Oilseed cakes are produced as a by-product of oil pressing and are mostly used as feed. Their use for human consumption is due to the functional properties and benefits for human health. Herein, oilseed cake flours of eight species (flax, hemp, milk thistle, poppy, pumpkin, rapeseed, safflower, sunflower) were sieved into fractions above (A250) and below (B250) 250 µm. The chemical composition, SDS-PAGE profiles, colour, functional properties and antioxidant activities of these flours were evaluated. The B250 fractions were evaluated as being protein and ash rich, reaching crude protein and ash content ranging from 31.78% (milk thistle) to 57.47% (pumpkin) and from 5.0% (flax) to 11.19% (poppy), respectively. A high content of carbohydrates was found in the flours of hemp, milk thistle and safflower with a significant increase for the A250 fraction, with a subsequent relation to a high water holding capacity (WHC) for the A250 fraction (flax, poppy, pumpkin and sunflower). The A250 milk thistle flour was found to have the richest in polyphenols content (TPC) (40.89 mg GAE/g), with the highest antioxidant activity using an ABTS•+ assay (101.95 mg AAE/g). The A250 fraction for all the species exhibited lower lightness than the B250 fraction. The obtained results indicate that sieving oilseed flour with the aim to prepare flours with specific functional characteristics and composition is efficient only in combination with a particular species.

Soybean is a valuable protein and oilseed crop ranked among the most significant of the major crops. Field experiments were carried out in 2016–2019 in South-East Poland. The influence of soybean cultivars (Aldana, Annushka), nitrogen fertilizer (0, 30, 60 kg∙ha⁻¹ N) and inoculation with B. japonicum (control, HiStick^® Soy, Nitragina) on the content of fatty acids (FA) in soybean seeds was investigated in a three-factorial experiment. This study confirms the genetic determinants of fatty acid composition in soybean seeds and their differential accumulation levels for C16:0, C16:1, C18:1n9, C18:2, C18:3, and C20:0 as well saturated (SFA), monounsaturated (MUFA), and polyunsaturated (PUFA) fatty acids. Increasing the rate from 30 to 60 kg ha⁻¹ N did not produce the expected changes, suggesting the use of only a “starter” rate of 30 kg ha⁻¹ N. Inoculation of soybean seeds with a strain of Bradyrhizobium japonicum (HiStick^® Soy, BASF, Littlehampton, UK and Nitragina, Institute of Soil Science and Plant Cultivation–State Research Institute, Puławy, Poland) is recommended as it will cause a decrease in SFA and C16:0 acid levels. This is considered nutritionally beneficial as its contribution to total fatty acids determines the hypercholesterolemic index, and it is the third most accumulated fatty acid in soybean seeds. The interaction of cultivars and inoculation formulation on fatty acid content of soybean seeds was demonstrated. An increase in the value of C16:0 content resulted in a decrease in the accumulation of C18:1, C18:2, and C18:3 acids. The content of each decreased by almost one unit for every 1% increase in C16:0 content. The dominant effect of weather conditions on the FA profile and C18:2n6/C18:3n3 ratio was demonstrated. This suggests a need for further evaluation of the genetic progress of soybean cultivars with respect to fatty acid composition and content under varying habitat conditions.

Soybean is a thermophilic and photophilic plant very sensitive to weather course during the vegetation period. This trait limits soybean cultivation in higher latitude countries. This field study aimed to evaluate the effects of three sowing dates on the development, the duration of vegetative and generative stages, and the yield of two soybean cultivars (Lissabon and Merlin) under conditions in south-western Poland in the years 2016–2019. The sowing date determines the temperature and the day length available for soybean plants, influencing development and yield. Delaying the sowing date by 20 days in relation to the earliest (16–21.04) resulted in the shortening of the length of the vegetative development by 12 days and the shortening of the entire vegetation period by 14 days. The delayed sowing date (06–19.05) under the conditions of south-western Poland (Lower Silesia) contributed to a significant decrease in yield. Lissabon produced greater soybean yield than Merlin. Special attention should be paid to proper seed sowing dates in soybean agriculture practice. It is necessary to breed soybean genotypes adapted to day length and thermal conditions of the cultivation area to achieve the maximum seed yield.

A two-factorial field experiment with soybean (Glycine max(L.) Merill) was conducted in a randomized block design, with four replications. The tested factors were seed priming method and genotype responses. There had been seven soybean varieties (Aldana, Aligator, Annushka, Augusta, Lissabon, Mavka, and Merlin) and each of them had control (unprimed) and seed primed groups. The aim of this study was to determine the effect of hydropriming on germination ability and emergence under field conditions, on the growth and development of selected soybean varieties. Shortly before harvest, 10 randomly selected plants were collected from each plot, and their morphological and yield-related traits were measured. In addition, the seed yield was assessed. On the basis of statistical analysis, significant differences were found between the applied hydropriming method and the control group in regard to morphological traits. Seed treatment resulted in a slight increase in harvested seed yield, which is within error margin. The seed yield of Aligator increased significantly by 0.5 t ha⁻¹, indicating a genotype-specific different reaction to seed priming in terms of yield.