Mirta Bensic

Prof. Mirta Bensic

University of Osijek Department of Mathematics, Osijek, Osječko-Baranjska Županija, Croatia
orcid

Research Focus & Metrics

Academic Career Length

20Years (2007-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
12 April 2020 in Materials
Verified
Journal Article
Open access
PDF file
RBRobert Bušić
Robert Bušić
MBMirta Bensic
Mirta Bensic
Ivana MiličevićIvana Miličević
Ivana Miličević
KSKristina Strukar
Kristina Strukar
The paper aims to investigate the influence of waste tire rubber and silica fume on the fresh and hardened properties of self-compacting concrete (SCC) and to design multivariate regression models for the prediction of the mechanical properties of self-compacting rubberized concrete (SCRC). For this purpose, 21 concrete mixtures were designed. Crumb rubber derived from end-of-life tires (grain size 0.5–3.5 mm) was replaced fine aggregate by 0%, 5%, 10%, 15%, 20%, 25%, and 30% of total aggregate volume. Silica fume was replaced cement by 0%, 5%, and 10% of the total cement mass. The optimal replacement level of both materials was investigated in relation to the values of the fresh properties and mechanical properties of self-compacting concrete. Tests on fresh and hardened self-compacting concrete were performed according to the relevant European standards. Furthermore, models for predicting the values of the compressive strength, modulus of elasticity, and flexural strength of SCRC were designed and verified with the experimental results of 12 other studies. According to the obtained results, mixtures with up to 15% of recycled rubber and 5% of silica fume, with 28 days compressive strength above 30 MPa, were found to be optimal mixtures for the potential future investigation of reinforced self-compacting rubberized concrete structural elements.

29 February 2020 in Applied Sciences
Verified
Journal Article
Open access
PDF file
LJLidija Jakobek
Lidija Jakobek
PMPetra Matić
Petra Matić
ŠKŠima Kraljević
Šima Kraljević
Šime UkićŠime Ukić
Šime Ukić
MBMirta Bensic
Mirta Bensic
ABAndrew Barron
Andrew Barron
Interactions between polyphenols and fibers are important for polyphenol bioactivities, and have been studied in vitro with adsorption process and isotherms. However, the theoretical interpretations of adsorption potentially can be affected by the method of isotherm modeling. The aim was to study the interactions between β-glucan and quercetin derivatives (quercetin-3-glucoside, quercetin-3-galactoside, quercetin-3-rhamnoside) by studying adsorption, and to potentially improve the modeling of adsorption isotherms. Quercetin derivatives were determined by using spectrophotometric method. Experimental results were modeled with Langmuir, Dubinin-Radushkevich, and Hill isotherms using non-linear regression, linear regression, and improved non-linear regression. For improved non-linear regression, code in the R programming language was developed. All quercetin derivatives adsorbed onto the surface of β-glucan. Improved non-linear regression gave somewhat lower errors and may be the most appropriate for adsorption interpretation. According to isotherms obtained with improved regression, it may be suggested that adsorption is higher for rhamnoside and glucoside of quercetin than for quercetin-3-galactoside which agrees with experimental results. Adsorption could be a physical process. The spatial arrangement of hydroxyl (OH) groups on the glycoside part of quercetin could affect the adsorption. In conclusion, a novel approach using improved non-linear regression has been shown to be a useful, novel tool for adsorption interpretation.

31 July 2009 in Expert Systems with Applications
Verified
Journal Article
Closed access
Nataša ŠarlijaNataša Šarlija
Nataša Šarlija
MBMirta Bensic
Mirta Bensic
MZMarijana Zekic-Susac
Marijana Zekic-Susac

