This paper presents an analysis on using an on-board energy storage device (ESD) for enhancing braking energy re-use in electrified railway transportation. A simulation model was developed in the programming language C++ to help with the sizing of the ESD. The simulation model based on the mathematical description has been proposed for a train equipped with on-board ESD for analysis of effectiveness of its application. A case study was carried out for a metro line taking into consideration train characteristics, track alignment, line velocity limits and a running time table. This case study was used to assess the energy savings and perform a cost-benefit analysis for different sizes of the on-board ESD by applying the proposed approach. It was shown that when additional environmental benefits (reduction of CO2 emissions) are considered, this may significantly improve effectiveness of the investments due to CO2 European Emission allowances.
This paper investigates the benefits of using the on-board energy storage devices (OESD) and wayside energy storage devices (WESD) in light rail transportation (metro and tram) systems. The analysed benefits are the use of OESD and WESD as a source of supply in an emergency metro scenario to safely evacuate the passengers blocked in a metro train between stations; the use of OESD for catenary free sections, the benefits of using the WESD as an energy source for electrical car charging points and tram traction power supply; the benefits of using a central communication system between trams, cars, WESD and electrical car charging points. The authors investigated the use of: OESD with batteries for a catenary free section for different scenarios (full route or a catenary free section between two stations); the charge of OESD between stations (in parallel with tram motoring) to decrease the charging dwell time at stations and to help in achieving the operational timetable; the thermal effect of the additional load on the overhead contact system (OCS) when the tram is charging between stations; the sizing of OESD and WESD for emergency feeding in a metro system. The authors investigated the use of the WESD as a source of energy for the electrical car charging points to reduce the car pollution and carbon emissions. Presented in the paper is the enhanced multi train simulator with WESD prepared for the analyses conducted. The paper describes the DC electrical solver and WESD control method. A validation of the software has been conducted in regard to the substation voltage, WESD energy balance and WESD control.
This paper proposes a simulation model to calculate short-circuit fault currents in a DC light rail system with a wayside energy storage device. The simulation model was built in MATLAB/Simulink using the electrical information required to define a comprehensive DC traction power rail system. The short-circuit fault current results obtained from the simulation model were compared with hand calculation results obtained using EN 50123-1 guidance. The relative error was 1.02%, which validates the model. A case study was carried out for a 1500 V DC light rail system. In the case study, a method was proposed to assess the DC protection and the withstand and breaking capacity of the DC circuit breakers for maximum current and distant faults. A traction power modeling simulation was conducted for the 1500 V DC light rail system to calculate the maximum load current in the analyzed electrical sections. It is concluded that the proposed simulation model and fault methodology can be used for DC protection settings calculations and DC circuit breaker rating analysis.
This paper presents the design and simulation of an non isolated DC-DC Cuk converter. The input current control is provided with pulse-width modulation (PWM). A closed control loop is used with two proportional-integral (PI) controllers for the current and voltage. The DC-DC Cuk converter is used with Simulink cells for battery and supercapacitors (SC) to simulate the charging and discharging process for a stationary energy storage device (ESD). Simulations results are presented in Simulink.