Samples of 316L austenitic stainless steel with bimodal grain size distributions are elaborated using two distinct routes. The first one is based on powder metallurgy using spark plasma sintering of two powders with different particle sizes. The second route applies the reverse-annealing method: it consists in inducing martensitic phase transformation by plastic strain and further annealing in order to obtain two austenitic grain populations with different sizes. Microstructural analy ses reveal that both methods are suitable to generate significative grain size contrast and to control this contrast according to the elaboration conditions. Mechanical properties under tension are then characterized for different grain size distributions. Crystal plasticity finite element modelling is further applied in a configuration of bimodal distribution to analyse the role played by coarse grains within a matrix of fine grains, considering not only their volume fraction but also their spatial arrangement.
Ultrafine grained (UFG) materials in the bigger grain size range (0.5–1) µm display a good combination of strength and ductility, unlike smaller size UFG and nanostructured metals, which usually exhibit high strength but low ductility. Such difference can be attributed to a change in plasticity mechanisms that modifies their strain hardening capability. The purpose of this work is to investigate the work hardening mechanisms of UFG nickel considering samples with grain sizes ranging from 0.82 to 25 µm. Specimens processed combining ball milling and spark plasma sintering were subjected to monotonous tensile testing up to fracture. Then, microstructural observations of the deformed state of the samples were carried out by electron backscattered diffraction and transmission electron microscopy. A lower strain hardening capability is observed with decreasing grain size. Samples in the submicrometric range display the three characteristic stages of strain hardening with a short second stage and the third stage beginning soon after yielding. Microstructural observations display a low fraction of low angle grain boundaries and dislocation density for the sample with d = 0.82 µm, suggesting changes in plasticity mechanisms early in the UFG range.
Powder metallurgy is a good option when coupled with pressure as a method to obtain nanostructured materials (NsM). The samples obtained by these means are nearly fully dense specimens that present low internal stresses. In this work, nickel is chosen to study the possibilities of nanostructuration via Spark Plasma Sintering (SPS) of ball-milled powders. The enhancement of the mechanical properties of the sintered samples are studied and compared with the results obtained for 316L austenitic stainless steel in a previous work.
30 April 2020 in Metallurgical and Materials Transactions A