Krzysztof Mazurek

Dr. Krzysztof Mazurek

KOMAG Institute of Mining Technology
orcid

Research Focus & Metrics

Academic Career Length

19Years (2008-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
14 September 2021 in Energies
Verified
Journal Article
Open access
PDF file
Krzysztof MazurekKrzysztof Mazurek
Krzysztof Mazurek
MSMarek Szyguła
Marek Szyguła
AFAndrzej Figiel
Andrzej Figiel
KFKrzysztof Filipowicz
Krzysztof Filipowicz
Opening deeper coal seams requires constructing underground mine roadways in difficult geological conditions. Supporting of such roadways is subjected to a very high load from the rock mass. The types of roof supports used so far do not provide immediate support for the rock mass, which tends to converge the roadway, allowing for a rapid build-up of stresses in the surrounding rock mass. The article presents a new type of frame roadway support. This is a yielding support (consecutive arches are connected in a helical pattern), enabling the successive arches to be provided with initial load-bearing capacity already at the construction stage. The so-called unscrewing of the helix enables the arches to be pressed against the surface of the developed roadway with a controlled force. The introduction discusses the types of yielding roof supports used in the Polish mining industry and indicates their characteristic features. Further along in the article, the assumptions adopted for the construction of models to be tested and assumptions for the static and dynamic load to the models are defined, and the results of the model numerical tests are presented. The tests were aimed at comparing the qualitative behavior of the new roof support and the closed, circular support which is closest to it. The results of numerical tests confirmed the strength of the new solution not lower than the closed (circular) frame support, previously used in the most difficult geological conditions.

1 April 2020 in Journal of Electrical Engineering
Verified
Journal Article
Open access
PDF file
Krzysztof MazurekKrzysztof Mazurek
Krzysztof Mazurek
MSMarek Szyguła
Marek Szyguła
KPKarel Perutka
Karel Perutka
KTKrzysztof Turczyński
Krzysztof Turczyński
KSKrzysztof Stankiewicz
Krzysztof Stankiewicz
The paper presents the concept of installation of an electricity generator and en energy store inside a roller of belt or roller conveyor. Accordingly, the use of a generator-pulley does not require any structural changes to be made to an existing conveyor. In addition, the user will be able to power distributed sensors network for monitoring the operation of the belt conveyor anywhere on its route.

1 June 2008 in Journal of Coal Science and Engineering (China)
Verified
Journal Article
Closed access
PDF file
HGHorst Gondek
Horst Gondek
Krzysztof MazurekKrzysztof Mazurek
Krzysztof Mazurek
SSStanisław Szweda
Stanisław Szweda

26 April 2019 in IOP Conference Series: Earth and Environmental Science
Verified
Conference Paper
Open access
PDF file
Krzysztof MazurekKrzysztof Mazurek
Krzysztof Mazurek
Using the gas accumulator is one of the methods for protection of hydraulic leg against dynamic load caused by bumps. The structure of numerical model of the hydraulic leg with gas accumulator, intended for computer simulations aiding the selection of technical parameters of gas accumulator, is presented. It is used to protect hydraulic leg against dynamic overload. Features of the method for modelling the interactions between solid and fluid, used in dedicated MSC.Dytran software tools are discussed. Mathematical model of the leg with gas accumulator was validated by comparison with the stand test measurements. Impact of gas accumulator on pressure in working area at set external load is given.