The aim of this study is to determine the sorption-desorption behavior of a mixture of thirteen aqueous PAHs on cork waste at a particle of size 0.25–0.42 mm obtained from the remains of cork strips. The final purpose is to use this natural adsorbent as an alternative to activated carbon in an innovative approach for the removal of this class of toxic compounds, and significantly reduce the regeneration costs of the process. The chemical composition of the selected cork revealed that suberin (38.5 %) and lignin (31.6 %) were the main structural components of the cell wall. The high efficiency of cork as a biosorbent of PAHs is shown by the fact that just over 80 % of adsorption occurred during the first two minutes of contact time. Both Freundlich's and Langmuir's isotherms gave good fits to the sorption process. The highest adsorption affinities were exhibited for pyrene, anthracene, and phenanthrene. Desorption studies indicate a high degree of irreversibility for all PAHs, and especially so in the case of high molecular PAHs. The correlation with KF and low molecular weight PAHs was the most significant. The quantity of cork required to reduce water pollution was estimated to be between 3 and 15 times less than the quantities required in the case of other materials (i.e. aspen wood and leonardite). This study demonstrates for the first time that cork is a potential biosorbent for PAHs and may have relevance in the future treatment of PAH-contaminated waters.
5 November 2015 in Journal of Environmental Science and Health, Part A
The efficiency of cork waste in adsorbing aqueous polycyclic aromatic hydrocarbons (PAHs) has been previously reported. Biodegradation of contaminated cork using filamentous fungi could be a good alternative for detoxifying cork to facilitate its final processing. For this purpose, the degradation efficiency of anthracene by three ligninolytic white-rot fungi (Phanerochaete chrysosporium, Irpex lacteus and Pleurotus ostreatus) and three non-ligninolytic fungi which are found in the cork itself (Aspergillus niger, Penicillium simplicissimum and Mucor racemosus) are compared. Anthracene degradation by all fungi was examined in solid-phase cultures after 0, 16, 30 and 61 days. The degradation products of anthracene by P. simplicissimum and I. lacteus were also identified by GC-MS and a metabolic pathway was proposed for P. simplicissimum. Results show that all the fungi tested degraded anthracene. After 61 days of incubation, approximately 86%, 40%, and 38% of the initial concentration of anthracene (i.e., 100 µM) was degraded by P. simplicissimum, P. chrysosporium and I. lacteus, respectively. The rest of the fungi degraded anthracene to a lesser extent (<30%). As a final remark, the results obtained in this study indicate that P. simplicissimum, a non-ligninolytic fungi characteristic of cork itself, could be used as an efficient degrader of PAH-contaminated cork.
1 February 2019 in Science of The Total Environment
Reusing by-products is an important strategy to ensure the preservation of natural capital and climate change mitigation. This study aimed at evaluating the potential of cork granulates, a by-product of winery industry, as an organic carbon (OC) source for the treatment of hydroponic wastewaters. First, chemical characterization was performed and discussed. Secondly, batch studies were performed using synthetic hydroponic wastewater to understand the role of particle size (PS), pH and contact time (CT) on the release of OC. The suberin is the major compound, representing >50%. It was noticed that a variance on the content of suberin across species, within the same species and depending on the extraction part (belly, cork and back) could be expected. >60% of the sample is composed by carbon while <1% was nitrogen (high C:N ratio), indicating a low risk of releasing organic nitrogen. The statistical results suggested that the main effect of PS on the release of OC is greater than both, CT and pH. The chemical release of OC gets slower with time, being this effect greater as the PS increase. Moreover, estimations showed that using the 4 mm PS, the amount of water treated would be twice the amount if the 8 mm PS had been used. The PS seems to play an important role at design nature-based solutions (NBS) focused on denitrification. The surface response methodology indicates a significant negative interaction between CT and PS suggesting that the mathematical model could be used for further optimization studies. The reuse of organic by-products as filter media seems to be an economic and environmentally friendly alternative to enhance denitrification in NBS, while preserving natural capital. However, further real scale and long-term experiments are needed to validate cork's potential as an "internal" OC source for NBS.
Cork is a natural and renewable material extracted from the cork oak Quercus suber L. (1) Background: The cellular structure and chemical composition of the plant wall give cork its physical and mechanical properties. Chemically, the composition of cork is principally dominated by the presence of suberin as the main structural cell wall component and affected by its close association with other components. The usual chemical analysis of cork has been partially adapted from wood and other lignocellulosic analytical methods and it is a method with extensive procedures. This study aims to (i) find quicker and more sustainable methods for testing the cork chemical composition, (ii) conduct extraction tests using alternative techniques, (iii) optimize alternative methodologies, and (iv) validate the proposed sustainable methodologies. (2) Methods: Microwave-assisted extraction (MAE) and accelerated solvent extraction (ASE) are explored as alternative systems to the traditional method. The percentages of the extractives obtained via MAE are lower than the percentages obtained by means of the classical composition. (3) Results: However, the percentages of suberin are very similar in both methods: 46.39% in the case of the classical composition and 45.11% in the case of microwave-assisted extraction. No significant differences are observed between the content of the extractives in the dichloromethane, ethanol, and water obtained via ASE and the results obtained with the classical methodology. (4) Conclusions: MAE and ASE are faster methods; they use less solvents and provide more reproducible results than the classical chemical composition methodology. These data pave the way for novel sustainable alternatives relative to the studies of the chemical composition of cork.