Adding nucleating agents (NAs) is one of the most efficient ways to obtain improved mechanical, optical, and thermal properties of isotactic polypropylene (iPP). While it is well appreciated that electrical property is critically affected by crystalline modification, the role between them remains unclear. Here, we address this issue by incorporating commercial α-NA and β-NA into iPP, both of which exhibit strong nucleation ability, e.g., reducing the size of crystalline agglomerates from 45.3 μm (Pure-iPP) to 2.5 μm (α-iPP) and 7.6 μm (β-iPP), respectively. Mechanical testing results show that while β-modification decreases the tensile strength a little, it does enhance the elongation at break (200%) and toughness (25.3% higher), relative to its unfilled counterparts. Moreover, a well-dispersed β-iPP system obtains a comprehensive improvement of electrical properties, including dielectric breakdown strength, space charge suppression, and internal field distortion under a high external field (−100 kV/mm) due to newly-generated deep charge trapping sites. This crystalline modification strategy is attractive for future development of many engineering insulating polymers.
Despite similar material composition and insulation application, the alternating current (AC) cross-linked polyethylene (XLPE) and direct current (DC) XLPE materials cannot replace each other due to different voltage forms. Herein, this work presents a systematical investigation into the effects of thermal aging on the material composition and properties of 500 kV-level commercial AC XLPE and DC XLPE materials. A higher content of antioxidants in the AC XLPE than in the DC XLPE was experimentally demonstrated via thermal analysis technologies, such as oxidation-induced time and oxidation-induced temperature. Retarded thermal oxidation and suppression of space charge effects were observed in thermally aged AC XLPE samples. On the other hand, the carbonyl index of DC XLPE dramatically rose when thermal aging was up to 168 h. The newly generated oxygen-containing groups provided deep trapping sites (~0.95 eV) for space charges and caused severe electric field distortion (120%) under −50 kV/mm at room temperature in the aged DC XLPE samples. For the unaged XLPE materials, the positive space charge packets were attributed to the residue crosslinking byproducts, even after being treated in vacuum at 70 °C for 24 h. Thus, it was reasoned that the DC XLPE material had a lower crosslinking degree to guarantee fewer crosslinking byproducts. This work offers a simple but accurate method for evaluating thermal oxidation resistance and space charge properties crucial for developing high-performance HVDC cable insulation materials.
The insulation property at high voltage frequencies has become a tough challenge with the rapid development of high-voltage and high-frequency power electronics. In this paper, the electrical treeing behavior of silicone rubber (SIR) is examined and determined at various voltage frequencies, ranging from 50 Hz to 130 kHz. The results show that the initiation voltage of electrical trees decreased by 27.9% monotonically, and they became denser when the voltage frequency increased. A bubble-shaped deterioration phenomenon was observed when the voltage frequency exceeded 100 kHz. We analyze the typical treeing growth pattern at 50 Hz (including pine-like treeing growth and bush-like treeing growth) and the bubble-growing pattern at 130 kHz. Bubbles grew exponentially within several seconds. Moreover, bubble cavities were detected in electrical tree channels at 50 Hz. Combined with the bubble-growing characteristics at 130 kHz, a potential growing model for electrical trees and bubbles in SIR is proposed to explain the growing patterns at various voltage frequencies.