Laura Myltykbayeva

Dr. Laura Myltykbayeva

orcid

Research Focus & Metrics

Academic Career Length

12Years (2015-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
1 June 2019 in Theoretical and Experimental Chemistry
Verified
Journal Article
Closed access
PDF file
KDK. Dossumov
K. Dossumov
GEGaukhar Ergazieva
Gaukhar Ergazieva
LMLaura Myltykbayeva
Laura Myltykbayeva
MTM. M. Telbaeva
M. M. Telbaeva
ABA. T. Batyrbaev
A. T. Batyrbaev

1 May 2016 in Theoretical and Experimental Chemistry
Verified
Journal Article
Closed access
PDF file
KDK. Dossumov
K. Dossumov
GEGaukhar Ergazieva
Gaukhar Ergazieva
LMLaura Myltykbayeva
Laura Myltykbayeva
NAN. A. Asanov
N. A. Asanov

10 September 2019 in Chemical Papers
Verified
Journal Article
Closed access
PDF file
KDK. Dossumov
K. Dossumov
GEGaukhar Ergazieva
Gaukhar Ergazieva
BEB. T. Ermagambet
B. T. Ermagambet
MAMoldir Anissova
Moldir Anissova
MMManshuk Mambetova
Manshuk Mambetova
ZKZh. M. Kassenova
Zh. M. Kassenova

1 May 2015 in Coke and Chemistry
Verified
Journal Article
Closed access
PDF file
KDK. Dossumov
K. Dossumov
GEGaukhar Ergazieva
Gaukhar Ergazieva
LMLaura Myltykbayeva
Laura Myltykbayeva
USU. Suyunbayev
U. Suyunbayev
NAN. A. Asanov
N. A. Asanov
AGA. M. Gyulmaliev
A. M. Gyulmaliev
The effect of modifying additives of copper, neodymium and molybdenum on acidity and dispersity of nickel catalyst is studied by temperature-programmed desorption of ammonia and scanning electron microscopy. The activity of these catalysts in the reaction of partial oxidation of methane (POM) and dry reforming of methane (DRM) are measured. The greatest activity is observed for the catalysts NiCuNdMo/Al2O3HZSM-5. The introduction of molybdenum into the NiCuNd/Al2O3HZSM-5 catalyst increases the total acidity of the catalyst from 26.71 × 10−4 to 29.46 × 10−4 mol/gKt, and also it increases the dispersion of the active phases of the catalysts surface. This data of change positively affects the activity of the catalyst in POM reaction, concentration of hydrogen in the reaction product compared with NiCuNd/Al2O3HZSM-5 increases from 60 to 70 vol %. In the range 650–900 °C the equilibrium yield of H2 and CO is observed in the conversion of methane by carbon dioxide over the NiCuNdMo/Al2O3HZSM-5 catalyst. In the oxidation of methane by oxygen the main products is hydrogen, whereas synthesis gas is formed in the conversion of methane by carbon dioxide.

30 May 2018 in Eurasian Chemico-Technological Journal
Verified
Journal Article
Open access
KDK. Dossumov
K. Dossumov
GEGaukhar Ergazieva
Gaukhar Ergazieva
LMLaura Myltykbayeva
Laura Myltykbayeva
MAMoldir Anissova
Moldir Anissova
The catalytic activity of carriers: θ‒Al2O3, γ‒Al2O3, 5A, 4A, 3A and 13X and the oxides of metals of variable valency ‒ NiO, La2O3, CuO, MoO3, MgO, V2O5, WO3, CoO, Cr2O3, ZnO, ZrO2, CeO2, Fe2O3, supported on the effective carrier γ‒Al2O3 by the method of capillary impregnation of the support with solutions of nitric salts of metals were investigated in the process of carbon dioxide conversion of methane (DRM). The optimal technological regimes for the process were: the reaction temperature -800 °C, the space velocity of the initial reactants ‒ 1500 h-1 with a methane to carbon dioxide ratio equal to 1. It was found that among the studied catalysts the highest activity is shown by the NiO/γ‒Al2O3 catalyst, where the yields of hydrogen and carbon monoxide reaches 45.4 and 42.4% by volume, respectively, when methane conversion is 89%. The XRF method showed that the content of alumina and nickel oxide after the reaction remained unchanged at 96.7 and 3.0%, respectively. Scanning electron microscopy (SEM), transmission electron microscopy (TEM), small angle X-ray scattering (XRS) determined that nickel-containing NiO/γ‒Al2O3 catalyst form nickel nanoparticles (6.4‒10 and 50‒150 nm) and a uniform their distribution on the surface of the carrier takes place. These physical chemical characteristics have a positive effect on the activity of NiO/γ‒Al2O3 catalyst in the process of carbon dioxide conversion of methane to synthesis gas.

20 January 2016 in Eurasian Chemico-Technological Journal
Verified
Journal Article
Open access
PDF file
KDK. Dossumov
K. Dossumov
HKHideki Kurokawa
Hideki Kurokawa
YYY. G. Yergaziyeva
Y. G. Yergaziyeva
LMLaura Myltykbayeva
Laura Myltykbayeva
STS. Zh. Tayrabekova
S. Zh. Tayrabekova
Nickel catalysts supported on different carriers (θ-Al2O3, γ-Al2O3, HZSM-5 with γ-Al2O3, HZSM-5, and NaX) have been investigated for the partial oxidation of methane. All the supported nickel catalysts showed a high activity for the formation of synthesis gas, and γ-Al2O3 was the most effective among all the tested carriers.The effect of the heat-treatment temperature of the 3 wt.% Ni/γ-Al2O3 catalyst on its catalytic activity was studied, and a considerable decrease in its activity was observed by the heat-treatment of the catalyst at 1000 °C compared with the catalysts prepared by the 300–800 °C – calcination. The XRD analysis suggested the formation of NiAl2O4 that is a non-reducible compound at the high calcination temperature. The addition of a modifier (Co, Ce, or La) to the 3 wt.% Ni/γ-Al2O3 catalyst increased the selectivity to H2 and CO with the decreasing selectivity to CO2, and the highest selectivity to H2 was obtained by the 5 wt.% NiLa/γ-Al2O3. The developed 5 wt.% NiLa/γ-Al2O3 catalyst showed a high stability for 30 h for the partial oxidation of methane at 750 °C. The methane conversion reached 95%, selectivity to hydrogen 83% and 52% to carbon monoxide.