Inadequately treated or untreated wastewater greatly contribute to the release of unwanted toxic contaminants into water bodies. Some of these contaminants are persistent and bioaccumulative, becoming a great concern as they are released into the environment. Despite the abundance of wastewater treatment technologies, the adsorption method overall has proven to be an excellent way to treat wastewater from multiple industry sources. Because of its significant benefits, i.e., easy availability, handling, and higher efficiency with a low cost relative to other treatments, adsorption is opted as the best method to be used. However, biosorption using naturally found seaweeds has been proven to have promising results in removing pollutants, such as dyes from textile, paper, and the printing industry, nitrogen, and phosphorous and phenolic compounds, as well as heavy metals from various sources. Due to its ecofriendly nature together with the availability and inexpensiveness of raw materials, biosorption via seaweed has become an alternative to the existing technologies in removing these pollutants from wastewater effectively. In this article, the use of low-cost adsorbent (seaweed) for the removal of pollutants from wastewater has been reviewed. An extensive table summarises the applicability of seaweed in treating wastewater. Literature reported that the majority of research used simulated wastewater and minor attention has been given to biosorption using seaweed in the treatment of real wastewater.
1 November 2021 in Environmental Technology & Innovation
Ocean thermal energy conversion (OTEC) is a solution for environmental and climate change issues in the tropics. The OTEC potential in Malaysia using ocean conditions and bathymetry data has been previously studied and demonstrated. Following this, it is vital to perform a basic performance analysis of a 10 MW Rankine Cycle OTEC plant using the Malaysian ocean conditions. In this paper, the results of heat and mass balance will be reported for a 10 MW Rankine cycle OTEC plant which uses heat exchangers of plate-type and anhydrous ammonia as its working fluid. The value of a minimum objective function (γ) is derived by total heat surface area (AT) divided by the net power (PN). γ decreases when the inlet temperature difference (inlet temperature of warm seawater (TWSWI)—inlet temperature of cold seawater (TCSWI)) increases. PN is clarified to be approximately 70–80% of the PG (gross power) using Malaysian ocean conditions.
The Malaysian Government has set a target of achieving 20% penetration of Renewable Energy (RE) in the energy mix spectrum by 2025. In order to get closer to the target, Ocean Thermal Energy Conversion (OTEC) aligned with solar PV, biogas and biomass energy sources must be evaluated and comprehended. Hybrid OTEC systems consisting of energy and water production are currently under research and validation. Therefore, for the construction of a commercial OTEC plant, 1 MW or 2.5 MW, the choice of a strategic location or potential site is vital. In this paper, oceanographic data such as seawater temperature, depth, salinity and dissolved oxygen obtained from the Japan Oceanographic Data Center (JODC) for Semporna, Tawau, Kudat, Pulau Layang-Layang and Pulau Kalumpang in Sabah, Malaysia, are reported. The RE available from the Exclusive Economic Zone (EEZ) on the coast of Sabah was estimated based on the JODC data obtained. There were no remarkable differences in temperatures between the five sites, which were reported as approximately 27 °C at the surface and 7 °C at depths below 600 m. The surface salinities below 100 m at those sites were slightly lower than the deeper waters, where the salinity increased up to approximately 34.5 PSU. Dissolved oxygen data from the Pulau Kalumpang site showed a slight increment to approximately 4.7 mL/L at depth intervals below 50 m, before declining steadily to approximately 1.7 mL/L along with the depth. The temperature-salinity profiles of the Malaysian sites were congruent with those of Palau, Kumejima and Okinawa, but not with that of Fiji, where the salinity profile showed a distinct variation at the relative depth (below 200 m). Estimates of RE using two different methods were used to prove the potential of OTEC in Malaysia.
8 February 2024 in Journal of Marine Science and Technology
Ocean thermal energy conversion (OTEC) is a heat engine application that utilizes the Rankine cycle to extract energy from the thermal gradient between surface seawater and deep seawater. Hybrid cycle OTEC (H-OTEC) is a combination of an open cycle desalination system and a closed-cycle power generation system that leverages the features of both cycles. Unlike other desalination technologies that require extensive energy to operate, H-OTEC relies entirely on renewable energy. In addition, a desalination plant can be coupled with the H-OTEC system (H-OTEC + D) to improve its performance. Conventionally, the total heat transfer area of heat exchangers per net power is used as an objective function to achieve optimal performance with the lowest capital expenditure cost. The proposed objective function, unlike the conventional one, considers both power and water. In this study, the optimization of H-OTEC + D and H-OTEC is carried out by minimizing the proposed objective function, considering several independent variables. The performance of both systems is evaluated in terms of the objective function, power consumption, seawater flow rates, and desalination ratio. The findings also indicate the effectiveness of the proposed objective function over the conventional one as an effective tool for maximizing power and desalinated water generation.
10 May 2025 in International Journal of Hydrogen Energy