An environmentally friendly hydrogel based on gelatin has been investigated as a gel polymer electrolyte in a symmetric carbon-based supercapacitor. To guarantee the complete sustainability of the devices, biomaterials from renewable resources (such as chitosan, casein and carboxymethyl cellulose) and activated carbon (from coconut shells) have been used as a binder and filler within the electrode, respectively. The electrochemical properties of the devices have been compared by using cyclic voltammetry, galvanostatic charge/discharge curves and impedance spectroscopy. Compared to the liquid electrolyte, the hydrogel supercapacitors show similar energy performance with an enhancement of stability up to 12,000 cycles (e.g., chitosan as a binder). The most performant device can deliver ca. 5.2 Wh/kg of energy at a high power density of 1256 W/kg. A correlation between the electrochemical performances and charge storage mechanisms (involving faradaic and non-faradaic processes) at the interface electrode/hydrogel has been discussed.

A five-layer (5L) graphene on a glass substrate has been demonstrated as a transparent conductive electrode to replace indium tin oxide (ITO) in organic photovoltaic devices. The required low sheet resistance, while maintaining high transparency, and the need of a wettable surface are the main issues. To overcome these, two strategies have been applied: (i) the p-doping of the multilayer graphene, thus reaching 25 Ω □⁻¹ or (ii) the O₂-plasma oxidation of the last layer of the 5L graphene that results in a contact angle of 58° and a sheet resistance of 134 Ω □⁻¹. A Nd:YVO₄ laser patterning has been implemented to realize the desired layout of graphene through an easy and scalable way. Inverted Polymer Solar Cells (PSCs) have been fabricated onto the patterned and modified graphene. The use of PEDOT:PSS has facilitated the deposition of the electron transport layer and a non-chlorinated solvent (ortho-xylene) has been used in the processing of the active layer. It has been found that the two distinct functionalization strategies of graphene have beneficial effects on the overall performance of the devices, leading to an efficiency of 4.2%. Notably, this performance has been achieved with an active area of 10 mm², the largest area reported in the literature for graphene-based inverted PSCs.

Environmentally friendly energy storage devices have been fabricated by using functional materials obtained from completely renewable resources. Gelatin, chitosan, casein, guar gum and carboxymethyl cellulose have been investigated as sustainable and low-cost binders within the electrode active material of water-processable symmetric carbon-based supercapacitors. Such binders are selected from natural-derived materials and industrial by-products to obtain economic and environmental benefits. The electrochemical properties of the devices based on the different binders are compared by using cyclic voltammetry, galvanostatic charge/discharge curves and impedance spectroscopy. The fabricated supercapacitors exhibit series resistance lower than a few ohms and values of the specific capacitance ranged between 30 F/g and 80 F/g. The most performant device can deliver ca. 3.6 Wh/kg of energy at a high power density of 3925 W/kg. Gelatin, casein and carboxymethyl cellulose-based devices have shown device stability up to 1000 cycles. Detailed analysis on the charge storage mechanisms (e.g., involving faradaic and non-faradaic processes) at the electrode/electrolyte interface reveals a pseudocapacitance behavior within the supercapacitors. A clear correlation between the electrochemical performances (e.g., cycle stability, capacitance retention, series resistance value, coulombic efficiency) ageing phenomena and charge storage mechanisms within the porous carbon-based electrode have been discussed.