The objective of this research was to synthesize fluorescent silver nanoclusters (NC Ag-BSA/PVP) using polyvinylpyrrolidone polymer (PVP) as a stabilizer in conjunction with bovine serum albumin protein (BSA). The nanoclusters were prepared using a wet chemistry reduction technique with two distinctive pathways: the addition of PVP after BSA and the addition of PVP after the metal precursor. The optical properties of the materials were studied in samples with different BSA/PVP molar ratios and varying amounts of metal/reductant. The impact of protein and polymer amounts on fluorescence was determined. The materials were characterized using X-ray diffraction (XRD), infrared spectroscopy (FTIR), thermogravimetric analysis (TGA), X-ray energy dispersive spectroscopy (EDS), dynamic light scattering (DLS), fluorescence spectroscopy, and UV-Vis-NIR spectroscopy. It was observed that increasing the BSA/PVP ratio resulted in higher fluorescence intensity at λ = 450 nm and a decrease at λ = 600 nm. Regarding the metal/reductant ratio, the amount of metal ions impacted the intensity obtained at λ = 600 nm. The experiments revealed that BSA had the largest effect on fluorescence intensity at λ = 450 nm, with little effect on fluorescence intensity regardless of the amount of polymer used. Due to its one-step synthesis and favorable reaction conditions, the NC Ag-BSA/PVP obtained under the proposed methodology holds promise as an optical marker material. The use of the stabilizing duo BSA-PVP, as well as the proposed amounts in this research, serves as a precedent for developing new experimental syntheses of colloidal nanoparticles.
Black titanium dioxide nanoparticles (bTiO2 NPs) have emerged as promising materials for light-driven applications due to their extended optical absorption and reduced environmental concerns compared with heavy-metal-based quantum dots. In this work, bTiO2 NPs were synthesized via a simple, low-cost, and environmentally friendly one-pot aqueous method. X-ray diffraction analysis confirmed the formation of the anatase TiO2 phase. Transmission electron microscopy (TEM) was used to determine the particle size finding a value of 10.3 ± 3.4 nm. The colloidal dispersion exhibited a positive zeta potential of +47.5 mV, indicating favorable electrostatic stabilization. Optical characterization revealed strong UV absorption at 280 nm, together with a pronounced NIR absorption band centered at approximately 804 nm, consistent with optical transitions associated with sub-band gap electronic states. The analysis of X-ray photoelectron spectroscopy (XPS) to the Ti 2p core-level confirmed the presence of 7.3% of Ti3+ species that can explain the NIR absorption. Photoluminescence analysis showed an emission band at 430–433 nm. Under 808 nm NIR irradiation, with an initial temperature of 37 °C, the bTiO2 NPs exhibited pronounced photothermal heating, reaching a maximum temperature increase of 30.2 °C and a photothermal conversion efficiency of 21.6%. The photothermal response increased with nanoparticle concentration under the evaluated experimental conditions, demonstrating concentration-dependent NIR photothermal heating. In vitro cytotoxicity assays showed high cell viability at the lower concentration tested, exceeding 100% at 50 µg/mL, whereas cell viability decreased to approximately 60% at 500 µg/mL. Overall, these results indicate that the synthesized bTiO2 NPs exhibit extended NIR absorption, concentration-dependent photothermal heating, and concentration-dependent effects on cell viability, supporting their potential for further investigation as photothermal nanomaterials.