With industry development, the separation of oily wastewater is becoming more critical. Inspired by organisms such as lotus leaves, biomimetic superhydrophobic surfaces with micro-nano structures have shown great potential in this regard. In this work, PDMS/PVDF oil–water separation membranes with designed microstructures were prepared by electrospinning technology. The membrane-forming effect of electrospinning with different ratios of PDMS and PVDF was studied. The study found that membranes with high PDMS content were more likely to form microspheres, and PDMS tended to concentrate on the microspheres. The results also showed that the microspheres would bring better hydrophobicity to the membrane. When the ratio of PDMS to PVDF is 1:2, the membrane has a water contact angle of up to 150° and an oil contact angle of 0°. At this ratio, the separation efficiency of the membrane for the water-in-oil emulsion is 98.7%, and it can still maintain more than 98% after ten separation cycles, which is a good candidate for oil–water separation. Furthermore, microspheres enable the membrane to achieve macroscopic uniformity and microscopic phase separation so that the membranes have both good elongation and fracture strength. In addition, the PDMS/PVDF membranes also exhibit excellent UV resistance, and their UV protection factor is greater than 185, making them a potential UV protective material.
The problems of environmental pollution are increasingly severe. Among them, industrial wastewater is one of the primary sources of pollution, so it is essential to deal with wastewater, especially oil and water mixtures. At present, biomimetic materials with special wettability have been proven to be effective in oil-water separation. Compared with three-dimensional (3D) materials, two-dimensional (2D) materials show unique advantages in the preparation of special wettable materials due to their high specific surface area, high porosity, controlled structure, and rich functional group rich on the surface. In this review, we first introduce oil–water mixtures and the common oil–water separation mechanism. Then, the research progress of 2D materials in oil–water separation is presented, including but not limited to their structure, types, preparation principles, and methods. In addition, it is still impossible to prepare 2D materials with large sizes because they are powder-like, which greatly limits the application in oil–water separation. Therefore, we provide here a review of several ways to transform 2D materials into 3D materials. In the end, the challenges encountered by 2D materials in separating oil–water are also clarified to promote future applications.
Titanium alloys have limited applications due to their poor friction performance. Inspired by the scale structures on biological surfaces in nature, laser surface texturing technology was employed to fabricate diamond-shaped biomimetic micro-textures with different angles and area densities on the surface of titanium alloy (Ti6Al4V). The coupling effect of scale-like biomimetic micro-textures and polytetrafluoroethylene (PTFE) coatings on the frictional properties of Ti6Al4V were explored. A comparison was made between PTFE-coated untextured and textured samples, and the tribological properties of PTFE coatings on surfaces with different texture angles and densities were investigated. The contact stress distribution between the friction pairs was simulated using ANSYS finite element analysis software. We found that the combination of textured surfaces and PTFE coatings effectively reduced the friction coefficient of Ti6Al4V and enhanced the load-bearing capacity of the PTFE coating. This is because the diamond-shaped biomimetic micro-textures facilitate the continuous supply of PTFE lubricant to the Ti6Al4V friction surface, providing long-lasting lubrication and reducing friction during the tribological process. The textured samples with a 90° angle and an areal density of 30% exhibited the best friction-reducing properties, with the average friction coefficient decreasing by 71.42% under a 10 N load and 73.50% under a 20 N load. This study employed a combination of experiments and simulations to validate the effects of texture angle and areal density on the coupled PTFE coating, providing guidance for the optimization design of textured titanium alloys surfaces with solid lubricants.
4 June 2024 in Journal of Materials Engineering and Performance