Hydroxyapatite (HAp) and hydroxyapatite/multi-walled carbon nanotube (MWCNT) composites were obtained by the co-precipitation method, followed by ultrasound-assisted and microwave radiation and thermal treatment at 250 °C. X-ray diffraction (XRD) confirmed the presence of a hexagonal phase in all the samples, while Fourier-transform infrared (FTIR) spectroscopy elucidated the interaction between HAp and MWCNTs. The photoluminescent technique revealed that HAp and the composite with non-functionalized MWCNTs present a blue luminescence, while the composite with functionalized MWCNTs, under UV-vis radiation shows an intense white emission. These findings allowed presentation of a proposal for the use of HAp and HAp with functionalized MWCNTs as potential materials for optoelectronic and medical applications.
In this research, changes in several characteristics of partially reduced titania were studied. The reduction process used made it possible to gradually observe changes in the material depending on the amount of reducing agent used. We used NaBH4 to impregnate commercial TiO2 with isopropyl alcohol. Impregnated TiO2 nanoparticles were dried and thermally treated in a nitrogen flow to obtain blue titania samples. Thorough spectroscopic characterization showed that oxygen atoms from hydroxyl groups, as well as from the surface, and the lattice of TiO2 was consumed. This caused changes in the surface and even in the bulk of TiO2 when the amount of reducing agent used was increased. Structural, optical, superficial, and textural characteristics were studied using XRD, Raman, DRS UV-Vis-NIR, Mid-DRIFT, XPS, and nitrogen adsorption/desorption isotherms. A photocatalytic test of the degradation of methylene blue dye was performed. Among different effects on the mentioned characteristics, we found evidence of changes in the surface properties of the blue titania samples and their probable effect on the photocatalytic properties. The reduction process implied a preponderant decrease in the surface hydrophilicity of the reduced samples, an effect shown for the first time in this type of material.
MnxZn1-xFe2O4 (x = 0–1) solid solution was prepared using the TREG-mediated solvothermal method. 10–12 nm spherical superparamagnetic particles (except for ZnFe2O4) were obtained. At room temperature, the ferrites have lower magnetic saturation (Ms) than magnetite. However, at 10 K, it is precisely the opposite. DRX and EXAFS showed that incorporating Zn2+ ions in tetrahedral A-sites provokes a redistribution of Mn and Fe ions in octahedral B-sites of the mixed spinel structure. For Zn concentrations from x = 0.5 and below, the Mn and Fe ions are almost equally distributed between A and B-sites. Therefore, at low Zn concentrations, the small migration of Fe and Mn ions to B-sites increases the magnetic moment of B sub-lattices and, consequently, the total magnetic saturation. In addition, Mn2+ oxidized to Mn3+ and, simultaneously, Fe3+ reduced to Fe2+, affecting the magnetic properties. The increment of Zn concentration severely reduces the magnetization.
Zinc-doped hydroxyapatite (Zn-HAp) was used as photocatalyst for degrading Bisphenol A (BPA) in aqueous solution. Zn-HAp was synthesized by co-precipitation method, and its properties were analyzed by X-ray Diffraction (XRD), Energy Dispersive Spectroscopy (EDS), Attenuated Total Reflectance Fourier Transform Infrared Spectroscopy (ATR-FTIR), Nitrogen Adsorption–Desorption Isotherms, and Diffuse Reflectance Spectroscopy (DRS). During analysis, the Zn-HAp material showed an increase in light absorption in the region from 240-400 nm and in photocatalytic activity on the process of BPA degradation under UVA radiation (λ = 350 nm). After 240 min of irradiation, the material degraded 82% of the contaminant, showing that Zn-HAp can be used as an UVA light photocatalyst for the removal of BPA. Therefore, Zn-HAp is a promising photocatalyst in water technology.
16 July 2025 in Journal of Physics and Chemistry of Solids