Lizbeth Liliana Díaz-Muñoz

Dr. Lizbeth Liliana Díaz-Muñoz

orcid

Research Focus & Metrics

Academic Career Length

5Years (2022-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
1 January 2022 in International Journal of Chemical Engineering
Verified
Journal Article
Open access
PDF file
Lizbeth Liliana Díaz-MuñozLizbeth Liliana Díaz-Muñoz
Lizbeth Liliana Díaz-Muñoz
Hilda Elizabeth Reynel-ÁvilaHilda Elizabeth Reynel-Ávila
Hilda Elizabeth Reynel-Ávila
DCDidilia Ileana Mendoza Castillo
Didilia Ileana Mendoza Castillo
Adrian Bonilla-PetricioletAdrian Bonilla-Petriciolet
Adrian Bonilla-Petriciolet
JJJuan Carlos Jauregui
Juan Carlos Jauregui
This paper reports the preparation, evaluation, and comparison of alkaline and acidic heterogeneous carbon‐based catalysts in the transesterification of safflower oil with methanol to obtain biodiesel. These catalysts were obtained from the pyrolysis of flamboyant pods and their functionalization and activation with potassium hydroxide, citric acid, tartaric acid, sulfuric acid, and calcium nitrate. Different routes for the preparation of these catalysts were tested and analyzed where the FAME formation was the target variable to be improved. Results showed that the catalyst prepared with potassium hydroxide and calcium nitrate achieved the highest FAME formation (i.e., 95%) and outperformed the catalysts prepared with calcium nitrate and other acids even after four regeneration‐reaction cycles. The best properties of an alkaline catalyst could be associated with its specific surface area and contents of potassium and calcium moieties, which were higher than those observed for acidic catalysts. Transesterification rates for biodiesel production were better estimated with the pseudo‐order kinetic model, which ranged from 0.0004 to 0.038 L/mol⋅min for alkaline and acidic catalysts.

22 January 2025 in Molecules
Verified
Journal Article
Open access
PDF file
DCDaniel Eduardo Cárdenas-Piñeros
Daniel Eduardo Cárdenas-Piñeros
Hilda Elizabeth Reynel-ÁvilaHilda Elizabeth Reynel-Ávila
Hilda Elizabeth Reynel-Ávila
Lizbeth Liliana Díaz-MuñozLizbeth Liliana Díaz-Muñoz
Lizbeth Liliana Díaz-Muñoz
Adrian Bonilla-PetricioletAdrian Bonilla-Petriciolet
Adrian Bonilla-Petriciolet
Carlos Durán-ValleCarlos Durán-Valle
Carlos Durán-Valle
MAMarta Adame-Pereira
Marta Adame-Pereira
Biodiesel produced via oil transesterification often contains metallic impurities, such as copper, which affects its quality and engine performance. This study explores the use of activated carbon prepared from spent coffee grounds to remove copper from biodiesel. Activated carbon samples were prepared via biomass pyrolysis and chemical activation with KOH and HNO3. The optimal conditions for copper adsorption were determined using a Taguchi L9 design. Maximum adsorption capacities were 13.4 and 17.3 mg/g at 30 and 40 °C, respectively, in batch adsorbers. In packed-bed columns, the axial dispersion reduced the adsorption efficiency obtaining bed adsorption capacities from 1.9 to 5.1 mg/g under tested experimental conditions. Adsorbent characterization and adsorption modeling indicated that copper removal was driven by multi-cationic interactions, where carboxylic groups from carbon surface acted as key active sites. The new adsorbent outperformed commercial bone char, making it a cost-effective alternative to improve biodiesel production contributing to the energy matrix diversification.

20 August 2025 in Molecules
Verified
Journal Article
Open access
PDF file
Hilda Elizabeth Reynel-ÁvilaHilda Elizabeth Reynel-Ávila
Hilda Elizabeth Reynel-Ávila
ELEduardo Ledea-Figueredo
Eduardo Ledea-Figueredo
Lizbeth Liliana Díaz-MuñozLizbeth Liliana Díaz-Muñoz
Lizbeth Liliana Díaz-Muñoz
Adrian Bonilla-PetricioletAdrian Bonilla-Petriciolet
Adrian Bonilla-Petriciolet
ismael alejandro aguayo villarrealismael alejandro aguayo villarreal
ismael alejandro aguayo villarreal
Carlos Durán-ValleCarlos Durán-Valle
Carlos Durán-Valle
This study reports the separation of methyl ethyl ketone (MEK), a relevant compound in the biorefinery context, from aqueous solutions using activated carbons derived from avocado seed biomass. Two synthesis routes were explored via chemical and thermal activation with H2SO4 and KOH. A Taguchi experimental design was applied to tailor synthesis conditions, with MEK adsorption capacity as the target property. Adsorption kinetics and isotherms were evaluated to determine the thermodynamic behavior of MEK separation using the best-performing activated carbons. The carbon activated with H2SO4 achieved the highest adsorption capacity (142 mg g−1) at 20 °C and pH 4, surpassing KOH-based materials. This enhanced performance correlated to increased surface area and acidic oxygenated functionalities. However, higher pH and temperature reduced the adsorption efficiency for all adsorbents. Comprehensive characterization was performed using XRD, XRF, FTIR, SEM, N2 adsorption–desorption isotherms, pH at point of zero charge, and surface acidity/basicity analysis via Boehm titration. Thermodynamic data and surface characterization indicated that MEK adsorption occurs via a double-layer mechanism dominated by electrostatic interactions and hydrogen bonding. The findings highlight an optimized approach for tailoring avocado-based activated carbons to efficiently recover MEK from aqueous media, supporting its potential application in downstream purification of fermentation broths for biofuel production and energy transition processes.

14 July 2025 in Technologies
Verified
Journal Article
Open access
PDF file
Javier Emanuel Castañeda AudeJavier Emanuel Castañeda Aude
Javier Emanuel Castañeda Aude
ECEnrique Díaz Barriga Castro
Enrique Díaz Barriga Castro
Lizbeth Liliana Díaz-MuñozLizbeth Liliana Díaz-Muñoz
Lizbeth Liliana Díaz-Muñoz
JGJavier Alberto Garza-Cervantes
Javier Alberto Garza-Cervantes
José Rodríguez-MirasolJosé Rodríguez-Mirasol
José Rodríguez-Mirasol
CGCarlos Enrique Escárcega González
Carlos Enrique Escárcega González
This research presents a novel, sustainable, and eco-friendly method for the rapid green synthesis of nanoparticles with antibacterial properties. This method employs steam distillation to extract reducing and stabilizing agents from orange peel waste, followed by ultrasound-assisted synthesis. To the best of our knowledge, this is the first reported integration of these two techniques for nanoparticle production. The extracted materials were then subjected to rigorous characterization through a combination of analytical techniques, including FTIR, HPLC, and TEM. These analytical approaches enabled a comprehensive analysis of the synthesized NPs, revealing their size distribution within the range of 1.5 to 14 nm. Among the synthesized nanomaterials, AgNPs exhibited the most potent antibacterial activity, with statistically significant minimum inhibitory concentrations (MICs) of 16 ppm for E. coli ATCC and 32 ppm for resistant E. coli and E. faecalis strains. This study underscored the promise of valorizing citrus waste for nanomaterial synthesis and introduced a novel, scalable methodology for producing bioactive nanoparticles, promoting a more sustainable technology for this purpose. Notably, this research aligns with United Nations Sustainable Development Goal 12, which promotes responsible consumption and production by transforming organic waste into high-value functional nanomaterials for biomedical and environmental applications.