19 June 2020 in Foods
Verified
Journal Article
Open access
PDF file
Veronika Barišić PavičićVeronika Barišić Pavičić
Veronika Barišić Pavičić
IFIvana Flanjak
Ivana Flanjak
MKMirela Kopjar
Mirela Kopjar
MBMirta Bensic
Mirta Bensic
Antun JozinovićAntun Jozinović
Antun Jozinović
DADjurdjica Ačkar
Djurdjica Ačkar
Cocoa shell is a by-product of the chocolate industry that is rich in dietary fiber and bioactive components. In this research, the influence of high voltage electric discharge (HVED) treatment on chemical and physical characteristics of the cocoa shell, i.e., the effects of applied time and frequencies on grinding ability, water binding capacity (WBC), dietary fibers and tannin content was investigated. HVED had a significant influence on the chemical and physical properties of cocoa shell, all of which could be linked to changes in fiber properties. Along with the fiber content, grinding ability and water binding capacity were increased. These properties have already been linked to fiber content and soluble/insoluble fiber ratio. However, this research implies that change in fiber properties could be linked to tannin formation via complexation of other polyphenolic components. Additional research is needed to verify this effect and to establish mechanisms of tannin formation induced by HVED and its influence on fiber quantification.

4 January 2024 in Applied Sciences
Verified
Journal Article
Open access
PDF file
MZMatija Zvonarić
Matija Zvonarić
MBMirta Bensic
Mirta Bensic
IBIvana Barišić
Ivana Barišić
TDTihomir Dokšanović
Tihomir Dokšanović
The high stiffness of cement-bound aggregate (CBA) is recognized as its main drawback. The stiffness is described by the modulus of elasticity, which is difficult to determine precisely in CBA. Incorporating rubber in these mixtures reduces their stiffness, but mathematical models of the influence of rubber on the mechanical characteristics have not previously been defined. The scope of this research was to define a prediction model for the compressive strength (fc), dynamic modulus of elasticity (Edyn) and static modulus of elasticity (Est) based on the measured ultrasonic pulse velocity as a non-destructive test method. The difference between these two modules is based on the measurement method. Within this research, the cement and waste rubber content were varied, and the mechanical properties were determined for three curing periods. The Edyn was measured using the ultrasonic pulse velocity (UPV), while the Est was determined using three-dimensional digital image correlation (3D DIC). The influence of the amount of cement and rubber and the curing period on the UPV was determined. The development of prediction models for estimating the fc and Est of CBA modified with waste rubber based on the non-destructive test results is highlighted as the most significant contribution of this work. The curing period was statistically significant for the prediction of the Est, which points to the development of CBA elastic properties through different stages during the cement-hydration process. By contrast, the curing period was not statistically significant when estimating the fc, resulting in a simplified, practical and usable prediction model.

8 February 2024 in Molecules
Verified
Journal Article
Open access
PDF file
Antun JozinovićAntun Jozinović
Antun Jozinović
JBJelena Panak Balentić
Jelena Panak Balentić
DADjurdjica Ačkar
Djurdjica Ačkar
MBMirta Bensic
Mirta Bensic
Jurislav BabicJurislav Babic
Jurislav Babic
Drago SubaricDrago Subaric
Drago Subaric
This research studies the influence of the addition of defatted press cakes (from the production of hazelnut, camelina, pumpkin, and hemp seed oil) on nutritionally important components: fibre, resistant starch, polyphenols, hydroxymethylfurfural (HMF), and acrylamide in directly and indirectly expanded snacks. The amounts of press cakes added to corn grits were 3, 6, and 9%. Extrusion was carried out in a laboratory single-screw extruder. For indirectly expanded products (SCFX), supercritical CO2 was injected during extrusion, and secondary expansion was completed in the microwave oven. The type and content of press cake, as well as the type of product, significantly influenced total polyphenol content and antioxidant activity. Press cakes increased the contents of both soluble and insoluble fibre (from 1.94% d. m. and 1.28% d. m. for extrudates without press cakes up to 3.17% d. m. and 6.94% d. m. for SCFX extrudates with press cakes, respectively), and resistant starch was not markedly influenced by their addition. The influence of the content of press cake on HMF was not significant, whereas the type of cake and the type of extrusion influenced HMF significantly. In a raw mixture of corn grits with 3% of pumpkin press cake, HMF was below the limit of detection, and the highest content was found in the classically extruded sample with the addition of 9% of camelina press cake (580 ppb). In all samples, the acrylamide content was below the limit of detection, indicating that safe products were obtained. This research shows potential for the implementation of supercritical CO2 extrusion in the production of safe, nutritionally improved snack products. Future research might bring about the design of cost-effective processes applicable in the industry.