Enhancing the through-flow capability of the turbine facilitates the potential to decrease the external dimension of the engine, leading to a reduction in weight and an increase in the thrust-to-weight ratio. The optimization of blade profile in terms of aerodynamic design is an essential strategy to improve the overall performance of the high through-flow design turbine. This study aims to develop an automated optimization technique, utilizing the response surface method (RSM), to enable reliable prediction and rapid optimization of aerodynamic performance. A parametric modeling method is devised to generate blade profiles with continuous curvature throughout the automated optimization process. The Box–Behnken experimental design, in combination with Reynolds-averaged Navier–Stokes numerical calculation, is employed to construct a second-order polynomial RSM approximation model. The optimization process comprises two levels: improving the through-flow capability and reducing blade profile loss. The optimized profile, Opt1, achieves a substantial 13.19% improvement in through-flow capability at the cost of a 12.27% increase in blade profile loss. Thus, further optimization is performed to minimize blade profile loss based on the Opt1 scheme. Geometric constraints are applied to the most influential parameters affecting through-flow capability to mitigate their impacts. Compared to the Opt1, the final optimized profile, Opt2, achieves a substantial 31.83% decrease in blade profile loss with a negligible sacrifice of 0.23% in through-flow capability.
Blade tip leakage is responsible for reducing the aerodynamic performance and increasing the thermal load. In order to obtain better cooling efficiency, the thermodynamic performance of different film hole arrangements and blowing ratios have been compared and analyzed in a cavity tip structure. Reynolds-averaged Navier–Stokes equation simulations at five blowing ratios from 0.25 to 2.0 have been carried out for three stream-wise and four pitch-wise film hole arrangements. Based on the reference flow field of the cavity without any coolant, the mechanism of the cooling air influence is analyzed by investigating the flow structure and the vortex development in the tip region. It is found that in the stream-wise arrangements and pitch-wise arrangements, the scheme SW1, in which the film holes are arranged along the suction surface, and the scheme PW2, in which the air film holes are arranged at 0.2 times the axial position, provide the maximum average film cooling efficiency of 0.235 and 0.282, respectively. However, the effective cooling area of SW1 is greater than that of PW2, which are 39.2% and 41.3%, respectively. At the lower blowing ratios, the cooling efficiency increases with the increase in the blowing ratio; however, at the higher blowing ratios, the cooling effect is affected by the clearance size and cavity depth when the coolant impinges on the casing wall.
4 August 2017 in Proceedings of the Institution of Mechanical Engineers, Part G: Journal of Aerospace Engineering
In this paper, the synergistic effect between compound lean and aspiration on the aerodynamic performance of compressor cascades is discussed. Preliminary experimental data verify the accuracy of the computational fluid dynamics method adopted, and a thorough study on reciprocal effect among lean angle, aspirated flow fraction and aspiration streamwise location is conducted. The calculations show that, due to the shorter streamwise length of the re-grown boundary layer against adverse pressure gradient, the aspiration location located farther downstream from the leading edge can minimize the loss of the blade passage flow. With the application of blade lean, which is similar to the flow control mechanism in the unaspirated cascades, an increase in pressure at the suction surface corner is used to migrate the low momentum fluid from the corners towards the midspan of the suction surface. Meanwhile, the reduced aspirated flow velocity and the improved favorable pressure gradient in the lean anterior plenum can reduce the entropy rise through the plenum. Simultaneously, the suction power required in the blade passage flow is reduced with blade lean, while the suction power for the aspirated flow through the plenum shows the opposite trend.