In the field of food packaging, the addition of exfoliated layered silicates in polymers has been established to improve the polymers’ gas barrier properties. Using these polymers as coatings to protect smart textiles from oxidation and corrosion while maintaining their textile properties should significantly extend their lifetime and promote their market penetration. The aim of this study was to print new polymer dispersions containing layered silicates to protect screen-printed conductive structures, and to test the resulting samples. For this, appropriate printing parameters were determined by statistical design of experiments. According to these results, conductive structures were printed and protected with the selected coating. The abrasion resistance and the continuity of the protective layer of the printed samples were then measured. A continuous protective coating of approximately 70–80 µm thickness was applied on a conductive structure. The printed samples showed a very high resistance to abrasion (unchanged by 85,000 abrasion cycles) while remaining flexible and presenting a lower water vapor permeability (<2.5 g/m² d) than the coatings commonly used in the textile field.
The urban logistic sector is struggling with the following two problems: a particularly high level of traffic and air pollution. For those reasons, small electric vehicles are the perfect technical solution to cope sustainably with the increasing parcel volume in urban areas. To compensate the weight disadvantage of electric drive, a textile lightweight solution for the body of logistics vehicles is examined in this study. Therefore, various textiles and mounting solutions are examined and developed, as well as tested by multiple testing procedures. The result of this work is an ideal combination of a textile and suitable mounting method for a textile lightweight body for last—mile logistic vehicles.