In South Korea, Honam High-Speed Railway has a relatively large residual settlement issue and high fines content has been pointed out as one of the causes. Design guidelines regulate not to use soils containing fines content higher than 25%. However, there is no background information on the effect of fines content on settlement. Therefore, this paper aims to investigate compressional behavior according to fines content using sand and kaolinite. Oedometer test results showed that the compression index is lowest with fines content of 15% to 20% at which the mixture produced maximum density. The optimum fines content for inducing low settlement would be 15% to 20% for the sand–kaolinite mixture. Transition fines content (TFC), which shows sand-like to claylike behavior, was observed to have between 21% and 26% of fines content. Critical fines content (fcrit) where a minimum void ratio occurs was estimated as 21.67%. These behavioral changes appear when fines content is greater than the optimum fines content. SEM also shows that the kaolinite particles were overlapped, creating flat surfaces with a fines content higher than 30%, and showing clay-like behavior. Based on the analysis results, engineers can simply identify the behavior of embankment materials to ensure optimum fines content and consequently minimize long-term settlement potential.

In conventional design of soil-nailed slope, the nail parameters such as nail spacing (1–2 m), and nail inclination (10º–20º) have been recommended without considering any specific slope angle. Henceforth, this paper presents a numerical evaluation on the soil-nailed slope with flexible facing based on the finite element method in order to investigate the range of those two parameters with any size of nail head in various slope angles (45º, 55º, 65º, and 75º). Based on a minimum factor of safety (FS_min = 1.5), the analysis results indicated that the suggested range of those parameters in the conventional specification was applicable in the slope angle of 45º and 55º with any sizes of nail head. Nevertheless, it was not practical for slope angle of 65º and 75º, which required the size of nail head at least 400 × 400 × 250 mm, with nail spacing less than or equal to 1.5 m, and nail inclination from 5º to 10º.