Corner modifications can reduce wind loads acting on supertall buildings and modify the corresponding flow structures. The present study investigated the aerodynamic shape optimization of the corner recession square cylinders with multiple geometric parameters in a large design space via the GA-GRNN surrogate model updating-based multi-objective optimization framework. Six typical optimal aerodynamic shape sections M1~M6 were selected from the Pareto optimal front, and the effects of multiple geometric parameters of these sections on the aerodynamic performance and flow field were analyzed. The results showed that the present multi-objective optimization framework can significantly reduce the computational load and time cost, and significantly improve the optimization efficiency in solving complex engineering problems. The optimal corner recession sections can obviously reduce the mean drag coefficient CD and root mean square lift coefficient CσL while significantly increasing the Strouhal number St of the square cylinder, and it is concluded that the aerodynamic shape optimization can significantly improve the aerodynamic performance of square-sectional supertall buildings. When compared with the benchmark section, the CD and CσL of the optimal section M1 can be reduced up to 45.7% and 84.5%, respectively. Based on the analysis of the flow structures around the optimal sections, the flow mechanism can be attributed to the fact that the corner recession modifications postpone the flow separation, and deflect the separated shear layer towards the side surfaces and suppress the development of vortex shedding in the wake, which leads to significant elongation of the wake length and reduction of the width of the recirculation region. The proposed multi-objective optimization framework in this study can provide an important reference for the aerodynamic shape optimization of building structures and relevant studies.
This study presents a full-scale steady CFD methodology for evaluating flow quality in a large-scale low-speed wind tunnel (8 m × 6 m test section, 130 m/s). The tunnel geometry is resolved at 1:1 scale, the damping screens and honeycomb are modeled as porous media, and results are validated against wind tunnel test data and the GJB 1179A-2012 acceptance criteria. The baseline configuration reproduces the axial static pressure gradient within the acceptance criterion but substantially overpredicts turbulence intensity, dynamic pressure coefficient, and both velocity direction deviation angles. Damping screens, modeled as porous jumps, provide the dominant correction, bringing all metrics within the acceptance limits. Adding honeycomb yields incremental improvement: porous zone modeling preserves or improves all metrics, whereas a porous jump representation pushes velocity direction deviations beyond the limit. Between RNG k-ε and SST k-ω, only turbulence intensity is closure-dependent, with RNG k-ε closer to experiment. At Ma ≈ 0.38, compressibility does not alter the flow quality assessment, confirming that incompressible assumption is sufficient. By replacing costly physical trials with a validated CFD workflow, these findings provide a practical, resource-efficient reference for the CFD-based evaluation, design, and retrofit of wind tunnel infrastructure that underpins renewable-energy and energy-efficiency research.
About Me
Mainly engaged in structural wind engineering research
Mainly engaged in structural wind engineering research