Meat species authentication in food is most commonly based on the detection of genetic variations. Official food control laboratories frequently apply single and multiplex real-time polymerase chain reaction (PCR) assays and/or DNA arrays. However, in the near future, DNA metabarcoding, the generation of PCR products for DNA barcodes, followed by massively parallel sequencing by next generation sequencing (NGS) technologies, could be an attractive alternative. DNA metabarcoding is superior to well-established methodologies since it allows simultaneous identification of a wide variety of species not only in individual foodstuffs but even in complex mixtures. We have recently published a DNA metabarcoding assay for the identification and differentiation of 15 mammalian species and six poultry species. With the aim to harmonize analytical methods for food authentication across EU Member States, the DNA metabarcoding assay has been tested in an interlaboratory ring trial including 15 laboratories. Each laboratory analyzed 16 anonymously labelled samples (eight samples, two subsamples each), comprising six DNA extract mixtures, one DNA extract from a model sausage, and one DNA extract from maize (negative control). Evaluation of data on repeatability, reproducibility, robustness, and measurement uncertainty indicated that the DNA metabarcoding method is applicable for meat species authentication in routine analysis.
23 July 2021 in Journal of Veterinary Diagnostic Investigation
The continued search for intermediate hosts and potential reservoirs for SARS-CoV2 makes it clear that animal surveillance is critical in outbreak response and prevention. Real-time RT-PCR assays for SARS-CoV2 detection can easily be adapted to different host species. U.S. veterinary diagnostic laboratories have used the CDC assays or other national reference laboratory methods to test animal samples. However, these methods have only been evaluated using internal validation protocols. To help the laboratories evaluate their SARS-CoV2 test methods, an interlaboratory comparison (ILC) was performed in collaboration with multiple organizations. Forty-four sets of 19 blind-coded RNA samples in Tris-EDTA (TE) buffer or PrimeStore transport medium were shipped to 42 laboratories. Results were analyzed according to the principles of the International Organization for Standardization (ISO) 16140-2:2016 standard. Qualitative assessment of PrimeStore samples revealed that, in approximately two-thirds of the laboratories, the limit of detection with a probability of 0.95 (LOD95) for detecting the RNA was ≤20 copies per PCR reaction, close to the theoretical LOD of 3 copies per reaction. This level of sensitivity is not expected in clinical samples because of additional factors, such as sample collection, transport, and extraction of RNA from the clinical matrix. Quantitative assessment of Ct values indicated that reproducibility standard deviations for testing the RNA with assays reported as N1 were slightly lower than those for N2, and they were higher for the RNA in PrimeStore medium than those in TE buffer. Analyst experience and the use of either a singleplex or multiplex PCR also affected the quantitative ILC test results.
Game meat products are particularly prone to be adulterated by replacing game meat with cheaper meat species. Recently, we have presented a real-time polymerase chain reaction (PCR) assay for the identification and quantification of roe deer in food. Quantification of the roe deer content in % (w/w) was achieved relatively by subjecting the DNA isolates to a reference real-time PCR assay in addition to the real-time PCR assay for roe deer. Aiming at harmonizing analytical methods for food authentication across EU Member States, the real-time PCR assay for roe deer has been tested in an interlaboratory ring trial including 14 laboratories from Austria, Germany, and Switzerland. Participating laboratories obtained aliquots of DNA isolates from a meat mixture containing 24.8% (w/w) roe deer in pork, roe deer meat, and 12 meat samples whose roe deer content was not disclosed. Performance characteristics included amplification efficiency, level of detection (LOD95%), repeatability, reproducibility, and accuracy of quantitative results. With a relative reproducibility standard deviation ranging from 13.35 to 25.08% (after outlier removal) and recoveries ranging from 84.4 to 114.3%, the real-time PCR assay was found to be applicable for the detection and quantification of roe deer in raw meat samples to detect food adulteration.
Since March 2024, H5N1 highly pathogenic avian influenza (HPAI) has been detected in U.S. dairy cattle. Infectious virus shed in unpasteurized milk, a matrix not previously evaluated for H5N1 detection, makes real-time reverse transcription quantitative polymerase chain reaction (rRT-qPCR) assays critical for animal diagnostics and food safety through screening and early detection of milk samples. This interlaboratory comparison exercise evaluated the performance of PCR-based H5N1 assays across 45 participants from government, academic, and commercial laboratories using blinded milk samples spiked with an inactivated H5N1 virus culture at concentrations ranging from 85 to 170,000 genome copies/100 μL. Participants tested samples using their routine protocols. The rate of detection (ROD), Ct values, and levels of detection where 50% of the samples yielded a positive result (LOD50) were analyzed with methods grouped by extraction and PCR kit combinations for sensitivity comparison. For high-concentration samples (17,000 and 170,000 copies/100 μL), ROD was ≥99%; however, detection decreased significantly at lower concentrations, with only 34% of participants reliably detecting samples at 1,700 copies/100 μL and 24% at 85 copies/100 μL. Eight distinct method types were used by participants, with some methods consistently detecting low levels of virus, and others having a 0% detection rate at low copy levels. This study reveals substantial variability in H5N1 detection capabilities across laboratories, with method selection impacting sensitivity. This finding has important implications for human and animal health surveillance and emergency response, highlighting the need for evaluation of protocols and quality control measures for H5N1 testing in milk.
Outlier testing and elimination can be avoided via application of robust estimators. Amongst robust estimators, the Q/Hampel method displays the best performance (in terms of breakdown point and efficiency). While the formulas and correction factors for Q/Hampel in the case of the design with two variance components (e.g. within- and between-laboratory variance) have already been made available, corresponding formulas for other designs have not. A case in point is the staggered-nested design, which is a highly efficient design for e.g. the estimation of intermediate precision in method validation studies. Accordingly, the formulas and correction factors for the use of Q/Hampel in the staggered-nested design are provided here.
Non-targeted methods (NTMs) using matrix-assisted laser desorption/ionization time-of-flight mass spectrometry (MALDI-TOF MS) show promise in bacterial resistance detection, yet temporal variations in spectral features pose significant challenges. These proteomic patterns, which characterize bacterial phenotypes and pathological functions, may vary over time due to bacterial adaptation, virulence, or resistance mechanisms, resulting in large prediction uncertainties and potentially degrading NTM performance. We present a comprehensive screening method to detect temporal changes in MALDI-TOF spectral patterns, demonstrated using methicillin-resistant and -susceptible Staphylococcus aureus (MRSA/MSSA) isolates collected over several years. Our approach combines convolutional neural networks (CNNs) with statistical methods, including significance testing, kernel density estimation, and receiver operating characteristics for dataset shift detection. We employ Gradient-weighted Class Activation Mapping (Grad-CAM) for post hoc feature description, enabling biochemical characterization of temporal changes. This analysis reveals crucial insights into the dynamic relationship between spectral data patterns over time, addressing key challenges in developing robust NTMs for routine applications.