 5 and for SCIG, Bus 5 with a peak value of 136 degrees. Thus, it can be propelled as the perfect location. Moreover, this is due to the three-phase fault was located at the transmission line7-5 which is far away from Buses 4 and 5. In the end, the WT integrated with DFIG provides a lower peak value of relative power angle compared to SCIG, whereas for settling time, it is the opposite.