Mohamed Aâtach

Mr. Mohamed Aâtach

University of Liège, Liège, Wallonia, Belgium
orcid

Research Focus & Metrics

Academic Career Length

6Years (2021-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
6 December 2022 in Metals
Verified
Journal Article
Open access
PDF file
Arevik VardanyanArevik Vardanyan
Arevik Vardanyan
Narine VardanyanNarine Vardanyan
Narine Vardanyan
MAMohamed Aâtach
Mohamed Aâtach
PMPierre Malavasi
Pierre Malavasi
SGStoyan Gaydardzhiev
Stoyan Gaydardzhiev
The effect of varying process parameters during bio-catalyzed leaching of metals from end-of-life printed circuit boards (PCBs) was investigated. Fragmented PCBs (under 2 mm) were subjected to an indirect bioleaching in a stirred tank reactor while pulp density, pH and initial ferric iron content were varied. An iron oxidizing Acidithiobacillus ferrooxidans 61 microbial strain was used to generate the lixiviant through oxidizing Fe(II) to Fe(III). Chemically generated Fe(III) was tested as lixiviant under the same conditions as the biological one for comparative purposes. Cell enumeration during leaching and microscopic observations of the input and leached PCBs were conducted in parallel to shed light on the observed phenomena. The degree of bringing metals in solution was found to depend mainly on ferric iron concentration and pH. For the entire duration being always kept as 24 h, substantial portion of Cu (~87%) was extracted respectively at 1% pulp density (PD), 15.5 g/L Fe3+ and pH 1. For Zn and Ni, nearly 100% recovery was observed at 5% PD, 18 g/L Fe3+ and pH 1.1. The achieved results offer possibilities for further studies at higher pulp density, to ultimately render the bioleaching approach as enabling economical and environmentally friendly technology for urban mining of non-ferrous metals.

9 December 2021 in Minerals
Verified
Journal Article
Open access
PDF file
ASAlidor Shikika
Alidor Shikika
FZFrançois ZAGABE ZABENE
François ZAGABE ZABENE
MAMuvundja Fabrice Amisi
Muvundja Fabrice Amisi
MMMac Cubaka Mugumaoderha
Mac Cubaka Mugumaoderha
JCJulien L. Colaux
Julien L. Colaux
SGStoyan Gaydardzhiev
Stoyan Gaydardzhiev
A novel approach for Ta and Nb extraction consisting of the pre-treatment of a coltan-bearing ore with an ammonium bifluoride sub-molten salt and subsequent acid leaching has been studied. The effects from ore granulometry, ammonium bifluoride (ABF) to ore mass ratio, temperature and duration of fluorination on the degree of Ta and Nb extraction were examined. The ABF to ore ratio and process temperature were found to have the most pronounced impact on extraction efficiency. The following optimal process conditions were determined: ore granulometric fraction (−75 + 45 µm), ABF-ore (5/1), fluorination temperature (200 °C) and fluorination time (2.5 h). Maintaining these parameters enabled about 94% of Ta and 95% of Nb to be brought into solution during the sulfuric-acid-leaching stage. A comparison of the proposed method with previously reported studies suggests that due to the effects of mechanical agitation and the recirculation of the HF-containing gaseous phase back into the process, the dosage rate of ABF at the fluorination stage could be reduced significantly without sacrificing the overall recovery of Ta and Nb. In such a way, the approach could offer added environmental benefits since release of fluoride-containing effluents into the environment could be limited.

31 May 2024 in Minerals Engineering
Verified
Journal Article
Closed access
MAMohamed Aâtach
Mohamed Aâtach
MSMiguel Antunes Simão
Miguel Antunes Simão
SGStoyan Gaydardzhiev
Stoyan Gaydardzhiev

29 April 2025 in Minerals
Verified
Journal Article
Open access
PDF file
JHJulie Hunt
Julie Hunt
JOJeffrey Oalmann
Jeffrey Oalmann
MAMohamed Aâtach
Mohamed Aâtach
EPEric Pirard
Eric Pirard
RFRussell Fulton
Russell Fulton
SFSandrin Tilman Feig
Sandrin Tilman Feig
Typical greisen-type ore samples from northeastern Tasmania were investigated for their critical metal potential. The samples contain zinnwaldite (KLiFe2+Al(AlSi3O10)(F,OH)2), a lithium-bearing mica that is prone to excessive breakage during conventional processing, leading to the generation of very-fine-sized particles (i.e., slimes, <20 µm), eventually ending up in tailings and resulting in lithium (Li) loss. To assess whether the natural grain size of valuable minerals could be preserved, the samples were processed using electric pulse fragmentation (EPF). The results indicate that EPF preferentially fragmented along mica-rich veins, maintaining coarse grain sizes, although a lower degree of liberation was observed in fine-grained, massive samples. In addition, the critical metal distribution within zinnwaldite was examined using laser ablation inductively coupled plasma mass spectrometry (LA-ICP-MS) techniques. The results reveal differences in Li content between groundmass zinnwaldite and vein-hosted zinnwaldite and that the zinnwaldite contains the critical elements rubidium (Rb), cesium (Cs), and rare earth elements (REEs: La, Ce, Pr, and Nd). Vein-hosted zinnwaldite has a higher average Li content, whereas groundmass mica contains higher concentrations of Rb, Cs, and REEs. Both mica types host inclusions of bismuth–copper–thorium–arsenic (Bi-Cu-Th-As), which are more abundant in vein-hosted mica. In some of the samples, Bi, Cu, Th, and REEs also occur along the mica cleavage planes, as well as in mineral inclusions. The Li, Rb, and Cs grades are comparable to those of European deposits, such as Cínovec and the Zinnwald Lithium Project.

4 August 2025 in Minerals
Verified
Journal Article
Open access
PDF file
ASAlidor Shikika
Alidor Shikika
FZFrançois ZAGABE ZABENE
François ZAGABE ZABENE
MAMuvundja Fabrice Amisi
Muvundja Fabrice Amisi
MMMac Cubaka Mugumaoderha
Mac Cubaka Mugumaoderha
JCJulien L. Colaux
Julien L. Colaux
SGStoyan Gaydardzhiev
Stoyan Gaydardzhiev
The contact details of the author Alidor Shikika have been updated