Nektarios Kalyvas

Dr. Nektarios Kalyvas

University of West Attica, Athens, Attikí, Greece
orcid

Research Focus & Metrics

Academic Career Length

21Years (2006-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
11 May 2006 in EP Europace
Verified
Journal Article
Open access
PDF file
EEEfstathios P. Efstathopoulos
Efstathios P. Efstathopoulos
DKDemosthenes G. Katritsis
Demosthenes G. Katritsis
SKSofia Kottou
Sofia Kottou
NKNektarios Kalyvas
Nektarios Kalyvas
ETEfthalia Tzanalaridou
Efthalia Tzanalaridou
KFKeith Faulkner
Keith Faulkner
Aims To perform a comprehensive analysis of all aspects of patient and in-room personnel radiation dosimetry in interventional electrophysiology. Methods and results Measurements were performed during 19 diagnostic electrophysiology studies and 24 catheter ablations. Kerma-area product and exposure time values were 48.7 (6.4–230) Gy cm2 and 25.5 (4.4–79.2) min for ablation, and 12.5 (4.5–117.2) Gy cm2 and 4.5 (1.2–31) min for diagnostic studies, respectively. Patient effective doses were 15.2 (2.1–59.6) mSv for ablation and 3.2 (1.3–23.9) mSv for diagnostic procedures. Radiation risk to the patient was estimated to be up to eight cases of fatal cancer in 10 000 procedures. The risk of development of fatal cancer was less than 3×10−6 per procedure to the primary operator. The risk for the nurse and technician was much lower. The dose per procedure for the primary operator was 7.1 µGy at the eyes, 0.79 µGy at the chest under the lead apron, 13.68 µGy at the chest over the apron, 3.82 µGy at the thyroid, 17.76 µGy at the left hand, and 12.11 µGy at the left knee. Conclusion As far as radiation exposure is concerned, electrophysiology studies followed by radiofrequency ablation are safe procedures for both patient and personnel when performed in catheterization laboratories with modern equipment, experienced operators, and standard safety precautions.

30 December 2010 in IEEE Transactions on Nuclear Science
Verified
Journal Article
Closed access
Christos MichailChristos Michail
Christos Michail
VSVasiliki A. Spyropoulou
Vasiliki A. Spyropoulou
GFGeorge P. Fountos
George P. Fountos
NKNektarios Kalyvas
Nektarios Kalyvas
IVIoannis G. Valais
Ioannis G. Valais
GPGeorge S. Panayiotakis
George S. Panayiotakis
Fundamental imaging performance in terms of Modulation Transfer Function (MTF), Noise Power Spectrum (NPS) and Detective Quantum Efficiency (DQE) was investigated for a high resolution CMOS based imaging sensor. The device consists of a 33.91 mg/cm2 Gd2O2S:Tb scintillator screen, placed in direct contact with a CMOS photodiode array. The CMOS photodiode array, featuring 1200×1600 pixels with a pixel pitch of 22.5 μm, was used as an optical photon detector. In addition to the conventional frequency dependent parameters characterizing image quality, image information content was assessed through the application of information capacity (IC). The MTF was measured using the slanted-edge method to avoid aliasing while the Normalized NPS (NNPS) was determined by two-dimensional (2D) Fourier transforming of uniformly exposed images. Both measurements were performed under the representative radiation quality (RQA) settings, RQA-5 (70 kVp digital-radiography) and RQA-M2 (28 kVp digital-mammography) recommended by the International Electrotechnical Commission Reports 62220-1 and 62220-1-2 respectively. The DQE was assessed from the measured MTF, NPS and the direct entrance surface air-Kerma (ESAK) obtained from X-ray spectra measurement with a portable cadmium telluride (CdTe) detector. The ESAK values ranged between 11-87 μGy for RQA-5 and 6-40 μGy for RQA-M2. Additionally the output electrons per X-ray photon of the detector and its signal transfer characteristics were assessed via an analytical model, within the framework of the linear cascaded systems (LCS) theory. It was found that the detector response function was linear for the exposure ranges under investigation. Additionally our results showed that for the same RQA quality the output electrons per X-ray photon, as well as the measured and analytically predicted MTF, were not significantly affected by ESAK. MTF and DQE where found better compared to previously published data for other CCD and CMOS sensors, while the NNPS appeared to be comparable in the frequency range under investigation (0-10 cycles/mm).

1 November 2014 in Radiation Measurements
Verified
Journal Article
Closed access
Christos MichailChristos Michail
Christos Michail
IVI. Valais
I. Valais
ISI. Seferis
I. Seferis
NKNektarios Kalyvas
Nektarios Kalyvas
Stratos DavidStratos David
Stratos David
IKI. Kandarakis
I. Kandarakis

24 June 2010 in Medical Physics
Verified
Journal Article
Closed access
PDF file
Christos MichailChristos Michail
Christos Michail
GFG. P. Fountos
G. P. Fountos
PLP. F. Liaparinos
P. F. Liaparinos
NKNektarios Kalyvas
Nektarios Kalyvas
IVI. Valais
I. Valais
GPG. S. Panayiotakis
G. S. Panayiotakis

27 May 2020 in Crystals
Verified
Journal Article
Open access
PDF file
Christos MichailChristos Michail
Christos Michail
VKVaia Koukou
Vaia Koukou
NMNiki Martini
Niki Martini
GSGeorge Saatsakis
George Saatsakis
NKNektarios Kalyvas
Nektarios Kalyvas
Ioannis ValaisIoannis Valais
Ioannis Valais
Background: In this study, the light output of a cadmium tungstate (CdWO4) single crystal was measured under various X-ray radiographic energies. Methods: A CdWO4 single crystal (10 × 10 × 10 mm3) was exposed to X-rays in the 50–130 kVp range. Measurements were evaluated against published data for single crystals of equal dimensions (CaF2:Eu and Lu3Al5O12:Ce). Since the crystal was examined for application in medical imaging detectors, the emitted optical spectrum was classified with respect to the spectral compatibility of numerous commercial optical sensors. Results: The luminescence efficiency (LE) was found to constantly increase with X-ray energy and was higher than that of CaF2:Eu for energies above 90 kVp. However, the efficiency of the previously published Lu3Al5O12:Ce was found to be constantly higher than that of CdWO4. The light emitted from CdWO4 can be optimally detected by certain charge-coupled devices (CCDs), amorphous silicon photodiodes, and photocathodes. Conclusions: The high density (7.9 g/cm3) of CdWO4 and the luminescence signal of this material make it suitable for medical imaging (such as dual energy), high-energy physics or for applications of scintillators in harsh environments.

1 November 2016 in Radiation Measurements
Verified
Journal Article
Closed access
Christos MichailChristos Michail
Christos Michail
IVI. Valais
I. Valais
NMN. Martini
N. Martini
VKV. Koukou
V. Koukou
NKNektarios Kalyvas
Nektarios Kalyvas
GFG. Fountos
G. Fountos