Natural convection in a steady state of incompressible air inside a cavity’s porous with a heated low wall of a sinusoidal profile is investigated numerically in this paper. The upper horizontal wall is kept cold while the two sides are thermally insulated. The proposed physical model was developed and studied with two-dimensional conditions, using the finite element method and adapting the Darcy-Brinkman model. This paper examines the laminar natural convection in a square porous cavity for different Rayleigh numbers (10 ≤ Ra ≤ 104), aspect ratios (0.25 ≤ AR ≤ 1.0), and sinusoidal temperature amplitude (0.25 ≤ λ ≤ 1.0). Moreover, the variation effect of Ra, AR, and λ on isotherms, streamlines, and the mean and local Nusselt numbers has been presented and analyzed. The results showed that an increase in the sinusoidal thermal amplitude, mean Nusselt number, and AR reduced somewhat the Rayleigh number. This provided a solution in which the mean Nusselt number increased by increasing the sinusoidal thermal amplitude and the Rayleigh number. On the other hand, it decreases slightly by increasing the AR. In addition, the convection transfer mechanism is the main mode when the Rayleigh number is high. Thus, it was found that the Darcy number also has an effect on heat transmission. The obtained results were compared with those found in the literature and were found to be in good accordance.
30 December 2017 in International Journal of Heat and Technology
The impact of aspect ratio and nonuniform temperature on mixed convection in an enclosure is examined numerically. The chosen shape is an enclosure with a sinusoidal temperature TH in its lower wall, while the upper wall is considered adiabatic. The sidewalls of the cavity move at a descending speed with a uniform temperature TC. The inspection is performed for different Richardson numbers and aspect ratios (AR) varying from 0.25 to 5, while the numbers of Prandtl (Pr = 0.71) and Grashof (Gr = 104) remain constant. The isothermal, streamline, and Nusselt numbers flow distributions inside the cavity are highlighted and discussed. Compared to uniform heating, significant changes in the flow rate are observed when receiving nonuniform heating on the lowest cavity surface. Two cells of flow rotating in opposing directions are formed inside the cavity when the cavity aspect ratio AR = 0.25. When the cavity aspect ratio becomes higher than the unity, these cells change with the development of Ri; they take an oval form and move to the heated side. The non-uniform heating yielded a sinusoidal localized thermal exchange rate with the lowest amounts at the edges and considerable amounts at the bottom center (Ri = 1 and 100).