This review is focused on the biosensing assay based on AuNPs (AuNPs) modified by proteins, peptides and nucleic acid aptamers. The unique physical properties of AuNPs allow their modification by proteins, peptides or nucleic acid aptamers by chemisorption as well as other methods including physical adsorption and covalent immobilization using carbodiimide chemistry or based on strong binding of biotinylated receptors on neutravidin, streptavidin or avidin. The methods of AuNPs preparation, their chemical modification and application in several biosensing assays are presented with focus on application of nucleic acid aptamers for colorimetry assay for determination of antibiotics and bacteria in food samples.
The determination of protease activity is very important for disease diagnosis, drug development, and quality and safety assurance for dairy products. Therefore, the development of low-cost and sensitive methods for assessing protease activity is crucial. We report two approaches for monitoring protease activity: in a volume and at surface, via colorimetric and acoustic wave-based biosensors operated in the thickness-shear mode (TSM), respectively. The TSM sensor was based on a β-casein substrate immobilized on a piezoelectric quartz crystal transducer. After an enzymatic reaction with trypsin, it cleaved the surface-bound β-casein, which increased the resonant frequency of the crystal. The limit of detection (LOD) was 0.48 ± 0.08 nM. A label-free colorimetric assay for trypsin detection has also been performed using β-casein and 6-mercaptohexanol (MCH) functionalized gold nanoparticles (AuNPs/MCH-β-casein). Due to the trypsin cleavage of β-casein, the gold nanoparticles lost shelter, and MCH increased the attractive force between the modified AuNPs. Consequently, AuNPs aggregated, and the red shift of the absorption spectra was observed. Spectrophotometric assay enabled an LOD of 0.42 ± 0.03 nM. The Michaelis–Menten constant, KM, for reverse enzyme reaction has also been estimated by both methods. This value for the colorimetric assay (0.56 ± 0.10 nM) is lower in comparison with those for the TSM sensor (0.92 ± 0.44 nM). This is likely due to the better access of the trypsin to the β-casein substrate at the surface of AuNPs in comparison with those at the TSM transducer.
The determination of protease activity is very important for disease diagnosis, drug development, and quality and safety assurance for dairy products. Therefore, the development of low-cost methods for assessing protease activity is critical. Here, we demonstrate that an acoustic wave-based biosensor operated in the thickness-shear mode (TSM) enables the low-cost detection of protease activity in real time. The TSM sensor was based on a protein substrate (PS) β-casein immobilized on a piezoelectric quartz crystal electrode. The β-casein layer was immobilized onto a gold surface by a carboxylate terminated self-assembled monolayer (SAM) of 11-mercaptoundecanoic acid (MUA). The carboxylic acid terminal was activated by the reaction of a mixture of water- soluble N-(3-Dimethylaminopropyl)-N0-ethylcarbodiimide (EDC) and N–Hydroxysuccinimide (NHS) on the electrode surfaces. We demonstrated that β-casein can form a stable assembly on a piezoelectric quartz crystal electrode. After an enzymatic reaction with trypsin, it cleaved the surface-bound β-casein substrate, which increased the frequency of the crystal in a sigmoidal manner. Trypsin was detected in the range of concentrations from 1 to 50 nM. The limit of detection was 0.2 nM. Initial reaction rates measured at different enzyme concentrations have been used to construct a calibration curve. Considering the results obtained, we believe that the TSM biosensor is a useful tool for protease analysis.