This study employed Taguchi-Grey relational analysis to optimize the influences of binder content, the molarity of sodium hydroxide (SH) solution, alkaline solution to binder content (Al/Bi) ratio, water to alkali-activated solids (W/S) ratio, and sodium silicate to sodium hydroxide solution (SS/SH) ratio on the workability, setting time, and compressive strength of alkali-activated slag-based concrete (AASC). Then, the recycled tire steel fibers (RTSF) were introduced into the optimized mixture in different dosages, and the physical and mechanical properties of fiber-reinforced AASC (FR-AASC) were evaluated. RTSF inclusion negatively affected the workability and increased the density while slightly reducing the water absorption. Additionally, the compressive strength and flexural behavior of FR-AASC improved by increasing the RTSF content. The analysis of images taken from flexural specimens through the Digital Image Correlation technique (DIC) revealed that higher RTSF dosage caused a curved macro crack with several branches alongside, leading to a better post-cracking performance in terms of strength and toughness.
Despite offering several benefits in terms of environment and economics, few studies were conducted on the ground granulated blast furnace slag (GGBFS) based alkali‐activated concrete reinforced with recycled tire steel fibers (RTSFs). Therefore, this paper employed the Taguchi method to investigate and optimize the influence of GGBFS content, the alkaline solution to GGBFS content ratio, sodium hydroxide solution concentration, and RTSF volume fraction on splitting tensile strength (STS) of recycled tire steel fiber‐reinforced alkali‐activated slag concrete (RTSFR‐AASC). The microstructural evaluation was done through scanning electron microscopy, and Fourier transform infrared spectroscopy (FTIR) analyses. The results indicated that the fiber content, the most efficient parameter on STS, led to a considerable enhancement in the performance characteristic. Microstructural analysis proved the variations in formation of C–S–H gel. The results of the confirmation experiment on the proposed optimized RTSFR‐AASC mixture with the highest 28‐day STS (7.11 MPa) confirmed the effectiveness of the Taguchi method.
18 January 2026 in Journal of Building Engineering
Incorporating steel slag, a residue derived from the metallurgical industry, into cementitious systems offers a sustainable route for resource recovery and carbon footprint reduction. Milling has been reported to address the low cementitious reactivity of steel slag, which remains a significant barrier to its widespread adoption. However, the influence of storage duration after milling on steel slag performance has not been systematically evaluated. To investigate the effects of post-milling duration as an independent factor, two types of steel slag, derived from a basic oxygen furnace and an electric arc furnace processes, were milled using planetary ball milling and stored under controlled environmental conditions for 1 h, 1 day, 4 days, 7 days, 3 months, and 1 year. The results showed that prolonged storage caused significant particle agglomeration, detected by particle size analysis, and a slight reduction in reactivity after 1 year, as determined by the Rapid, Reliable Relevant ( R3 ) reactivity test for supplementary cementitious materials. Replacing 30% of cement with steel slags stored for different times (1 h vs. 1 year) changed the properties of the blends. Compared with freshly milled slag, slag stored for 1 year caused a slight delay in cement hydration, as evidenced by calorimetry results. Consequently, blends containing 1-year-stored slag exhibited prolonged setting times and reduced apparent viscosity compared with the 1-h slag–cement blends. The compressive strength of blended cements was also negatively affected by long-term storage, and the amount of hydration products, such as portlandite, was slightly reduced in 28-day composites containing 1-year-stored slag. Graphical Abstract