Qiangren Xu

Dr. Qiangren Xu

orcid
Department of Electrical and Electronic Engineering, The Hon...

Research Focus & Metrics

Academic Career Length

5Years (2022-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
23 October 2023 in IEEE Journal of Emerging and Selected Topics in Power Electronics
Verified
Journal Article
Closed access
Qiangren XuQiangren Xu
Qiangren Xu
Shuhua FangShuhua Fang
Shuhua Fang
PWPeng Wan
Peng Wan
YWYicheng Wang
Yicheng Wang
DHDemin Huang
Demin Huang
The operation of permanent magnet synchronous motors is subject to many disturbances due to structural characteristics and operating situations. Particularly at low speeds, periodic disturbances, for instance, offset current error, cogging torque, etc., have a greater impact on the stable operation of the motor. For periodic disturbances, the conventional disturbance observer suffers from high delay and static error. Even though the observer bandwidth can be increased to enhance the tracking ability to perturbations, this will introduce high frequency noise at the same time. To solve these problems, an improved linear active disturbance rejection controller in this paper is designed. By adding an error proportional feedback term to the extended state observer, the capability of system to observe load perturbations is tremendously enhanced. A high-pass filter is employed at the state error feedback as a speed compensator. This method can reduce the speed ripples feasibly without complex structures and tedious calculations. The stability of the proposed method is demonstrated by theoretical analysis, and both simulation and experimental results are given to verify the effectiveness of the proposed method.

29 May 2024 in IEEE Transactions on Power Electronics
Verified
Journal Article
Closed access
Qiangren XuQiangren Xu
Qiangren Xu
Shuhua FangShuhua Fang
Shuhua Fang
The article proposes an improved robust control scheme for deadbeat predictive current sensorless control. Sensitivity analysis of the current prediction model and position estimation parameters are carried out, and the corresponding robust control scheme is designed. An enhanced supertwisting algorithm sliding-mode observer with smaller jitter and faster response speed is employed to observe back electromotive forces (back EMFs), inductance and flux linkage simultaneously. Consequently, the adverse effects of parameter mismatch on both the back EMFs observer and current prediction are attenuated with only one observer. The proposed strategy exhibits excellent performance under both steady state and dynamic conditions. Experimental results verify the superiority and effectiveness of the proposed strategy.

13 May 2025 in Applied Sciences
Verified
Journal Article
Open access
PDF file
GWGang Wang
Gang Wang
Shuhua FangShuhua Fang
Shuhua Fang
Qiangren XuQiangren Xu
Qiangren Xu
This article proposes an innovative joint vibration suppression method for six-axis collaborative robots. A permanent magnet synchronous motor (PMSM) and harmonic reducer are considered as a whole system in the design. A novel active disturbance rejection control (ADRC) scheme has been implemented by applying vibration suppression measures to the low-speed end of joint reducers. The mechanism of vibration generated by robot joints was analyzed. A vibration model for harmonic reducers was built. A new extended state observer model was designed to analyze the position disturbance data of two encoders in robot joints. Vibration signals were extracted and input into the ADRC algorithm to suppress joint vibration. A six-axis robot experimental platform was built and used to explore the changes in robot vibration trajectories under different speed conditions by applying the ADRC algorithm. The experimental results clearly show that the fluctuation amplitude of the trajectory of the robot has been reduced. The experimental results clearly show that by applying the new vibration suppression algorithm, the amplitude, vibration velocity, and acceleration of the robot at low speed have decreased 0.533 mm, 10.12 mm/s, and 0.49 mm/s2, respectively, and at the same time, the velocity stability of the PMSM has been improved. This article accurately evaluates the vibration suppression performance of the ADRC algorithm at different speeds of robots, effectively suppressing the vibration of robot joints.

29 November 2024 in IEEE Journal of Emerging and Selected Topics in Power Electronics
Verified
Journal Article
Closed access
DHDemin Huang
Demin Huang
Shuhua FangShuhua Fang
Shuhua Fang
Qiangren XuQiangren Xu
Qiangren Xu
This paper introduces a method focused on enhancing the position tracking performance of permanent magnet arc motors (PMAM) through the implementation of an iterative learning super twisting observer and super twisting control. The primary control objective is to achieve precise and reliable position tracking. The torque ripples caused by the structure and drive system of PMAM are the main reasons for the position tracking error. To overcome the drawbacks of conventional sliding mode control and the iterative learning (IL) strategy, which cannot maintain good performance when the speed changes, the proposed method uses position domain IL strategy to estimate the periodic component in torque ripples and super twisting algorithm to estimate the left nonperiodic components. Finally, the estimated lumped disturbances are fed forward to the super twisting controller to improve the disturbance rejection ability. The stability of proposed method is proved via Lyapunov function. The effectiveness of the proposed method is validated by simulation and experimental results.

14 August 2025 in IEEE Transactions on Industrial Electronics
Verified
Journal Article
Closed access
YMYao Meng
Yao Meng
XYXinyu Yang
Xinyu Yang
HCHong Chen
Hong Chen
Shuhua FangShuhua Fang
Shuhua Fang
Qiangren XuQiangren Xu
Qiangren Xu
This article proposes a new hybrid-excited flux switching machine with dual-set of PMs (HE-FSDPMM), which features employing PMs on both teeth and yoke of stator to produce parallel dual-PM flux to enhance the torque capability. Besides, the HE-FSDPMM equipped with field windings can produce another parallel dc flux for flux weakening. The topology and operation principle of HE-FSDPMM are described. The design considerations of HE-FSDPMM, including multiobjective optimization, slot/pole combination selection, and critical parameter effect analysis, are investigated. Then, the electromagnetic performances of HE-FSDPMM under different excitation states are analyzed, and a comprehensive performance comparison with two existing HE-FSPMMs is developed to evaluate the advantages of HE-FSDPMM. The results show that compared with the existing HE-FSPMMs, the proposed HE-FSDPMM accommodates higher torque density, higher PM utilization, higher power factor, and better flux weakening capability. Finally, a prototype of HE-FSDPMM is manufactured and an experimental validation is performed.

20 May 2025 in IEEE Journal of Emerging and Selected Topics in Power Electronics
Verified
Journal Article
Closed access
BRBingdan Ren
Bingdan Ren
Shuhua FangShuhua Fang
Shuhua Fang
ZSZhenyu Song
Zhenyu Song
Qiangren XuQiangren Xu
Qiangren Xu
JWJiyao Wang
Jiyao Wang
YMYao Meng
Yao Meng
The Permanent Magnet Arc Motor (PMAM) is widely applied in large direct-drive systems due to its high efficiency and high-power density. However, during low-speed operation, the motor is not only disturbed by the cogging torque, end torque, and flux linkage harmonics of the motor itself, but also susceptible to external disturbances and high-frequency components in the control signals. To address this issue, this article proposes a sliding mode control method that combines an integral sliding mode surface with a low-pass term and adopts an adaptive reaching law. This method effectively reduces the chattering phenomenon in sliding mode control and enhances the ability to suppress medium and high-frequency components of the system. Additionally, the integration of an extended state observer for disturbance estimation and compensation further improves the robustness of the system The stability of the proposed algorithm is confirmed through discretization analysis, and experimental results validate the effectiveness of the method.